Engineering topics

Conti, Giuseppina

Publications and source records attributed to Conti, Giuseppina.

7 records

DOE OSTI2023

Correlating Tomographic Chemical Inhomogeneity and Low Energy Electronic Structure in Layered Quantum Materials

Photoemission spectroscopy (PES) is a suite of experimental tools to learn about the electronic and chemical structure of materials and surfaces. Normally implemented in a surface-sensitive manner, the research performed under this grant focused on pushing PES into less explored regimes, to reveal bulk electronic structure, to reveal tomographic (layer-resolved) chemistry and electronic structure of layered materials and heterostructures, and to reveal interface phenomena at the junction of two different materials. Standing wave (SW) spectroscopies have also been applied to PdCoO2, a material of interest due to its high conductivity and electron-hydrodynamic tendencies. This material can be modeled as an alternating layered structure consisting of metallic Pd layers and insulating CoO2 layers. Using SW XPS, the total electronic structure has been decomposed into contributions from the two layers, and computations highlighted the different many-body interactions in the two layers (Comm. Phys. 4, 143 (2021)). We have also used hard-x-ray angle-resolved photoemission spectroscopy (ARPES), to investigate LaB6, a technologically important material with widespread application as a cathode material for electron microscopes. We measured the bulk electronic structure of this material and found that the one-step model of photoemission better captured the electronic structure and correlations. This model treats the three steps of the photoemission process—excitation, transport of the photoelectron to the crystal surface, and escape into the vacuum—as a single quantum mechanically coherent process (Phys. Rev. Mater. 5, 055002 (2021)). We also applied x-ray photoelectron spectroscopy, implemented in a near total reflection grazing incidence geometry to elucidate technologically relevant interfaces, such as those between a substrate and photoresist (J. Phys. D: Appl. Phys. 54 464002 (2021)).

36 MATERIALS SCIENCE↗

DOE OSTI2022

Emergent phenomena at oxide interfaces studied with standing-wave photoelectron spectroscopy

Emergent phenomena at complex-oxide interfaces have become a vibrant field of study in the past two decades due to the rich physics and a wide range of possibilities for creating new states of matter and novel functionalities for potential devices. The electronic-structural characterization of such phenomena presents a unique challenge due to the lack of direct yet nondestructive techniques for probing buried layers and interfaces with the required Ångstrom-level resolution, as well as element and orbital specificity. In this Review, we survey several recent studies wherein soft x-ray standing-wave photoelectron spectroscopy—a relatively newly developed technique—is used to investigate buried oxide interfaces exhibiting emergent phenomena such as metal-insulator transition, interfacial ferromagnetism, and two-dimensional electron gas. The advantages, challenges, and future applications of this methodology are also discussed.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Orbital contributions in the element-resolved valence electronic structure of Bi 2 Se 3

In this work, we studied the bulk band structure of a topological insulator (TI) Bi 2 Se 3 and determined the contributions of the Bi and Se orbital states to the valence bands using standing-wave excited hard x-ray photoemission spectroscopy (SW-HAXPES). This SW technique can provide the element-resolved information and extract individual Bi and Se contributions to the Bi2Se3 valence band. Comparisons with density-functional theory calculations (local density approximation and GW) reveal that the Bi 6s, Bi 6p, and Se 4p states are dominant in the Bi 2 Se 3 HAXPES valence band. Furthermore, these findings pave a way for studying the element-resolved band structure and orbital contributions of this class of TIs.

36 MATERIALS SCIENCE↗

DOE OSTI2021

High resolution depth profiling using near-total-reflection hard x-ray photoelectron spectroscopy

By adjusting the incidence angle of incoming x rays near the critical angle of x-ray total reflection, photoelectron intensity is strongly modulated due to the variation of x-ray penetration depth. Photoelectron spectroscopy combined with near-total reflection exhibits tunable surface sensitivity, providing depth-resolved information. In this Review, we first describe the experimental setup and specific data analysis process. We then review three different examples that show the broad application of this method. Furthermore, the emphasis is on its applications correlated to oxide heterostructures, especially quantitative depth analyses of compositions and electronic states. In the last part, we discuss the limitations of this technique, mostly in terms of the range of samples that can be studied.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Chemical and structural characterization of EUV photoresists as a function of depth by standing-wave x-ray photoelectron spectroscopy

