Search NASA⌕ Search

Engineering topics

Cianciosa, M.

Publications and source records attributed to Cianciosa, M..

FES 2023 Theory & Simulation Performance Target

The Report for the 2023 Theory & Simulation Performance Target (TSPT) is presented herein. The 1st, 2nd and 3rd Quarter Reports are given in Sec. I, Sec. II and Sec. III. These are unchanged from those previously submitted, except that in this final document the equations, figures and citations have been automatically renumbered. The 4th Quarter Report is given in Sec. IV. The following material presents verification calculations of several widely used three-dimensional (3D) magnetohydrodynamic (MHD) equilibrium codes in strongly shaped configurations; for both fixed and free-boundary equilibria; for the so-called vacuum case and for the case of high plasma pressure; and, for magnetic fields that have nested magnetic surfaces and for fields that have a magnetic island. The configurations studied includes the recently discovered “precise-QA” case [Phys. Rev. Lett., 128, 035001 (2002)] and other highly optimized configurations. Because of the strong (extreme) shaping, the latter of these pose challenges to the 3D MHD codes. A new method is introduced for constructing coordinates in arbitrarily shaped toroidal domains, and this can improve the robustness of 3D equilibrium calculations. Beyond the equilibrium calculation, this report demonstrates the capability of performing non-linear extended-MHD modelling of optimized stellarator equilibria. This capability allows the assessment not only of linear stability thresholds but also of the nonlinear evolution of unstable equilibria to new configurations that might be far from the original configuration, with significantly different transport properties and magnetic topology. They also enable the self-consistent determination of pressure profiles in non-integrable magnetic topology through the use of highly anisotropic thermal-transport equations. The calculations presented here represent the first demonstration of extended-MHD calculations in strongly-shaped, optimized quasi-symmetric configurations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Demonstration of reduced neoclassical energy transport in Wendelstein 7-X

Research on magnetic confinement of high-temperature plasmas has the ultimate goal of harnessing nuclear fusion for the production of electricity. Although the tokamak is the leading toroidal magnetic-confinement concept, it is not without shortcomings and the fusion community has therefore also pursued alternative concepts such as the stellarator. Unlike axisymmetric tokamaks, stellarators possess a three-dimensional (3D) magnetic field geometry. The availability of this additional dimension opens up an extensive configuration space for computational optimization of both the field geometry itself and the current-carrying coils that produce it. Such an optimization was undertaken in designing Wendelstein 7-X (W7-X), a large helical-axis advanced stellarator (HELIAS), which began operation in 2015 at Greifswald, Germany. A major drawback of 3D magnetic field geometry, however, is that it introduces a strong temperature dependence into the stellarator’s non-turbulent ‘neoclassical’ energy transport. Indeed, such energy losses will become prohibitive in high-temperature reactor plasmas unless a strong reduction of the geometrical factor associated with this transport can be achieved; such a reduction was therefore a principal goal of the design of W7-X. In spite of the modest heating power currently available, W7-X has already been able to achieve high-temperature plasma conditions during its 2017 and 2018 experimental campaigns, producing record values of the fusion triple product for such stellarator plasmas. The triple product of plasma density, ion temperature and energy confinement time is used in fusion research as a figure of merit, as it must attain a certain threshold value before net-energy-producing operation of a reactor becomes possible. Here we demonstrate that such record values provide evidence for reduced neoclassical energy transport in W7-X, as the plasma profiles that produced these results could not have been obtained in stellarators lacking a comparably high level of neoclassical optimization.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Overview of first Wendelstein 7-X high-performance operation

The optimized superconducting stellarator device Wendelstein 7-X (with major radius R = 5.5 m, minor radius $a$ = 0.5 m, and 30 m 3 plasma volume) restarted operation after the assembly of a graphite heat shield and 10 inertially cooled island divertor modules. This paper reports on the results from the first high-performance plasma operation. Glow discharge conditioning and ECRH conditioning discharges in helium turned out to be important for density and edge radiation control. Plasma densities of 1–4.5 × 10 19 m –3 with central electron temperatures 5–10 keV were routinely achieved with hydrogen gas fueling, frequently terminated by a radiative collapse. In a first stage, plasma densities up to 1.4 × 10 20 m –3 were reached with hydrogen pellet injection and helium gas fueling. Here, the ions are indirectly heated, and at a central density of 8 · 10 19 m –3 a temperature of 3.4 keV with $T_e/T_i$ = 1 was transiently accomplished, which corresponds to $nT_i(0)τ_E =$ 6.4 × 10 19 keV s m –3 with a peak diamagnetic energy of 1.1 MJ and volume-averaged normalized plasma pressure $\langleβ\rangle$ = 1.2%. The routine access to high plasma densities was opened with boronization of the first wall. After boronization, the oxygen impurity content was reduced by a factor of 10, the carbon impurity content by a factor of 5. The reduced (edge) plasma radiation level gives routinely access to higher densities without radiation collapse, e.g. well above 1 × 10 20 m –2 line integrated density and $T_e = T_i =$ 2 keV central temperatures at moderate ECRH power. Both X2 and O2 mode ECRH schemes were successfully applied. Core turbulence was measured with a phase contrast imaging diagnostic and suppression of turbulence during pellet injection was observed.

