Engineering topics

Correa, Julia

Publications and source records attributed to Correa, Julia.

12 records

DOE OSTI2025

Continuous surface-to-distributed acoustic sensor snapshots explain reactivation of individual natural fractures during an unconventional reservoir stimulation

ABSTRACT Fiber-optic sensing technologies allow petroleum engineering teams to detect hydraulic fracture interaction with boreholes during unconventional reservoir stimulation. In combination with high-repeatability seismic sources, the same distributed acoustic sensors (DASs) enable vertical seismic profiling (VSP) of the fracture evolution away from the boreholes. We discovered clear signatures of seismic scattering on activated fractures during nine days of continuous seismic monitoring of the fracturing stages at the Austin Chalk/Eagle Ford Field Laboratory. The present study applies a novel approach for quantitative analysis of the scattering events in terms of the evolution of the geometry and elastic stiffness of individual fractures. Our characterization strategy sequentially refines the fracture models: from a stack of 1D soft layers to 3D rectangular inclusions. First, we estimate the number of fracture locations and reflectivity using a modified sparse-spike deconvolution of the stacked VSP traces. The fracture set consists of five fractures spaced by 15–30 m with a reflectivity of approximately 1%. Then, we develop a scattering integral method to refine these estimates along with an inversion of the fracture top and bottom for each monitoring vintage. We find that, initially, some of the fractures are located above the monitoring fiber with the height of approximately 100 m. Then we integrate the seismic interpretation with the low-frequency DAS and pressure and microseismic monitoring to reconstruct the activation process of the fractures. Most likely, some of the natural fractures slowly grew downward to the monitoring fiber as a result of fluid injections in the stimulated well. This led to bright strain anomalies but did not trigger seismicity. The top of the fractures remained almost constant and were limited by a lithologic boundary/stress barrier. To our knowledge, this is the first time VSP data enabled tracking of the fracture evolution with such high spatial and temporal resolution, which was previously only available for crosswell surveys and at a much smaller scale.

Glubokovskikh, Stanislav↗

DOE OSTI2024

Revealing complex subsurface dynamics with continuous seismic monitoring: Observations using distributed acoustic sensing and surface orbital vibrators during hydraulic fracturing

Understanding hydraulic fracturing is crucial to improving the stimulation of unconventional reservoirs and increasing fluid production. This study develops a novel seismic monitoring technology using distributed acoustic sensing (DAS) and surface orbital vibrators (SOV) to capture fracture seismic response and mechanical properties at high temporal intervals. We analyze continuous time-lapse vertical seismic profiling (VSP) data acquired every hour during the first nine days of treatment of an unconventional reservoir in the Austin Chalk/Eagle Field Laboratory. The VSP data contain clear seismic signals scattered from the activated fractures. The spatiotemporal changes of the fracture reflectivity revealed by the SOV/DAS data correlate well with the observations of fracture locations inferred from low-frequency DAS data. These results capture the fracture opening and closure processes, as well as highlight potential prestage activations of the fractures due to hydraulic connectivity with preexisting fracture systems. Therefore, analysis of the presented data set provides a unique opportunity to understand fracture initiation and subsequent evolution, not only in the context of unconventional resources but also in enhanced geothermal systems.

Correa, Julia↗

DOE OSTI2024

Utah FORGE 3-2417: Fiber-Optic Geophysical Monitoring of Reservoir Evolution - 2024 Annual Workshop Presentation

This is a presentation on the Fiber-Optic Geophysical Monitoring of Reservoir Evolution by Rice University, presented by Jonathan Ajo-Franklin. This video slide presentation discusses the development of an end-to-end fiber-optic sensing approach for EGS to track the (1) initial zone of fracture creation, (2) zones of connected mechanically compliant fractures, (3) zones of flowing fractures, and (4) the integration of the data into an improved THM model. This presentation was featured in the Utah FORGE R&D Annual Workshop on August 13, 2024.

15 GEOTHERMAL ENERGY↗

DOE OSTI2024

The Austin Chalk/Eagle Ford Field Laboratory (ACEFFL)

This project, led by Texas A&M University, developed a science-based field laboratory in the Austin Chalk/Eagle Ford Shale Formation to determine the stimulated reservoir volume created by the fracturing of multiple wells. Utilizing newly developed monitoring solutions, the team delivered comprehensive high-quality field data on the extent and morphologies of productive fractures created from these wells. Advanced field monitoring was complemented by laboratory testing on cores and drill cuttings, and coupled modeling for design, prediction, calibration, and code validation. The Austin Chalk/Eagle Ford Field Laboratory (ACEFFL) was hosted by SM Energy, which provided access to the wells of opportunity.