The success in the miniaturization of the electronic device constituents depends mostly on the photolithographic techniques. Recently, to achieve patterning at the sub-10-nm node, extreme ultraviolet (EUV) lithography has been introduced into high volume production. Continued scaling of EUV via increased numerical aperture to achieve nodes at 3-nm and below requires the development of fundamentally new patterning materials and new characterization methods. Current EUV-resist film thicknesses are in the 20- to 40-nm range, and further thickness reduction is required for the next generation. Therefore, interfaces become exceedingly important, and the properties of the resist film would be dominated by top and bottom interfacial effects. X-ray photoelectron spectroscopy (XPS) combined with standing-wave excitation (SW-XPS), a fairly new method in the EUV lithography field, previously had been largely applied in multilayers and superlattices for characterizing the composition and electronic structure of buried layers and interfaces as a function of depth. We applied the SW-XPS method to organic/inorganic photoresists to provide depth-selective information on their structural and chemical conditions of as a function of temperature, EUV exposure, different underlayers, and other fundamental parameters. As a first attempt, we perform an SW-XPS feasibility study on self-assembled monolayer (SAM) films after exposure to an electron beam. By SW-XPS, we determined that the interface between the Al 2 O 3 underlayer and the SAMs is smooth, with a mean roughness of about 0.2 nm. Moreover, we determined that the SAM chains are, on average, tilted by 1/430 deg off the sample normal. The SW-XPS results also suggest that the SAM is not a perfectly aligned and uniform monolayer, with some areas having thickness higher than a single monolayer. We demonstrated that SW-XPS can provide useful information on ultrathin materials with high potential for being used as a characterization method of organic/inorganic photoresists.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Bulk electronic structure of lanthanum hexaboride (LaB 6 ) by hard x-ray angle-resolved photoelectron spectroscopy

In the last decade rare-earth hexaborides have been investigated for their fundamental importance in condensed matter, and for their applications in advanced technological fields. Among these compounds, LaB 6 has a special place, being a traditional d-band metal without additional f- bands. In order to understand the bulk electronic structure of the more complex rare-earth hexaborides, in this paper we investigate the bulk electronic structure of LaB 6 using tender/hard x-ray photoemission spectroscopy, measuring both core-level and angle-resolved valence-band spectra. Furthermore, we compare the La 3d core level spectrum to cluster model calculations in order to understand the bulk-like core-hole screening effects. The results show that the La 3d well-screened peak is at a lower binding energy compared to the main poorly-screened peak; the relative intensity between these peaks depends on how strong the hybridization is between La and B atoms. Here, we show that the recoil effect, negligible in the soft x-ray regime, becomes prominent at higher kinetic energies for lighter elements, such as boron, but is still negligible for heavy elements, such as lanthanum. In addition, we report the bulk-like band structure of LaB6 determined by tender/hard x-ray angle-resolved photoemission spectroscopy (HARPES). We compare HARPES experimental results to the free-electron final-state calculations and to the more precise one-step photoemission theory including matrix element and phonon excitation effects. The agreement between the features present in the experimental ARPES data and the theoretical calculations is very good. In addition, we consider the nature and the magnitude of phonon excitations in order to interpret HARPES experimental data measured at different temperatures and excitation energies. We demonstrate that one step theory of photoemission and HARPES experiments provide, at present, the only approach capable of probing, both experimentally and theoretically, true “bulk-like” electronic band structure of rare-earth hexaborides and strongly correlated materials.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Two-dimensional electron systems in perovskite oxide heterostructures: Role of the polarity-induced substitutional defects

The discovery of a two-dimensional electron system (2DES) at the interfaces of perovskite oxides such as LaAlO 3 and SrTiO 3 has motivated enormous efforts in engineering interfacial functionalities with this type of oxide heterostructures. However, the fundamental origins of the 2DES are still not understood, e.g., the microscopic mechanisms of coexisting interface conductivity and magnetism. In this paper, we report a comprehensive spectroscopic investigation on the depth profile of 2DES-relevant Ti 3d interface carriers using depth- and element-specific techniques like standing-wave excited photoemission and resonant inelastic scattering. We found that one type of Ti 3d interface carriers, which give rise to the 2DES are located within three unit cells from the n-type interface in the SrTiO 3 layer. Unexpectedly, another type of interface carriers, which are polarity-induced Ti-on-Al antisite defects, reside in the first three unit cells of the opposing LaAlO3 layer (~10 Å). Our findings provide a microscopic picture of how the localized and mobile Ti 3d interface carriers distribute across the interface and suggest that the 2DES and 2D magnetism at the LaAlO 3 /SrTiO 3 interface have disparate explanations as originating from different types of interface carriers.

36 MATERIALS SCIENCE↗