Engineering topics

Conner, David A.

Publications and source records attributed to Conner, David A..

21 records · Page 2

NASA NTRS1991

Far-field hover acoustic characteristics of the XV-15 tiltrotor aircraft with Advanced Technology Blades

An experimental investigation has been conducted with the XV-15 tilt-rotor VTOL aircraft in order to ascertain the noise-reduction efficacy of Advanced Technology Blades (ATBs). Attention is given to acoustic directivity characteristics in the lower hemisphere of the sound field. Modest overall sound pressure levels (OASPLs) were measured near the in-plane position, showing that thickness noise is not significant in hover when ATBs are used; rotor tip-speed reductions reduced the average OASPL by nearly 8 dB in-plane and by nearly 5 dB at 12.6 deg below the rotor plane.

Conner, David A.↗

NASA NTRS1990

Some far-field acoustics characteristics of the XV-15 tilt-rotor aircraft

Far-field acoustics tests have been conducted on an instrumented XV-15 tilt-rotor aircraft. The purpose of these acoustic measurements was to create an encompassing, high confidence (90 percent), and accurate (-1.4/ +1/8 dB theoretical confidence interval) far-field acoustics data base to validate ROTONET and other current rotorcraft noise prediction computer codes. This paper describes the flight techniques used, with emphasis on the care taken to obtain high-quality far-field acoustic data. The quality and extensiveness of the data base collected are shown by presentation of ground acoustic contours for level flyovers for the airplane flight mode and for several forward velocities and nacelle tilts for the transition mode and helicopter flight mode. Acoustic pressure time-histories and fully analyzed ensemble averaged far-field data results (spectra) are shown for each of the ground contour cases.

Golub, Robert A.↗

NASA NTRS1989

Measurement resolution of noise directivity patterns from acoustic flight tests

The measurement resolution of noise directivity patterns from acoustic flight tests was investigated. Directivity angle resolution is affected by the data reduction parameters, the aircraft velocity and flyover altitude, and by deviations of the aircraft from the desired flight path. Equations are developed which determine bounds for the lateral and longitudinal directivity angle resolution as a function of the nominal directivity angle. The equations are applied to a flight test data base and the effects of several flight conditions and data reduction parameters on the directivity angle resolution are presented. The maximum directivity angle resolution typically occurs when the aircraft is at or near the overhead position. In general, directivity angle resolution improves with decreasing velocity, increasing altitude, increasing sampling rate, decreasing block size, and decreasing block averages. Deviations from the desired ideal flight path will increase the resolution. For the flight experiment considered in this study, an average of two flyovers were required at each test condition to obtain an acceptable flight path. The ability of the pilot to maintain the flight track improved with decreasing altitude, decreasing velocity, and practice. Due to the prevailing wind conditions, yaw angles of as much as 20 deg were required to maintain the desired flight path.

Conner, David A.↗