Compagnini, Giuseppe | Search NASA

DOE OSTI2023

High performance aluminum-air flow batteries through double-face architecture and laser-modified and friction-stir processed 3D anode

Aluminum-air batteries (AAB) are regarded as one of the most promising beyond-lithium high-energy-density storage candidates. Here, this paper introduces a three-dimensional (3D) Al 7075 anode enabled by femtosecond laser and friction-stir process which, along with a special double-face anode architecture provides world-class performance. Electrochemical characterizations prove that the corrosion resistance of the modified 3D Al 7075 FSP anode was enhanced, and electrochemically active surface area (ECSA) was increased compared with that of normal Al 7075 anode. Friction-stir processing reduced the mean grain size from 30 μm to 3 μm. The discharge performance of 3D Al 7075 FSP anode is shown to be quite stable, and the average values of energy density are significantly increased from 2256 mWh g –1 to 2941 mWh g –1 at 100 mA cm –2 . In a double-face flowing Al-air battery system, the 3D Al 7075 FSP anode exhibited significantly better electrocatalytic performance (discharge voltage of 0.76 V at 400 mA cm –2 , and power density of 337.8 mW cm –2 ) than that of a commercial Al 7075 anode.

25 ENERGY STORAGE↗

DOE OSTI2022

Surface analysis insight note: Differentiation methods applicable to noisy data for determination of sp2‐ versus sp3‐hybridization of carbon allotropes and AES signal strengths

The derivatives of the spectra are commonly used for quantification in Auger Electron Spectroscopy (AES) spectra, while the derivative of the KLL C Auger line has proven to be valuable in obtaining a measure of the relative proportions of sp 2 ‐ and sp 3 ‐hybridization using the D‐parameter in both AES and X‐ray Photoelectron Spectroscopy (XPS). Differentiation of X‐ray Photoelectron Spectroscopy (XPS) and Auger Electron Spectroscopy (AES) spectra by numerical means is presented and illustrated for polymeric, such as PEEK and Nylon, as well as for graphitic materials including highly ordered pyrolytic graphite and graphene oxide. The most commonly available Savitzky–Golay method is explained mathematically and developed through the case of constructing a 5‐point quadratic polynomial convolution kernel suitable for differentiating spectra of adequate signal to noise. The concept of differentiation of spectra where signal to noise is less than adequate is also developed. Two alternative strategies to Savitzky–Golay differentiation are presented, which fit curves to data that allow derivatives to be obtained where Savitzky–Golay would otherwise fail. These alternative methods involve constructing a parametric curve that fits data over the entire energy interval of interest. Derivatives of spectra are then obtained by differentiating these parametric curves directly. A comparison of results for different materials for which specific sp 2 ‐ vs sp 3 ‐hybridized carbon proportions are of interest is used to emphasize the importance of characterizing methods used to differentiate spectra and understanding the characteristics of instrumentation used to measure spectra. The case for using Principal Component Analysis noise reduction with C KLL spectra is made for spectra collected from a heterogeneous graphene oxide sample.

Fairley, Neal↗