02 PETROLEUM↗

DOE OSTI2023

Utah FORGE 3-2417: Fiber-Optic Geophysical Monitoring of Reservoir Evolution - Workshop Presentation

This is a presentation on the Fiber-Optic Geophysical Monitoring of Reservoir Evolution at the Utah FORGE Milford Site project by Rice University, presented by Prof. Jonathan Ajo-Franklin. The project's objective was to develop an end-to-end fiber-optic sensing approach for EGS to track the initial zone of fracture creation, zones of connected mechanically compliant fractures, and zones of flowing fractures linking the injection/production well pair. This approach would also be used to integrate data into an improved thermo-hydro-mechanical model (THM). This presentation was featured in the Utah FORGE R&D Annual Workshop on September 8, 2023. The workshop provided a valuable opportunity to explore the progress made in each of the 17 Research and Development projects funded under Solicitation 2020-1 which aim to enhance our understanding of the crucial factors influencing the development of Enhanced Geothermal Systems (EGS) reservoirs and resources.

15 GEOTHERMAL ENERGY↗

DOE OSTI2022

Evidence of Nonlinear Seismic Effects in the Earth from Downhole Distributed Acoustic Sensors

Seismic velocities and elastic moduli of rocks are known to vary significantly with applied stress, which indicates that these materials exhibit nonlinear elasticity. Monochromatic waves in nonlinear elastic media are known to generate higher harmonics and combinational frequencies. Such effects have the potential to be used for broadening the frequency band of seismic sources, characterization of the subsurface, and safety monitoring of civil engineering infrastructure. However, knowledge on nonlinear seismic effects is still scarce, which impedes the development of their practical applications. To explore the potential of nonlinear seismology, we performed three experiments: two in the field and one in the laboratory. The first field experiment used two vibroseis sources generating signals with two different monochromatic frequencies. The second field experiment used a surface orbital vibrator with two eccentric motors working at different frequencies. In both experiments, the generated wavefield was recorded in a borehole using a fiber-optic distributed acoustic sensing cable. Both experiments showed combinational frequencies, harmonics, and other intermodulation products of the fundamental frequencies both on the surface and at depth. Laboratory experiments replicated the setup of the field test with vibroseis sources and showed similar nonlinear combinations of fundamental frequencies. Amplitudes of the nonlinear signals observed in the laboratory showed variation with the saturating fluid. These results confirm that nonlinear components of the wavefield propagate as body waves, are likely to generate within rock formations, and can be potentially used for reservoir fluid characterization.

58 GEOSCIENCES↗

DOE OSTI2022

Demonstration of Novel Monitoring Techniques for a North Dakota Carbon Capture and Storage Project

Conference paper presented at 16th International Conference on Greenhouse Gas Control Technologies (GHGT-16), Lyon, France, October 23–27, 2022. We present an overview and initial results of the novel and sustainable monitoring techniques developed by the Energy & Environmental Research Center (EERC) and its commercial partners associated with the Red Trail Energy (RTE) carbon capture and storage (CCS) project. RTE is an investor-owned 64-million-gallon dry mill ethanol production plant in Richardton, North Dakota, USA. Currently in operation as of June 2022, the RTE facility will capture 180,000 tonnes of carbon dioxide (CO 2 ) annually (>99% CO 2 ) that is otherwise emitted during the ethanol production process and inject it into the Broom Creek Formation, a deep saline aquifer, for permanent on-site geologic storage.

01 COAL, LIGNITE, AND PEAT↗

DOE OSTI2022

Monitoring, Verification, and Accounting (MVA) Strategy for a North Dakota Carbon Capture and Storage Project Integrated with Ethanol Production: Developing and Demonstrating Sustainable Monitoring Techniques

Conference presentation at American Association of Petroleum Geologists (AAPG) Carbon Capture, Utilization, and Storage (CCUS) Conference, Houston, Texas, March 28–30, 2022. An overview of the novel and sustainable monitoring techniques developed by the University of North Dakota's Energy & Environmental Research Center (EERC) and its commercial partners for the Red Trail Energy (RTE) carbon capture and storage (CCS) project.

