Search NASA⌕ Search

Engineering topics

Clements, T. R.

Publications and source records attributed to Clements, T. R..

5 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Effect of swirling flow on augmentor performance, phase 2

A test program has been conducted with an augmentor that employed swirling flow as a means of promoting rapid flame propagation. The program measured the trajectory and dispersion of JP-5-type kerosene sprayed into a strongly swirling flowfield. Using the data obtained, a set of sprayrings was designed and evaluated in the augmentor at conditions simulating those typical of augmented turbojet engines. At the inlet test temperature of 649 C the swirling flowfield had no effect on the radial position of the fuel spray. The augmentor demonstrated combustion efficiencies greater than 95% over most of the operating range, which extended from an equivalence ratio of 0.2 to over 1.0.

Clements, T. R.↗
NASA NTRS1974

Effect of swirling flow on augmentor performance

A test program was conducted with an augmentor which employed swirling flow as a means of promoting rapid flame propagation. The program evaluated the effect of augmentor length, swirl intensity, fuel zoning and Mach number on augmentor performance. Combustion efficiencies near 100% were demonstrated over most of the operating range which extended from an equivalence ratio of 0.2 to over 1.0. The tests were conducted at an inlet temperature of 649 C (1200 F) and at a pressure of 2 atmospheres. The augmentor total pressure losses were typical of current state of the art augmentors.

Clements, T. R.↗
NASA NTRS1973

Effect of fuel zoning and fuel nozzle design on pollution emissions at ground idle conditions for a double-annular ram-induction combustor

An exhaust emission survey was conducted on a double-annular ram induction combustor at simulated ground idle conditions. The combustor was designed for a large augmented turbofan engine capable of sustained flight speeds up to Mach 3.0. The emission levels of total hydrocarbon (THC), carbon monoxide, carbon dioxide, and nitric oxide were measured. The effects of fuel zoning, fuel nozzle design, and operating conditions (inlet temperature and reference Mach number) on the level of these emissions were determined. At an overall combustor fuel/air ratio of 0.007, fuel zoning reduced THC emissions by a factor of 5 to 1. The reduction in THC emissions is attributed to the increase in local fuel/air ratio provided by the fuel zoning. An alternative method of increasing fuel/air ratio would be to operate with larger-than-normal compressor overboard bleed; however, analysis on this method indicated an increase in idle fuel consumption of 20 percent. The use of air-atomizing nozzles reduced the THC emissions by 2 to 1.

Clements, T. R.↗
NASA NTRS1972

Development of a short length combustor for a supersonic cruise turbofan engine using a 90 deg sector of a full annulus

A performance development program has been conducted on a short length, double-annular, ram-induction combustor. The combustor was designed for a large augmented turbofan engine capable of sustained flight speeds up to Mach 3.0. Performance tests were conducted at an inlet temperature and Mach number simulating engine sea level takeoff conditions. At the design temperature rise of 1600 F, combustion efficiency was 100%, pattern factor was 0.20, and combined diffuser-combustor pressure loss was 4.4% or 1.12 times the diffuser inlet velocity head. A temperature rise in excess of 2400 F with a combustion efficiency of 94% was demonstrated.

Clements, T. R.↗