Search NASASearch

Engineering topics

Cook, W. L.

Publications and source records attributed to Cook, W. L..

Comparison of model and flight test data for an augmentor-wing STOL research aircraft

The major areas of confidence derived from wind tunnel tests performed on the Augmentor-Wing jet-STOL research aircraft were delineated and it was shown that, for the most part, tunnel results compare favorably with flight experience. Since the model differs in some respects from the actual aircraft, precise correlation between tunnel and flight tests results were not expected; in some areas the model tests were known to be non-representative so that a degree of uncertainty remained: these areas of greater uncertainty are identified and again discussed in the light of subsequent flight tests.

Cook, W. L.

Correlation of low speed wind tunnel and flight test data for V/STOL aircraft

The availability of wind tunnel test data for correlation purposes of the same V/STOL aircraft tested in flight is very limited. This is due in a large part to size limitations of wind tunnels and the number of wind tunnels available for testing of full-scale aircraft. Wind tunnel tests are described for two research aircraft - the XV-5B fan-in-wing aircraft and the YOV-10 RCF (rotating cylinder flap) aircraft - in the NASA Ames 40- by 80-foot wind tunnel. The tests were conducted specifically to provide for correlation between wind tunnel and in-flight aerodynamics and noise test data. Correlation between aerodynamic and noise data are presented and testing techniques that are related to the accuracy of the data, or that might affect the correlations, are discussed. The correlation of noise measurements made with a J-85 engine mounted on a F-106 aircraft during low altitude flyovers with the same J-85 engine mounted on a model and tested in the Ames 40- by 80-foot wind tunnel are also reported.

Cook, W. L.

Comparison of model and flight test data for an augmented jet flap STOL research aircraft

Aerodynamic design data for the Augmented Jet Flap STOL Research Aircraft or commonly known as the Augmentor-Wing Jet-STOL Research Aircraft was based on results of tests carried out on a large scale research model in the NASA Ames 40- by 80-Foot Wind Tunnel. Since the model differs in some respects from the aircraft, precise correlation between tunnel and flight test is not expected, however the major areas of confidence derived from the wind tunnel tests are delineated, and for the most part, tunnel results compare favorably with flight experience. In some areas the model tests were known to be nonrepresentative so that a degree of uncertainty remained: these areas of greater uncertainty are identified, and discussed in the light of subsequent flight tests.

Cook, W. L.

Correlation of low speed wind tunnel and flight test data for V/STOL aircraft

The XV-5B fan-in-wing aircraft and the Y0V-10 RCF rotating cylinder flap aircraft were subjected to wind tunnel tests. These tests were conducted specifically to provide for correlation between wind tunnel and inflight aerodynamics and noise test data. Correlation between aerodynamic and noise data are presented and testing techniques that are related to the accuracy of the data, or that might affect the correlations, are discussed.

Cook, W. L.

Satellite system considerations for computer data transfer

Communications satellites will play a key role in the transmission of computer generated data through nationwide networks. This paper examines critical aspects of satellite system design as they relate to the computer data transfer task. In addition, it discusses the factors influencing the choice of error control technique, modulation scheme, multiple-access mode, and satellite beam configuration based on an evaluation of system requirements for a broad range of application areas including telemetry, terminal dialog, and bulk data transmission.

Cook, W. L.

Aerodynamics of jet flap and rotating cylinder flap STOL concepts

The aerodynamic effectiveness of various propulsive lift concepts to provide for the low speed performance and control required for short takeoff and landing aircraft is discussed. The importance of the interrelationship between the propulsion system and aerodynamic components of the aircraft is stressed. The relative effectiveness of different lift concepts was evaluated through static and wind tunnel tests of various aerodynamic models and propulsion components, simulations of aircraft, and in some cases, flight testing of research aircraft incorporating the concepts under study. Results of large scale tests of lift augmentation devices are presented. The results of flight tests of STOL research aircraft with augmented jet flaps and rotating cylinder flaps are presented to show the steeper approach flight paths at low forward speeds.

Cook, W. L.

A summary of wind tunnel research on tilt-rotors from hover to cruise flight

An experimental research program conducted on a series of tilt rotors designed for a range of blades twist is reported. The test facilities used in the program are identified. The objective of the program was to obtain precise results on the influence of blades twist and aeroelasticity on tilt rotor performance from hover to high speed cruise Mach number to 0.7. Five aluminum rigid rotors and one fiber glass composite rotor were tested.

Poisson-Quinton, PH.

A summary of wind tunnel research on tilt rotors from hover to cruise flight

An experimental research program has been conducted on a series of tilt rotors designed for a range of blade twist in various wind tunnel facilities. The objective was to obtain precise results on the influence of blade twist and aeroelasticity on tilt rotor performance, from hover to high speed cruise Mach number of about 0.7. global forces on the rotor, local loads and blade torsional deflection measurements were compared with theoretical predictions inside a large Reynolds-Mach envelope. Testing techniques developed during the program are described.

Poisson-Quinton, PH.