Nozzle extension design status report
Twenty possible concepts of a possible nozzle/nozzle extension interface were originated. Not all of the concepts were considered worthy of analysis time. Six of them were thermally analyzed and three were stress analyzed. These analyses were done to determine which of the concepts would have the best chance of succeeding, that is, they were a screening process which was to allow rating of one concept against another. This was done because adequate material properties to determine absolute stress levels were not available at the time of the analyses. Through all of the concepts still exhibit some areas of negative margin of safety, concept no. 1 shows good promise that, with slight modifications, it could have all positive margins of safety. Another significant question, regarding these designs, has to do with the Grafoil seals and insulators. Some additional data was just recently received on Grafoil properties, but it was too late to incorporate in the analyses. The new data were not significantly different from the properties which were used.