Engineering topics
Publications and source records attributed to Cirlin, E. H..
Results are presented from an extensive series of new high resolution scanning electron microscope studies of the very primative group of meteorites known as unequilibrated chondrites. These include quantitative analyses of micrometer sized phases and interpretation in terms of relevant phase equilibria. Several new meteorite minerals including high chromium metal, have been discovered.
Watson and Haff (1980) have discussed a theory which is designed to explain quantitatively isotopic fractionation effects observed during sputtering of simple or complex targets. This theory is based on the assumption that most of the atoms sputtered from a surface originate in the top monolayer. The present investigation is mainly concerned with a direct experimental test of that assumption. The sputtering of both solid and liquid phases of gallium, indium, and the gallium-indium eutectic alloy is studied. Results obtained with the aid of ion scattering and Auger spectroscopy show that, in agreement with rough theoretical expectations, the surface monolayer of a gallium-indium alloy with 16.5 percent indium in bulk contains more than 94 percent indium, while the next layer can be only slightly enriched.
Recent SEM observations of the Allende chondrules and matrix are reported. Intergrowths of both Fe-rich olivine (with a composition near Fa50), and clinoenstatite (with a composition of about Fs2). All of the clinoenstatite was involved in associations along the outer margins, grain boundaries, and internal crack surfaces of the chondrule. Most of the chondrules also contain abundant opaque inclusions which must have been strongly altered and partially replaced before chondrule formation. It is suggested that the Fe-rich olivine formed from the clinoenstatite by a reaction of the type Fe + 1/202 + MgSiO3 to (Fe,Mg)2SiO4. It is argued that a variation of the small, internally-heated planetesimal provides the most plausible environment for the chemical reaction.
The concentration of surface (low temperature site) and interior (high temperature site) Cd, Zn, and Pb in 13 Apollo 16 highland fines samples, pristine rock 65325, and mare fines sample 75081 were analyzed directly from the thermal release profiles obtained by flameless atomic absorption technique (FLAA). Cd and Zn in pristine ferroan anothosite 65325, anorthositic grains of the most mature fines 65701, and basaltic rock fragments of mare fines 75081 were almost all surface Cd and Zn indicating that most volatiles were deposited on the surfaces of vugs, vesicles and microcracks during the initial cooling process. A considerable amount of interior Cd and Zn was observed in agglutinates. This result suggests that high temperature site interior volatiles originate from entrapment during the lunar maturation processes. Interior Cd found in the most mature fines sample 65701 was only about 15% of the total Cd in the sample. Interior Pb present in Apollo 16 fines samples went up to 60%. From our Cd studies we can assume that this interior Pb in highland fines samples is largely due to the radiogenic decay which occurred after the redistribution of the volatiles took place. We obtained an average age of 4.0 b.y. for the parent rocks of Apollo 16 highland regolith from our interior Pb analyses.
Thermal release profiles of Pb, Zn, and Cd in sample 66095 (highly shocked breccia with melt rock matrix) showed that these volatiles were mostly present on the surface of the grains. Zn in rusty grains from 66095 was also mostly surface Zn, probably from sphalerite in grain boundaries and cracks. Simulation experiments of volatile transfer showed that Fe, FeCl2, iron phosphide, and troilite (FeS) can be produced and transported during subsolidus reactions. These results suggest that volatiles, rust, schreibersite, and possible siderophiles which are observed in lunar highland samples might have been redistributed during disequilibrium thermal metamorphism in hot ejecta blankets, and were not necessarily introduced by volcanic activity or meteoritic addition.
Quantitative ferromagnetic resonance (FMR) measurements at 9.5 and 35 GHz were made on lunar fines in order to determine the amount of single domain FE(0) and to ascertain the effect of sample quantity on the results of these experiments. Samples containing more than 10 micrograms of Fe(0) in an X-band TE(104) cavity, or more than 0.11 micrograms in a Ka-band cavity can cause errors greater than 1% in the quantitative determination of Fe(0), as well as cause anomalous broadening of the FMR line. Theoretical calculations were derived to show this effect which results from a nonlinear response of the FMR experiment with the sample quantity. Using samples of nominal weights, the amount of Fe(0) determined at 34 GHz was 1.1-1.8 times greater than at 9.5 GHz, while the linewidths increased by a factor of 1.2. As the particle size increases, the ratio of Fe(0) determined at 35 GHz to that determined at 9.5 GHz increases, suggesting that the additional iron is due to larger spheroidal particles which change from multidomain to single domain at the larger fields.
The surface composition of two samples from the highly shocked, glass-coated lunar basalt (12054) and from four glass-coated fragments from the 1-2 mm (14161) fines were examined by X-ray photoemission spectroscopy to determine whether the agglutination process itself is responsible for the difference between their surface and bulk compositions. Auger electron spectroscopy of glass balls from the 15425 and 74001 fines were analyzed to understand the nature, extent, and behavior of volatile phases associated with lunar volcanism. Initial results indicate that (1) volatiles, in the outer few atomic layers sampled, vary considerably from ball to ball; (2) variability over the surface of individual balls is smaller; (3) the dominant volatiles on the balls are S and Zn; and (4) other volatiles commonly observed are P, Cl, and K.
Results on lunar volatile transport processes have been obtained by studying green and brown glass droplets, orange and black core tube samples and the surface sample 74241 with the Scanning Auger Microprobe (SAM) and by Flameless Atomic Absorption Analysis (FLAA). SAM analyses show that the most dominant volatiles in the top few atomic layers of droplets are Zn and S, confirming that the surface Zn and S are good indicators of pyroclastic origin, and they are not entirely present as ZnS. In addition, FLAA thermal release profiles show that almost all the Zn and Cd are on grain surfaces, indicating that Zn and Cd were completely outgassed from lava fountain products during the volcanic eruption, were recondensed during or after the eruptions, and are thus present as surface coating.
