Search NASASearch

Engineering topics

Cohen, J. M.

Publications and source records attributed to Cohen, J. M..

At least 19 records

Large Engine Technology Program. Task 22: Variable Geometry Concepts for Rich-Quench-Lean Combustors

The objective of the task reported herein was to define, evaluate, and optimize variable geometry concepts suitable for use with a Rich-Quench-Lean (RQL) combustor. The specific intent was to identify approaches that would satisfy High Speed Civil Transport (HSCT) cycle operational requirements with regard to fuel-air ratio turndown capability, ignition, and stability margin without compromising the stringent emissions, performance, and reliability goals that this combustor would have to achieve. Four potential configurations were identified and three of these were refined and tested in a high-pressure modular RQL combustor rig. The tools used in the evolution of these concepts included models built with rapid fabrication techniques that were tested for airflow characteristics to confirm sizing and airflow management capability, spray patternation, and atomization characterization tests of these models and studies that were supported by Computational Fluid Dynamics analyses. Combustion tests were performed with each of the concepts at supersonic cruise conditions and at other critical conditions in the flight envelope, including the transition points of the variable geometry system, to identify performance, emissions, and operability impacts. Based upon the cold flow characterization, emissions results, acoustic behavior observed during the tests and consideration of mechanical, reliability, and implementation issues, the tri-swirler configuration was selected as the best variable geometry concept for incorporation in the RQL combustor evolution efforts for the HSCT.

Tacina, Robert R.

Longitudinal Mode Aeroengine Combustion Instability: Model and Experiment

Combustion instabilities in gas turbine engines are most frequently encountered during the late phases of engine development, at which point they are difficult and expensive to fix. The ability to replicate an engine-traceable combustion instability in a laboratory-scale experiment offers the opportunity to economically diagnose the problem more completely (to determine the root cause), and to investigate solutions to the problem, such as active control. The development and validation of active combustion instability control requires that the casual dynamic processes be reproduced in experimental test facilities which can be used as a test bed for control system evaluation. This paper discusses the process through which a laboratory-scale experiment and be designed to replicate an instability observed in a developmental engine. The scaling process used physically-based analyses to preserve the relevant geometric, acoustic, and thermo-fluid features, ensuring that results achieved in the single-nozzle experiment will be scalable to the engine.

Cohen, J. M.

Experimental Replication of an Aeroengine Combustion Instability

Combustion instabilities in gas turbine engines are most frequently encountered during the late phases of engine development, at which point they are difficult and expensive to fix. The ability to replicate an engine-traceable combustion instability in a laboratory-scale experiment offers the opportunity to economically diagnose the problem (to determine the root cause), and to investigate solutions to the problem, such as active control. The development and validation of active combustion instability control requires that the causal dynamic processes be reproduced in experimental test facilities which can be used as a test bed for control system evaluation. This paper discusses the process through which a laboratory-scale experiment was designed to replicate an instability observed in a developmental engine. The scaling process used physically-based analyses to preserve the relevant geometric, acoustic and thermo-fluid features. The process increases the probability that results achieved in the single-nozzle experiment will be scalable to the engine.

Cohen, J. M.

Longitudinal-Mode Combustion Instabilities: Modeling and Experiments

Combustion instabilities can lead to increased development time and cost for aeroengine gas turbines. This problem has been evident in the development of very-low emissions stationary gas turbines, and will likely be encountered in the newer, more aggressive aeroengine designs. In order to minimize development time and cost, it is imperative that potential combustion dynamics issues be resolved using analyses and smaller-scale experimentation. This paper discusses a methodology through which a problem in a full-scale engine was replicated in a single-nozzle laboratory combustor. Specifically, this approach is valid for longitudinal and "bulk" mode combustion instabilities. An explanation and partial validation of the acoustic analyses that were used to achieve this replication are also included. This approach yields a testbed for the diagnosis of combustion dynamics problems and for their solution through passive and active control techniques.

Cohen, J. M.

Analytic pulsar models

An analytical procedure is given for solving the Einstein equations of a rotating fluid body. It is demonstrated that an analytic model of uniform denisty, representing a slowly rotating neutron star, can describe both differentially and uniformly rotating stars.

Adams, R. C.

Origin of cosmic rays

A model is presented in which cosmic electrons are produced by pulsars, and cosmic protons and alpha particles are accelerated by shock waves in supernova envelopes. It is argued that neither mechanism by itself can produce both the observed protons and electrons at energies above a few hundred MeV. But supernova accelerated electrons could constitute the majority of cosmic electrons with energy below about 10 MeV.

