Electric flight systems
Materials used to illustrate a presentation on the development of electric flight systems are presented. Systems concepts are outlined.
Clay, C. W.↗
Engineering topics
Clay, C. W.
Publications and source records attributed to Clay, C. W..
An analysis of prop-fan/airframe aerodynamic integration
An approach to aerodynamic integration of turboprops and airframes, with emphasis placed upon wing mounted installations is addressed. Potential flow analytical techniques were employed to study aerodynamic integration of the prop fan propulsion concept with advanced, subsonic, commercial transport airframes. Three basic configurations were defined and analyzed: wing mounted prop fan at a cruise Mach number of 0.8, wing mounted prop fan in a low speed configuration, and aft mounted prop fan at a cruise Mach number of 0.8.
Boctor, M. L.↗
Application of advanced technologies to small, short-haul aircraft
The results of a preliminary design study which investigates the use of selected advanced technologies to achieve low cost design for small (50-passenger), short haul (50 to 1000 mile) transports are reported. The largest single item in the cost of manufacturing an airplane of this type is labor. A careful examination of advanced technology to airframe structure was performed since one of the most labor-intensive parts of the airplane is structures. Also, preliminary investigation of advanced aerodynamics flight controls, ride control and gust load alleviation systems, aircraft systems and turbo-prop propulsion systems was performed. The most beneficial advanced technology examined was bonded aluminum primary structure. The use of this structure in large wing panels and body sections resulted in a greatly reduced number of parts and fasteners and therefore, labor hours. The resultant cost of assembled airplane structure was reduced by 40% and the total airplane manufacturing cost by 16% - a major cost reduction. With further development, test verification and optimization appreciable weight saving is also achievable. Other advanced technology items which showed significant gains are as follows: (1) advanced turboprop-reduced block fuel by 15.30% depending on range; (2) configuration revisions (vee-tail)-empennage cost reduction of 25%; (3) leading-edge flap addition-weight reduction of 2500 pounds.
Andrews, D. G.↗
The shape of the future long-haul transport airplane
Long-haul transport plane configurations are discussed that are considered technically feasible within a practical level of near-term technology. Supersonic and transonic aircraft are considered, as well as different types of subsonic transports. It is indicated that superior second-generation supersonic transports are quite feasible technically; in particular, it is shown that problems of fuel consumption, efficient overland flight, and questions on noise and nitric oxides have straightforward engineering solutions. Transonic aircraft are practical but would have to have a different geometry than subsonic aircraft to provide the versatility necessary to compete at one end of their capability with supersonic transports and at the other end, for shorter ranges, with subsonic transports. The shape of subsonic transports is not expected to change noticeably, although recent advances of airfoil technology imply that new subsonic transports would have wings with higher aspect ratios and somewhat less sweep. But large specialized freighter aircraft and very long range laminar flow control or nuclear-powered aircraft with radically new shapes are possible.
Clay, C. W.↗