Search NASA⌕ Search

Engineering topics

Cornelius, A L

Publications and source records attributed to Cornelius, A L.

High pressure transport characteristics of Bi[subscript 2]Te[subscript 3], Sb[subscript 2]Te[subscript 3], and BiSbTe[subscript 3]

This paper presents ambient and high pressure measurements of transport properties of the Bi2Te3-Sb2Te3 series of materials. The electrical resistivity, thermal conductivity, and Seebeck coefficient have been measured on both end compounds and the direct solid solution of the two at pressure up to 10 GPa. An additional discussion involving the high pressure structure will be presented. From this, it was determined that these materials undergo at least two structural phase transitions between 0 and 20 GPa and a discussion is presented regarding this and the changes in the transport properties.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

High-pressure structural study of fluoro-perovskite CsCdF[subscript 3] up to 60 GPa: A combined experimental and theoretical study

The structural behavior of CsCdF{sub 3} under pressure is investigated by means of theory and experiment. High-pressure powder x-ray diffraction experiments were performed up to a maximum pressure of 60 GPa using synchrotron radiation. The cubic Pm{sub 3}{sup -} m crystal symmetry persists throughout this pressure range. Electronic structure calculations were carried out using the full-potential linear muffin-tin orbital method within the local-density approximation and the generalized gradient approximation for exchange and correlation effects. The calculated ground-state properties - the equilibrium lattice constant, bulk modulus and elastic constants - are in good agreement with experimental results. The calculations reveal that CsCdF{sub 3} is an indirect-gap insulator under ambient conditions, with the gap increasing under pressure.

36 MATERIALS SCIENCE↗

High pressure structural studies on SrRuO[subscript 3]

We have performed room temperature high pressure structural studies on the ferromagnetic perovskite SrRuO{sub 3} to 34 GPa. We have also used three different pressure media (silicone fluid, 4:1 methanol:ethanol and argon) to test for possible effects of pressure media on compression data. The orthorhombic perovskite structure is stable to the highest pressure, and the data can be fit with a bulk modulus of B{sub 0} = 192(3) GPa with a pressure derivative of B{prime}{sub 0} = 5.0(3) for all of the pressure media. We have also examined the high pressure behavior of the RuO{sub 6} octahedra using a model that assumes the octahedra are not distorted. Various tilt angles around the ideal cubic perovskite axes are found and can be used to estimate the Ru-O-Ru bond angle that is known to be directly related to the ferromagnetic Curie temperature. For all pressure media, there appears to be a minimum in the Ru-O-Ru bond angle around 15 GPa. Implications for the observed high pressure magnetic behavior of SrRuO{sub 3} will be discussed.

36 MATERIALS SCIENCE↗