Search NASA⌕ Search

Engineering topics

Covert, E. E.

Publications and source records attributed to Covert, E. E..

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Report of the Presidential Commission on the Space Shuttle Challenger Accident, Volume 1

The findings of the Commission regarding the circumstances surrounding the Challenger accident are reported and recommendations for corrective action are outlined. All available mission data, subsequent tests, and wreckage analyses were reviewed and specific failure scenarios were developed. The Commission concluded that the cause of the Mission 51-L accident was the failure of the pressure seal in the aft field joint of the right solid rocket motor. The failure was due to a faulty design unacceptably sensitive to a number of factors. These factors were the effects of temperature, physical dimensions, the character of materials, the effects of reuse, processing, and the reaction of the joint to dynamic loading. In addition to analyzing the material causes of the accident, the Commission examined the chain of decisions that culminated in approval of the launch. It concluded that the decision making process was flawed in several ways including (1) failure in communication resulting in a launch decision based on incomplete and misleading information, (2) a conflict between engineering data and management judgements, and (3) a NASA management structure that permitted flight safety problems to bypass key Shuttle managers.

Rogers, W. P.↗
NASA NTRS1984

Hot wire in low Reynolds number flow

Progress reports were issued on the following experiments: (1) low Reynolds number flow phenomenon of periodic vortex shedding in the wake behind a cylinder as studied by applying the hot wire anemometer technique of flow measurement. The downstream diffusion of these shed vortices was of prime concern. An evaluation of the performance of the hot wire at low Reynolds number is also considered. (2) A brief examination of the back sections of the Wright Brothers wind tunnel circuits were conducted to establish whether or not gross flow deviations were present at corners, or turning vane regions. A calibration of the test sections was done. (3) The attractiveness of using rembedded grids for airfoil calculations modeled by the Euler equations was explored. These calculations were extended to C-type grids and then to Navier-Stokes calculations,

Kolb, M. A.↗
NASA NTRS1982

Development of closed loop roll control for magnetic balance systems

This research was undertaken with the goal of demonstrating closed loop control of the roll degree of freedom on the NASA prototype magnetic suspension and balance system at the MIT Aerophysics Laboratory, thus, showing feasibility for a roll control system for any large magnetic balance system which might be built in the future. During the research under this grant, study was directed toward the several areas of torque generation, position sensing, model construction and control system design. These effects were then integrated to produce successful closed loop operation of the analogue roll control system. This experience indicated the desirability of microprocessor control for the angular degrees of freedom.

Covert, E. E.↗
NASA NTRS1981

Research developing closed loop roll control for magnetic balance systems

Computer inputs were interfaced to the magnetic balance outputs to provide computer position control and data acquisition. The use of parameter identification of a means of determining dynamic characteristics was investigated. The thyraton and motor generator power supplies for the pitch and yaw degrees of freedom were repaired. Topics covered include: choice of a method for handling dynamic system data; applications to the magnetic balance; the computer interface; and wind tunnel tests, results, and error analysis.

Covert, E. E.↗
NASA NTRS1981

Application of superconducting coils to the NASA prototype magnetic balance

Application of superconducting coils to a general purpose magnetic balance was studied. The most suitable currently available superconducting cable for coils appears to be a bundle of many fine wires which are transposed and are mechanically confined. Sample coils were tested at central fields up to .5 Tesla, slewing rates up to 53 Tesla/ sec and frequencies up to 30 Hz. The ac losses were measured from helium boil-off and were approximately 20% higher than those calculated. Losses were dominated by hysteresis and a model for loss calculation which appears suitable for design purposes is presented along with computer listings. Combinations of two coils were also tested and interaction losses are reported. Two feasible geometries are also presented for prototype magnetic balance using superconductors.

Haldeman, C. W.↗
NASA NTRS1979

Hysteresis zone or locus - Aerodynamic of bulbous based bodies at low speeds

Experimental data are presented which seem to suggest that a well-defined hysteresis locus on bulbous based bodies at low speeds does not exist. Instead, if the experiment is repeated several times, the entire hysteresis region seems to fill with data rather than trace out a specific hysteresis locus. Data obtained on an oscillating model even at low reduced frequencies may be well defined but when applied to arbitrary motion lead to less accurate results than desired.

Covert, E. E.↗
NASA NTRS1978

Application of digital control to a magnetic model suspension and balance model

The feasibility of using a digital computer for performing the automatic control functions for a magnetic suspension and balance system (MSBS) for use with wind tunnel models was investigated. Modeling was done using both a prototype MSBS and a one dimensional magnetic balance. A microcomputer using the Intel 8080 microprocessor is described and results are given using this microprocessor to control the one dimensional balance. Hybrid simulations for one degree of freedom of the MSBS were also performed and are reported. It is concluded that use of a digital computer to control the MSBS is eminently feasible and should extend both the accuracy and utility of the system.

Luh, P. B.↗
NASA NTRS1975

Engineering education for the 1980's: A speculation

The development of a course of study is briefly examined from two points of view. The first represents the background that would seem to be needed for a fledgling engineer upon his entry into the engineering profession and would allow him to complete successfully his on-the-job training, or engineering internship as it were. The second represents that which must be provided on the basis of the students background from secondary school. It is suggested that a course of study viewed in this way is never fixed, but rather evolves continuously. A particular evolving course of study is briefly discussed.

Covert, E. E.↗
NASA NTRS1972

Recent developments in a wind tunnel magnetic balance.

A functional description of a prototype six component magnetic balance system for wind tunnel application is presented. The relationship of forces and moments on a ferromagnetic body to applied magnetic fields and gradients is shown. The method of producing the required fields in the prototype balance, its magnet arrangement and its performance are discussed. Aerodynamic data obtained with this balance on several model geometries are presented and compared with wind tunnel and ballistic range results.

Stephens, T.↗
NASA NTRS1971

Magnetic simulation of gravity.

Investigation of the feasibility of a magnetically simulated gravity that could make it possible to simulate aircraft jettison processes in a wind tunnel. It is shown that coils capable to produce a thereto suitable magnetic field configuration do exist. Circumstances are defined for which multiple jettison releases may be simulated, and an approximate calculation for the errors due to magnetic field nonuniformities is presented.

Covert, E. E.↗