Cohen, J. M.

Pulsar observations and neutron star models

Information about the physical parameters of neutron stars is obtained from pulsar observations. The energy balance of the Crab Nebula and the Vela X remnant allows one to derive limits for the masses of the Crab and Vela pulsars. Glitch observations provide further clues on the masses of these two pulsars. The degree of confidence with which one should believe the derived numbers is pointed out. The possibility of observing neutron stars in binary systems as pulsating X-ray sources is discussed. Finally, the importance of observing redshifted gamma ray lines from the surface of neutron stars, and thus directly measuring either individual or statistical properties of these objects, is pointed out.

Boerner, G.

Hadron star models

The properties of fully relativistic rotating hadron star models are discussed using models based on recently developed equations of state. All of these stable neutron star models are bound with binding energies as high as about 25%. During hadron star formation, much of this energy will be released. The consequences, resulting from the release of this energy, are examined.

Cohen, J. M.

Rotating neutron star models and pulsars

Recently developed equations of state are used to construct fully relativistic models of rotating neutron stars. All of these stable neutron star models are bound. Consideration of binding energies suggests that very-low-mass neutron stars will not be formed in supernova explosions. Some criteria for equations of state are derived from a comparison with observations. Limits for the physical parameters of the Crab pulsar are obtained. In addition, we find that cosmic-ray protons cannot be produced by pulsars.

Boerner, G.

Cooling black body: A mechanism for cosmic gamma-ray bursts

An examination was made of black body emission as a possible radiation mechanism for cosmic ray bursts. It was suggested that black body radiation of variable temperature causes the bursts. Temperature variations are caused by cooling due to gamma ray emission.

Ramaty, R.

Positron-annihilation radiation from neutron stars.

Matter accreted on the surfaces of neutron stars consists of energetic particles of a few tens to one or two hundred MeV per nucleon, depending on the neutron-star mass. In addition to heat, such particles produce nuclear reactions with the surface material. It is proposed that the recently observed 473 plus or minus 30 keV spectral feature from the galactic center is gravitationally redshifted positron-annihilation radiation produced at the surfaces of neutron stars. The principal observational tests of the model would be the detection of nuclear gamma-ray lines from the galactic center.

Ramaty, R.

Gyromagnetic ratio of a massive body.

It is well known that the gyromagnetic ratio (g factor) of a classical, slowly rotating body whose charge density is proportional to its mass density must be equal to unity. However, if the body is very massive, the spacetime curvature effects of general relativity become important and the result g = 1 is no longer valid. We calculate here the gyromagnetic ratio of a slowly rotating, massive shell with uniform charge density. When the shell is large compared with the Schwarzschild radius we have g = 1, but as the shell becomes more massive the g factor increases. In the limit as the shell approaches its Schwarzschild radius we obtain g approaching 2 (the same value as for an electron).

Cohen, J. M.

Closed anisotropic cosmological models.

Derivation of a new exact solution to Einstein's equations representing homogeneous nonisotropic cosmological models of a closed universe containing electromagnetic and scalar fields. This solution reduces to a generalization of Brill's electromagnetic universe when the scalar field vanishes, and to the Taub-NUT-M space when both these fields vanish. The solutions also satisfy the scalar tensor equations and represent a universe containing electromagnetic fields and a source-free solution to the scalar-tensor equations representing a closed universe.

Batakis, N.

Pulsar observations and neutron star models

Information about the physical parameters of neutron stars is obtained from pulsar observations. The energy balance of the Crab nebula and the Vela X remnant allows derivation of limits for the masses of the Crab and Vela pulsars. Glitch observations provide further clues on the masses of these two pulsars. The degree of confidence in the derived numbers is pointed out. The possibility of observing neutron stars in binary systems as pulsating X-ray sources is discussed. The importance of observing redshifted gamma ray lines from the surface of neutron stars, and thus directly measuring either individual or statistical properties of these objects is pointed out.

Boerner, G.

Position annihilation radiation from neutron stars

Matter accreted on the surfaces of neutron stars consists of energetic particles of a few tens to a couple hundred MeV/nucleon, depending on the neutron star mass. In addition to heat, such particles produce nuclear reactions with the surface material. It is proposed that the recently observed 473 + or - 30 keV spectral feature from the galactic center is gravitationally red-shifted positron annihilation radiation produced at the surfaces of old neutron stars. The principal observational tests of the model would be the detection of nuclear gamma ray lines from the galactic center and red-shifted positron annihilation radiation from the galactic disk.

Ramaty, R.