Search NASA⌕ Search

Engineering topics

Conrad, E William

Publications and source records attributed to Conrad, E William.

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1953

Altitude Investigation of Several Afterburner Configurations for the J40-WE-8 Turbojet Engine

An investigation was conducted in the Lewis altitude wind tunnel to evaluate the performance and operational characteristics of the J40-WE-8 afterburner. A brief program of minor modifications to the flame holder, diffuser, and fuel system was undertaken to improve at a burner-inlet pressure level of 620 pounds per square foot. At this pressure level, modifications to the fuel system resulted in an increase in maximum net thrust from 1500 to 1600 pounds and a reduction in specific fuel consumption in the stoichiometric region from 3.70 to 3.15 pounds of fuel per hour per pound of net thrust. However, these fuel system modifications also resulted in buzzing combustion under certain operation conditions.

COMBUSTION - EFFECT OF ENGINE OPERATING CONDITIONS↗
NASA NTRS1953

Effect of Diffuser Design, Diffuser-exit Velocity Profile and Fuel Distribution on Altitude Performance of Several Afterburner Configurations

An investigation was conducted in the NACA Lewis altitude wind tunnel to improve the altitude performance and operational characteristics of an afterburner primarily by modifying the diffuser-exit velocity profile by changes in diffuser design and by changing the fuel distribution and the flame holder. Twenty configurations, consisting of combinations of six diffuser geometries, six flame-holder types, and twelve fuel systems, were investigated. Data were obtained over a range of afterburner fuel-air ratios at diffuser-inlet total pressures from 2750 to 620 pounds per square foot. Changes in fuel distribution affected the fuel-air ratio at which peak combustion efficiency occurred as well as the efficiency level. Screeching combustion, which was most prevalent at low altitudes and medium-to-high fuel-air ratios, imposed a restriction on the operable range of a number of configurations.

Diffusers, Subsonic↗
NASA NTRS1952

Effects of Internal Configuration on Afterburner Shell Temperatures

A brief investigation was conducted in the altitude wind tunnel to determine the extent to which the afterburner shell cooling problem could be alleviated by internal configuration changes. Data were obtained with and without a cooling liner installed and for variations in the radial fuel distribution and in the radial distribution in flame-seat area. Consideration is given to the effects on both shell temperature and afterburner performance. In the range of fuel-air ratio investigated, the use of a cooling liner resulted in substantial reductions in shell temperature with no penalty in performance. Appreciable reductions in afterburner shell temperature were made possible by control of the radial fuel distribution; however, the effects on performance are uncertain and may depend on other variables not investigated. No direct relation was found between shell temperature and the clearance between the flame holder and the shell; however, some cooling effect may possibly be achieved by varying the clearance.

TURBINES, GAS - AFTERBURNING↗
NASA NTRS1951

Altitude-wind-tunnel Investigation of Performance Characteristics of a J47D Prototype (RX1-1) Turbojet Engine with Variable-area Exhaust Nozzle

Performance of a J47D (RX1-1) turbojet engine equipped with afterburner, variable-area exhaust nozzle, and integrated electronic control was determined over a range of flight conditions. These data were obtained with the electronic control both operative and inoperative. For operation with scheduled exhaust nozzle area, the minimum specific fuel consumption of 1.15 pounds of fuel per hour per pound of net thrust occurred at about 7200 rpm at altitudes from 5000 to 25,000 feet at a flight Mach number of 0.19.

ENGINES, TURBOJET↗
NASA NTRS1950

Investigation of Effects of Inlet-air Velocity Distortion on Performance of Turbojet Engine

To determine effect of nonuniform inlet-air velocities, a full scale, axial-flow turbojet engine was investigated in Lewis altitude wind tunnel at altitudes from 20,000 to 50,000 feet, 0.21 flight Mach number and corrected engine speeds from 77.3 percent of rated speed to rated speed. Total-pressure variations as large as 103 pounds per square foot in radial direction and 90 pounds per square foot in circumferential direction at 30,000 feet were obtained. With the distortions investigated, net thrust varied between 0.95 and 1.03 of the thrust with uniform inlet-air distribution. Similarly the ratio of specific fuel consumption varied from 1.00 to 1.04. Within the arrange of this investigation the effects of nonuniform inlet velocity were not serious for the engine investigated.

AIR INLETS↗
NASA NTRS1949

Altitude-wind-tunnel Investigation of J47 Turbojet-engine Performance

An investigation has been conducted in the NACA Lewis altitude wind tunnel to evaluate the performance of the J47 turbojet engine over a range of simulated altitudes from 5000 to 50,000 feet, simulated flight Mach numbers from 0.21 to 0.97, and a complete range of engine speeds. Data are presented to show the effects of altitude at a flight Mach number of 0.21 and of flight Mach number at an altitude of 25,000 feet. The performance data are generalized by two methods to determine the range of flight conditions for which engine performance may be predicted from performance data obtained at a given flight condition.

Conrad, E William↗
NASA NTRS1949

Altitude Performance and Operational Characteristics of 29-inch-diameter Tail-pipe Burner with Several Fuel Systems and Flame Holders on J35 Turbojet Engine

An investigation of turbojet-engine thrust augmentation by means of tail-pipe burning has been conducted in the NACA Lewis altitude wind tunnel. Several fuel systems and flame holders were investigated in a 29-inch-diameter tail-pipe burner to determine the effect of fuel distribution and flame-holder design on tail-pipe-burner performance and operational characteristics over a range of simulated flight conditions. At an altitude of 5000 feet, the type of flame holder used had only a slight effect on the combustion efficiency. As the altitude was increased, the decrease in peak combustion efficiency became more rapid as the blocking area of the flame holder was reduced. At all altitudes investigated, an improvement in the uniformity of the radial distribution of fuel and air slightly increased the peak combustion efficiencies and shifted the peak combustion efficiency to higher tail-pipe fuel-air ratios. The use of an internal cooling liner extending the full length of the tail-pipe combustion chamber provided adequate shell cooling at all flight conditions investigated.

Conrad, E William↗