Engineering topics

Cotoni, Vincent

Publications and source records attributed to Cotoni, Vincent.

3 records

NASA NTRS2010

Low and High Frequency Models of Response Statistics of a Cylindrical Orthogrid Vehicle Panel to Acoustic Excitation

This presentation further develops the orthogrid vehicle panel work. Employed Hybrid Module capabilities to assess both low/mid frequency and high frequency models in the VA One simulation environment. The response estimates from three modeling approaches are compared to ground test measurements. Detailed Finite Element Model of the Test Article -Expect to capture both the global panel modes and the local pocket mode response, but at a considerable analysis expense (time & resources). A Composite Layered Construction equivalent global stiffness approximation using SEA -Expect to capture response of the global panel modes only. An SEA approximation using the Periodic Subsystem Formulation. A finite element model of a single periodic cell is used to derive the vibroacoustic properties of the entire periodic structure (modal density, radiation efficiency, etc. Expect to capture response at various locations on the panel (on the skin and on the ribs) with less analysis expense

Smith, Andrew↗

NASA NTRS2010

Experimental Validation of FE/BEM Dynamic Strain Model Under Diffuse Acoustic Field Loading

Structural finite element (FE) models naturally output displacement or acceleration response data. However, they can also be used to compute stress, internal forces, and strain response. When coupled with a boundary element model (BEM) of the fluid surrounding the structure, a fully coupled analysis can be performed. Modeling a diffuse acoustic field in the BEM fluid provides an excitation like that found when the structure is placed in a reverberation chamber. Fully coupling the structural FE model to the acoustic BEM model provides a means to predict not only the acceleration response of the panel to diffuse field loading, but also the ability to predict the dynamic stress and strain response. This type of model has been available with current predictive tools, but experimental validation of the prediction of dynamic stress or strain is difficult to find. An aluminum panel was instrumented with accelerometers and strain gages and hung in a reverberation room and subjected to a diffuse acoustic field. This paper presents the comparison of the experimental and predicted results.

Tsoi, W. Ben↗

NASA NTRS2008

Vibroacoustic Response of the NASA ACTS Spacecraft Antenna to Launch Acoustic Excitation

The Advanced Communications Technology Satellite was an experimental NASA satellite launched from the Space Shuttle Discovery. As part of the ground test program, the satellite s large, parabolic reflector antennas were exposed to a reverberant acoustic loading to simulate the launch acoustics in the Shuttle payload bay. This paper describes the modelling and analysis of the dynamic response of these large, composite spacecraft antenna structure subjected to a diffuse acoustic field excitation. Due to the broad frequency range of the excitation, different models were created to make predictions in the various frequency regimes of interest: a statistical energy analysis (SEA) model to capture the high frequency response and a hybrid finite element-statistical energy (hybrid FE-SEA) model for the low to mid-frequency responses. The strengths and limitations of each of the analytical techniques are discussed. The predictions are then compared to the measured acoustic test data and to a boundary element (BEM) model to evaluate the performance of the hybrid techniques.

Larko, Jeffrey M.↗