impurities↗

Major results from the first plasma campaign of the Wendelstein 7-X stellarator

Here, after completing the main construction phase of Wendelstein 7-X (W7-X) and successfully commissioning the device, first plasma operation started at the end of 2015. Integral commissioning of plasma start-up and operation using electron cyclotron resonance heating (ECRH) and an extensive set of plasma diagnostics have been completed, allowing initial physics studies during the first operational campaign. Both in helium and hydrogen, plasma breakdown was easily achieved. Gaining experience with plasma vessel conditioning, discharge lengths could be extended gradually. Eventually, discharges lasted up to 6 s, reaching an injected energy of 4 MJ, which is twice the limit originally agreed for the limiter configuration employed during the first operational campaign. At power levels of 4 MW central electron densities reached 3 × 10 19 m –3 , central electron temperatures reached values of 7 keV and ion temperatures reached just above 2 keV. Important physics studies during this first operational phase include a first assessment of power balance and energy confinement, ECRH power deposition experiments, 2nd harmonic O-mode ECRH using multi-pass absorption, and current drive experiments using electron cyclotron current drive. As in many plasma discharges the electron temperature exceeds the ion temperature significantly, these plasmas are governed by core electron root confinement showing a strong positive electric field in the plasma centre.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Role of a continuous MHD dynamo in the formation of 3D equilibria in fusion plasmas

Stationary 3D equilibria can form in fusion plasmas via saturation of magnetohydrodynamic (MHD) instabilities or stimulated by external 3D fields. In these cases the current profile is anomalously broad due to magnetic flux pumping produced by the MHD modes. Flux pumping plays an important role in hybrid tokamak plasmas, maintaining the minimum safety factor above unity and thus removing sawteeth. It also enables steady-state hybrid operation, by redistributing non-inductive current driven near the center by electron cyclotron waves. A validated flux pumping model is not yet available, but it would be necessary to extrapolate hybrid operation to future devices. In this work flux pumping physics is investigated for helical core equilibria stimulated by external 3D fields in DIII-D hybrid plasmas. We show that flux pumping can be produced in a continuous way by an MHD dynamo emf. The same effect maintains helical equilibria in reversed-field pinch (RFP) plasmas. The effective MHD dynamo loop voltage is calculated for experimental 3D equilibrium reconstructions, by balancing Ohm’s law over helical flux surfaces, and is consistent with the expected current redistribution. Similar results are also obtained with more sophisticated nonlinear MHD simulations. The same modelling approach is applied to helical RFP states forming spontaneously in RFX-mod as the plasma current is raised above 0.8–1 MA. This comparison allows to identify the underlying physics common to tokamak and RFP: a helical core displacement modulates parallel current density along flux tubes, which requires a helical electrostatic potential to build up, giving rise to a helical MHD dynamo flow.

3D equilibrium reconstruction↗

Overview of results from the MST reversed field pinch experiment

An overview of recent results from the MST reversed field pinch programme is presented here. With neutral beam injection, bursty energetic particle (EP) modes are observed. The profiles of the magnetic and density fluctuations associated with these EP modes are measured using a far infrared interferometer–polarimeter. Equilibrium reconstructions of the quasi-single-helicity 3D helical state are provided by the V3FIT code that now incorporates several of MST's advanced diagnostics. The orientation of the helical structure is controlled using a new resonant magnetic perturbation technique. Gyrokinetic simulations based on experimental equilibria predict unstable trapped-electron modes (TEMs), and small-scale density fluctuations are detected in improved-confinement plasmas with TEM-like features. Upgraded pellet injection permits study of density and beta limits over MST's full range of operation, and an MST-record line-average density of 0.9 × 1020 m3 (n/nG = 1.4) has been obtained. Impurity ion temperature measurements reveal a charge-to-mass-ratio dependence in the rapid heating that occurs during a sawtooth crash. Runaway of NBI-born fast ions during the impulsive sawtooth event agrees with test-particle theory. Magnetic self-organization studies include measurements of the dynamo emf with an applied ac inductive electric field using oscillating field current drive.

beta limit↗

Non-axisymmetric equilibrium reconstruction for stellarators, reversed field pinches and tokamaks

Axisymmetric equilibrium reconstruction using magnetohydrodynamic equilibrium solutions to the Grad Shafranov equation has long been an important tool for interpreting tokamak experiments. This paper describes recent results in non-axisymmetric (three-dimensional) equilibrium reconstruction of nominally axisymmetric plasmas (tokamaks and reversed field pinches (RFPs)), and fully non-axisymmetric plasmas (stellarators). Results from applying the V3FIT code to CTH and HSX stellarator plasmas, RFX-mod RFP plasmas and the DIII-D tokamak are presented.

Hanson, James D.↗