Search NASA⌕ Search

Engineering topics

Cofer, W. R., III

Publications and source records attributed to Cofer, W. R., III.

32 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Methane and nonmethane hydrocarbon concentrations in the Atlantic marine boundary layer

The reactions of reduced tropospheric trace gases with hydroxyl radicals are thought to play a significant role in global tropospheric photochemistry. Since tropospheric methane and nonmethane hydrocarbon (NMHC) concentrations will affect the tropospheric hydroxyl radical concentrations, accurate measurements of tropospheric CH4 and NMHC concentrations are necessary. Such measurements were, therefore, included in the first leg (from Hamburg, West Germany to Montevideo, Uruguay) of the 1980-1981 Antarctic Expedition. On the basis of the obtained data, a pronounced gradient between northern and southern hemispheric methane concentrations was observed in the marine boundary layer in the region of the intertropical convergence zone. Methane concentrations gradually decreased from about 1.70 ppmv at 40 deg N latitude to about 1.68 ppmv at 14 deg N latitude, then dropped sharply between 14 deg N and 10 deg N latitude to about 1.61 ppmv. NMHC data are also discussed.

Cofer, W. R., III↗
NASA NTRS1982

Carbon-catalyzed oxidation of SO2 by NO2 and air

A series of experiments was performed using carbon particles (commercial furnace black) as a surrogate for soot particles. Carbon particles were suspended in water, and gas mixtures were bubbled into the suspensions to observe the effect of carbon particles on the oxidation of SO2 by air and NO2. Identical gas mixtures were bubbled into a blank containing only pure water. After exposure each solution was analyzed for pH and sulfate. It was found that NO2 greatly enhances the oxidation of SO2 to sulfate in the presence of carbon particles. The amount of sulfate found in the blanks was significantly less. Under the conditions of these experiments no saturation of the reaction was observed and SO2 was converted to sulfate even in a highly acid medium (pH or = 1.5).

Rogowski, R. S.↗
NASA NTRS1982

Carbon catalyzed SO2 oxidation by NO2 and O3

The oxidation of SO2 to sulfate on carbon particles by trace quantities of NO2 and O3 was studied. Particulate carbon black was either: (1) directly exposed on the pan of a microbalance to various humidified mixtures of SO2 and oxidant gas and the resultant weight gains monitored, or (2) the gas mixtures were bubbled through aqueous suspensions of carbon black and pure water blanks. In each set of experiments the run times were varied appropriately and the yields of sulfate were determined analytically. Conversion of SO2 to sulfate was thus characterized as a function of exposure time and of oxidant gas. Carbon black was determined to be an excellent catalyst for SO2 oxidation to sulfate by both NO2 and O3. No saturation effects were observed in either experimental approach. Conversions of SO2 to sulfate did not appear pH dependent.

Cofer, W. R., III↗
NASA NTRS1982

Oxidation of SO2 by NO2 and air in an aqueous suspension of carbon

A series of experiments has been performed using carbon black as a surrogate for soot particles. Carbon black was suspended in water and gas mixtures were bubbled into the suspensions to observe the effect of carbon particles on the oxidation of SO2 by air and NO2. Identical gas mixtures were bubbled into a black containing only pure water. After exposure each solution was analyzed for pH and sulfate. It was found that NO2 greatly enhances the oxidation of SO2 to sulfate in the presence of carbon black. The amount of sulfate in the blanks was significantly less. Under the conditions of the experiments no saturation of the reaction was observed and SO2 was converted to sulfate even in a highly acid medium (pH not less than 1.5).

Rogowski, R. S.↗
NASA NTRS1981

Automated analyzer for aircraft measurements of atmospheric methane and total hydrocarbons

An automated methane/total hydrocarbon analyzer is presented, which can produce alternate methane/total hydrocarbon measurements every 7 seconds to provide the spatial resolution required for regional hydrocarbon measurements at aircraft speeds. The construction and sampling techniques developed for the aircraft mounted system are discussed. A technique to periodically measure atmosphere oxygen is incorporated into the analyzer to ensure accurate hydrocarbon measurements, and a data collection methodology is developed to minimize errors resulting from changes in flame ionization detector sensitivity at different altitudes. Aircraft data acquired at the 1979 Southeastern Virginia Urban Plume Study are also presented, which illustrate the application of the instrument to a troposphere pollution plume.

Cofer, W. R., III↗
NASA NTRS1981

Summary of measurement results of ozone, methane, and nonmethane hydrocarbons for C-54 aircraft. 1979 Southeastern Virginia Urban Plume Study

Methane, nonmethane hydrocarbon, and ozone data collected in a C-54 aircraft during the 1979 Southeastern Virginia Urban Plume Study are presented. Three major aircraft experiments were flown on five separate days in August collecting 20 hours of flight data. Direct correlation between ozone and hydrocarbon plumes was observed on several occasions.

