Engineering topics

Cook, M.

Publications and source records attributed to Cook, M..

22 records · Page 2

NASA NTRS1989

Field joint protection system rain qualification test report

This report documents the procedures, performance, and results obtained from the Field Joint Protection System (FJPS) rain test. This test was performed to validate that the flight configuration FJPS prevents the accumulation of moisture in the redesigned solid rocket motor (RSRM) field joints when subjected to simulated prelaunch natural rain environments. The FJPS test article was exposed to rain simulation for approximately 50 minutes. During the test, water entered through the open upper end of the systems tunnel and was funneled down between the tunnel and case. A sealant void at the moisture seal butt splice allowed this water to flow underneath the FJPS. The most likely cause of voids was improper bondline preparation, particularly on the moisture seal surface. In total, water penetrated underneath approximately 60 percent of the FJPS circumference. Because the test article was substantially different from flight configuration (no systems tunnel closeout), results of this test will not affect current flight motors. Due to the omission of systems tunnel covers and systems tunnel floor plate closeout, the test assembly was not representative of flight hardware and resulted in a gross overtest. It is therefore recommended that the test be declared void. It is also recommended that the test be repeated with a complete closeout of the systems tunnel, sealed systems tunnel ends, and improved adhesive bondline preparation.

Cook, M.↗

NASA NTRS1989

Field joint environmental protection system vibration/pressurization qualification

The procedures used and results obtained from vibration testing the redesigned solid rocket motor (RSRM) field joint environmental protection system (FJEPS), hereafter referred to as the joint protection system (JPS) are documented. The major purposes were to certify that the flight-designed JPS will withstand the dynamic environmental conditions of the redesigned solid rocket booster, and to certify that the cartridge check valve (vent valve) will relieve pressure build-up under the JPS during the initial 120 sec of flight. Also, an evaluation of the extruded cork insulation bonding was performed after the vibration testing.

Cook, M.↗

NASA NTRS1989

Lunar shuttle

Current plans for the extension of human presence into the solar system include the establishment of a permanently occupied base on the Moon for use as a source of raw materials, a transportation node, a facility for the fabrication and launch of elements of the space exploration infrastructure, and a base for scientific investigation and astronomical observatories. All of the aforementioned uses of a lunar base foresee the requirement for a lunar shuttle to operate from the lunar surface to one or more orbiting space stations located in low lunar orbits (LLO). The Utah State University lunar shuttle design is baslined for implementation after a mature lunar base has been established. The shuttle is designed to operate between the lunar base and a space station located in a 400-km-altitude orbit. This orbit was chosen with reference to Apollo experience, which has indicated that very low orbits, on the order of 100-km, may be unstable over periods of many months. After a thorough investigation of the anticipated needs and production capabilities of a lunar base, several design requirements were placed upon the shuttle. These requirements are (1) maximum use of lunar-derived propellant; (2) modularity and payload versatility; (3) two-way transport of 25-metric-ton cargo; (4) human transport capability; (5) satellite servicing; and (6) 3000-kg mass budget.

Voyer, P.↗

NASA NTRS1981

Using rewards and penalties to obtain desired subject performance

Operant conditioning procedures, specifically the use of negative reinforcement, in achieving stable learning behavior is described. The critical tracking test (CTT) a method of detecting human operator impairment was tested. A pass level is set for each subject, based on that subject's asymptotic skill level while sober. It is critical that complete training take place before the individualized pass level is set in order that the impairment can be detected. The results provide a more general basis for the application of reward/penalty structures in manual control research.

Cook, M.↗