01 COAL, LIGNITE, AND PEAT↗

DOE OSTI2021

Seismic monitoring of a small CO 2 injection using a multi-well DAS array: Operations and initial results of Stage 3 of the CO 2 CRC Otway project

Active time-lapse seismic is widely employed for monitoring CO 2 geosequestration due to its ability to track the distribution of fluids in space and time. However, standard 4D seismic monitoring suffers from several challenges, including high cost, disruption to other land uses, and, consequently, relatively large intervals between monitor surveys. Some of these challenges can be mitigated using permanently installed sources and receivers. Such an approach was tested at the CO 2 CRC Otway site by continuous offset VSP monitoring of 15,000 t of supercritical CO 2 injected into an aquifer 1,500 m deep with nine permanent seismic sources (surface orbital vibrators or SOVs) and five downhole fibre-optic receivers. This continuous monitoring is complemented by multi-well 4D VSP using a mobile vibroseis source and the same DAS receivers, which included one baseline and two monitor surveys after injection of 4,000 and 12,000 t of CO 2 . The continuous DAS-SOV monitoring detected an abrupt increase of travel times below the injection interval on the second day of injection (after injection of 300 t of CO 2 ) and tracked the growth of the areal CO 2 plume by mapping changes of reflection amplitudes. The plume is also detected by time-lapse changes of reflection amplitudes in multi-well 4D VSPs. The plume images obtained from continuous offset VSP and 4D VSP are broadly consistent with each other but with some differences due to differences in illumination, lateral variations of velocities and seismic anisotropy. Furthermore, these differences also serve as a measure of uncertainty of 4D VSP images.

4D VSP↗

DOE OSTI2021

Intelligent Monitoring Systems and Advanced Well Integrity and Mitigation

Long-term seismic monitoring of carbon capture and storage projects is needed to verify that the injected gas is safely stored in the subsurface until permanence can be assured. Conventional surface seismic monitoring techniques are usually expensive, require highly invasive surface operations, and need significant time investments on the part of personnel for both the field effort and processing the acquired data. For these reasons, permanent reservoir monitoring technologies are preferred, as they can offer a cost-effective solution for long-term monitoring. As part of the monitoring program of the Archer Daniels Midland’s large-scale injection of CO 2 in Decatur, Illinois, USA, a continuous seismic monitoring array was installed using a combination of surface orbital vibrator (SOV) sources and fiber-optic cables for distributed acoustic sensing (DAS) acquisition with the objective to build a continuous monitoring array. The aim of the presented project was to build a monitoring array and platform that integrates real-time seismic data with conventional data streams and provides continuous data analysis using dynamic computational models to deliver a comprehensive real-time assessment of subsurface conditions. It is in this context that the Intelligent Monitoring Systems and Advanced Well Integrity and Mitigation project was proposed with the objective to develop an integrated architecture that utilizes a permanent seismic monitoring network, combines the real-time geophysical and process data with reservoir flow and geomechanical models to create a comprehensive monitoring, visualization, and control system that delivers critical information for process surveillance and optimization.

54 ENVIRONMENTAL SCIENCES↗

DOE OSTI2021

An automated system for continuous monitoring of CO 2 geosequestration using multi-well offset VSP with permanent seismic sources and receivers: Stage 3 of the CO2CRC Otway Project

Time-lapse seismic is an essential tool for monitoring CO 2 injection into the subsurface but suffers from high cost and long intervals between surveys. An alternative approach is continuous monitoring using permanent sources and receivers capable of mapping CO 2 plume evolution on an almost daily basis and drastically reduce human effort, cost and survey turnaround. As part of the CO2CRC Otway project, a continuous monitoring system is employed to monitor a small (15,000 tonnes) CO 2 injection within the CO2CRC Otway Project. The permanent monitoring system employs distributed acoustic sensors (DAS) installed in boreholes as seismic receivers and seismic orbital vibrators (SOV) as seismic sources. The monitoring approach is based on vertical seismic profiling using five wells equipped with DAS cemented behind the casing and nine SOVs and is acquiring the data continuously in an autonomous manner. The data is then automatically processed on-site producing a seismic image every 2.5 days, which is then transmitted to a remote office. The data has good repeatability with NRMS of about ~10-15%.

58 GEOSCIENCES↗

DOE OSTI2020

Fibre-optic based DAS technology for Long-term Seismic Monitoring of Carbon Capture and Storage Projects

Long-term seismic monitoring of carbon capture and storage projects (CCS) is needed to verify that the injected gas is safely stored in the subsurface until permanence can be assured. Conventional surface seismic monitoring techniques are usually expensive, require highly invasive surface operations, and need significant time investments on the part of personnel for both the field effort and processing the acquired data. For these reasons, permanent reservoir monitoring (PRM) technologies are preferred, as they can offer a cost-effective solution for long-term monitoring. In this context, we have developed and trialed the use of distributed acoustic sensing (DAS) coupled to permanent rotary sources, called surface orbital vibrators (SOV), with the objective to build a continuous monitoring array for CCS projects.

47 OTHER INSTRUMENTATION↗