Cofer, W. R., III↗
NASA NTRS1981

Summary of 1978 Southeastern Virginia Urban Plume study: Aircraft results for carbon monoxide, methane, nonmethane hydrocarbons, and ozone

The characteristics of the Southeastern Virginia urban plume were defined with emphasis on the photon-oxidant species. The measurement area was a rectangle, approximately 150 km by 100 km centered around Cape Charles, Virginia. Included in this area are the cities of Norfolk, Virginia Beach, Chesapeake, Newport News, and Hampton. The area is bounded on the north by Wallops Island, Virginia, and on the south by the Hampton Roads area of Tidewater Virginia. The major axis of the rectangle is oriented in the southwest-northeast direction. The data set includes aircraft measurements for carbon monoxide, methane, nonmethane hydrocarbons, and ozone. The experiment shows that CO can be successfully measured as a tracer gas and used as an index for determining localized and urban plumes. The 1978 data base provided sufficient data to assess an automated chromatograph with flame ionization detection used for measuring methane and nonmethane hydrocarbons in flight.

Hill, G. F.↗
NASA NTRS1980

Synergistic effects in trace gas-aerosol interactions

The reaction of SO2 and NO2 with soot has been studied experimentally by gravimetric determination of chemisorption with subsequent analysis of the chemisorbed species by various techniques. When samples of commercially available carbon black (used as soot surrogate) are exposed to SO2 or NO2 in dry air or N2 as carrier gas, no quantitative chemisorption (less than 5 micrograms per mg of substrate) is observed. However, exposure of the same grade of carbon to a combination of SO2 and NO2 in dry air of N2 results in significant chemisorption (180-200 micrograms/mg), a major fraction of which is analyzed as sulfate.

Schryer, D. R.↗
NASA NTRS1980

The enhanced oxidation of SO2 by NO2 on carbon particulates

The oxidation of SO2 on carbon particles in dry air and in air at 65% relative humidity (RH) was found to be greatly enhanced by the presence of gaseous NO2. Exposures of 20-80ppm SO2 + 10ppm NO2 on 1-mg samples of commercial carbon black were found to produce both sorption and desorption coverages (weight retained after desorption into N2) of over one order of magnitude greater than for corresponding SO2 exposures. Significant agglomeration and wetting were observed to occur progressively during exposures at 65% RH, and samples, even after 150-h exposure, rarely reached steady-state weight gain. The wetting may have regenerated fresh reactive carbon surface. Sorptions conducted in nitrogen atmospheres, rather than in air, appeared to produce slightly higher sorptions and weight retentions for equivalent exposure concentrations and times, indicating that NO2 served as the oxidizer and that molecular oxygen, or some trace constitutents in air, may have weakly inhibited the oxidation by NO2. Wet chemical analysis of the desorbed phase indicated that sulfate, presumably H2SO4 accounted for over half of the retained weight. Measurements of pH from water-quenched samples indicated a highly acidic surface phase, and suggested the oxidation process could proceed in an acidic environment.

Cofer, W. R., III↗
NASA NTRS1978

Enhanced hydrophilicity of chlorided aluminum oxide particulates

An enhancement of hydrophilicity for chlorided aluminas was demonstrated by the results obtained from gaseous H2O sorptions at 70-, 80-, and 86-percent relative humidity on alpha and gamma aluminum oxide particulates and on alpha and gamma aluminum oxide particulates with a chemisorbed surface chloride phase (produced by reactions of gaseous HCl + H2O on alumina). Continuous sorption histories for H2O on chlorided aluminas having specific surface areas that range from 7 to 227 sq m/g before chloriding indicated that initial sorption rates were directly linked to the extent of chemisorbed chlorided coverage and implied the same relationship for sorption capacities. The initial sorption rate on chlorided aluminas was found to be slower for the first exposure to H2O than for subsequent exposures (which reached equilibrated H2O coverages much faster), suggesting that slow chemical reactions between H2O and chlorided alumina may have been operative during initial exposures. Chlorided alumina particles were found to remain very hydrophilic (relative to nonchlorided analogs) for several H2O sorption/desorption cycles.

Cofer, W. R., III↗
NASA NTRS1978

Adsorption and chemical reaction of gaseous mixtures of hydrogen chloride and water on aluminum oxide and application to solid-propellant rocket exhaust clouds

Hydrogen chloride (HCl) and aluminum oxide (Al2O3) are major exhaust products of solid rocket motors (SRM). Samples of calcination-produced alumina were exposed to continuously flowing mixtures of gaseous HCl/H2O in nitrogen. Transient sorption rates, as well as maximum sorptive capacities, were found to be largely controlled by specific surface area for samples of alpha, theta, and gamma alumina. Sorption rates for small samples were characterized linearly with an empirical relationship that accounted for specific area and logarithmic time. Chemisorption occurred on all aluminas studied and appeared to form from the sorption of about a 2/5 HCl-to-H2O mole ratio. The chemisorbed phase was predominantly water soluble, yielding chloride/aluminum III ion mole ratios of about 3.3/1 suggestive of dissolved surface chlorides and/or oxychlorides. Isopiestic experiments in hydrochloric acid indicated that dissolution of alumina led to an increase in water-vapor pressure. Dissolution in aqueous SRM acid aerosol droplets, therefore, might be expected to promote evaporation.

Cofer, W. R., III↗