We report and discuss quantitative X-ray photoemission (XPS) analyses of mm size areas and qualitative scanning Auger microprobe (SAM) analyses of micron size areas on the surfaces of impact glass coatings found on fragments in the 14161 coarse fines and on the top surface, and a reentrant crack surface of rock 12054. The data suggest that some segregation occurs during impact glass formation leading to surface enrichments in Si and depletions in Mg, Al, Ca, and Ti. The magnitude of the effect appears fairly small, although the complexity of the surfaces severely complicates the data analysis. Because of the complexity of the surfaces, both XPS and SAM data were essential. A search for direct evidence of either solar wind sputter erosion or vapor deposition on the exposed top surface of 12054 provided interesting results which we cannot yet fully interpret. Both this surface and the surface from the re-entrant crack showed enrichments of more than a factor of two in Fe with respect to the bulk.
Flameless atomic absorption (FLAA), X-ray photoemission spectroscopy (XPS) and grain size separation techniques were adopted to analyze Pb, Cd, Zn and S in orange and black droplets from Apollo 17 samples. The FLAA and XPS investigations show volatile trace metal enrichment in smaller grain fractions (broken droplets); thus a part of the volatiles was probably deposited after break-up of the droplets. In addition, redistribution of the volatiles by a cratering event is indicated by continuous decreases in Pb and Cd with core depth. Studies of Zn on individual regolith grains are also reported.
Explore the source record for details and available documents.
Heat treatment procedure at low pressure increases internal-friction quality factor of treated samples. Method can reduce propagation losses in porous ferroelectric ceramics by as much as a factor of 100.
We first review the evidence which links the characteristic ferromagnetic resonance observed in lunar fines samples with agglutinatic glass produced primarily by micrometeorite impacts and present new results on Apollo 15, 16, and 17 breccias which support this link by showing that only regolith breccias contribute significantly to the characteristic FMR intensity. We then provide a calibration of the amount of Fe metal in the form of uniformly magnetized spheres required to give our observed FMR intensities and discuss the theoretical magnetic behavior to be expected of Fe spheres as a function of size. Finally, we present FMR results on samples from every 5 mm interval in the core segments 60003, 60009, and 70009. These results lead us to suggest: (1) that secondary mixing may generally be extensive during regolith deposition so that buried regolith surfaces are hard to recognize or define; and (2) that local grinding of rocks and pebbles during deposition may lead to short scale fluctuations in grain size, composition, and apparent exposure age of samples.
Explore the source record for details and available documents.
Developments in the understanding of reduction processes which occur in the lunar regolith as a result of solar-wind bombardment and micrometeorite impacts are discussed. The mechanism is described by which water released during reduction is removed from the lunar surface, and the possible contribution of solar-wind sputtering to the reduction process is considered. It is shown that the overall reduction efficiency of incoming hydrogen ions may reach several per cent, which is sufficient to produce all the metallic iron observed in the regolith. Mossbauer spectroscopic data on the amount of metallic iron present as isolated atoms or small clusters in reduced grain surfaces are presented together with data on the metallic iron content of fines samples obtained by Mossbauer spectroscopy, ferromagnetic resonance, and scanning as well as transmission electron microscopy. A portable magnetic probe is described which has been designed for determining surface-exposure age profiles in intact lunar core and drive-tube samples.
The physical properties of lunar rocks were measured using the vibrating bar technique in order to provide data for interpretation of geophysical results such as those from seismic measurements. The effect of volatiles on the mechanical Q in lunar rocks was studied in addition to the effect of exposing a sample to controlled amounts of those gases most likely to be present in the lunar environment or likely to have been outgassed from the lunar interior. The moderate temperatures to which the sample was exposed during the thermal treatment and the small drop in resonant frequency during the course of the outgassing suggests that there was little change in microfracture density. The frequency, composition and texture dependence of the damping were investigated, to study the loss mechanism.
Internal friction quality factors Q up to 2200 have been observed in a strongly outgassed terrestrial analog of lunar basalt. This was accomplished by successively cycling a bar shaped sample vibrating in its fundamental longitudinal mode at 15 kHz to higher and higher temperatures in a vacuum between 100 and 10 nanotorr. After each cycle, Q measured at room temperature in the vacuum was observed to decrease with time suggesting that gas reabsorption was taking place even at these low pressures. A study of the effect of exposing a sample to a variety of gases and vapors showed that of the volatiles most likely to be present in the lunar environment H2O was by far the most effective in lowering Q.
We describe the characteristics of Apollo 16 fines samples 61281,8; 65701,13; 66031,6; 67701,26; and 67712,16 observed microscopically during the course of size and magnetic separations. Sample 67712,16 is unique in that almost all grains are rounded and no glass welded aggregates are present. All samples except 67712,16 contained about 0.5 wt.% of metal fragments 45 microns or more in diameter including occasional spheres and large single crystals. Some of this metal showed rust spots. Moessbauer spectra showed all the samples to be high in olivine compared to samples from other Apollo sites and to vary significantly in modal composition from each other. The fine grained Fe metal content and the excess absorption area near zero velocity in the Moessbauer spectra both vary with particle size and regolith maturity in the way one would predict from our model of Fe metal reduction and agglomeration during glass aggregate formation.