Engineering topics
Crawford, Tim
Publications and source records attributed to Crawford, Tim.
Measured Correlation Between Roll-Vortex Signatures and Radar-Inferred Sea Surface Roughness
This paper presents aircraft measurements of near-surface atmospheric boundary layer roll signatures and radar-derived sea surface roughness. These data are completely coincident in space and time and this unique feature supports attempts to definitively link SAR backscatter signatures to boundary layer roll impacts. The open-ocean data were collected at an altitude of 20 in from NOAA's Long-EZ aircraft using its turbulence probe and down-looking Ka-band radar scatterometer, Several flight legs of 20-30 km were flown with a heading across the wind direction, which is also roughly perpendicular to the roll vortices. We find remarkable correlation between measured modulations in the along-wind component of wind speed and radar backscatter for the spatial scale of I to 1.5 kin. Close agreement between normalized modulation amplitudes suggests the radar-inferred surface slope variance is changing linearly with wind speed. These data were collected within 30 minutes of a RADARSAT SAR overpass where apparent boundary layer impacts of the same orientation and spatial dimension are prevalent in the SAR backscatter image. Quantitative comparison between modulations in the aircraft and satellite radar data will be discussed.
Sea Surface Slope Statistics for Intermediate and Shore Scale Ocean Waves Measured Using a Low-Altitude Aircraft
Ocean surface remote sensing techniques often rely on scattering or emission linked to shorter- scale gravity-capillary ocean wavelets. However, it is increasingly apparent that slightly longer wavelengths of O(10 to 500 cm) are vital components in the robust sea surface description needed to link varied global remote sensing data sets. This paper describes a sensor suite developed to examine sea surface slope variations in the field using an aircraft flying at very low altitude (below 30 m) and will also provide preliminary measurements detailing changes in slope characteristics versus sea state and friction velocity. Two-dimensional surface slope is measured using simultaneous range measurements from three compact short-range laser altimeters mounted in an equilateral triangle arrangement with spacing of about 1 m. In addition, all three lasers provide independent wave elevation profiles after GPS-aided correction for aircraft altitude. Laser range precision is 1 cm rms while vertical motion correction is 15 cm rms. The measurements are made along-track at approximately 1 m intervals setting the spatial scale of the measurement to cover waves of intermediate to long scale. Products available for this array then include surface elevation, two-dimensional slope distribution, and the cross- and along-track 1-D slope distributions. To complement the laser, a down-looking mm-wave radar scatterometer is centered within the laser array to measure radar backscatter simultaneously with the laser slope. The radar's footprint is nominally 1 m in diameter. Near-vertical radar backscatter is inversely proportional to the small-scale surface slope variance and to the tilt of the underlying (laser-measured) surface facet. Together the laser and radar data provide information on wave roughness from the longest scales down to about 1 cm. These measurements are complemented by aircraft turbulence probe data that provides robust surface flux information.
The search for CFC alternatives is over?
The Electronics Manufacturing Productivity Facility (EMPF) is a U.S. Navy Center of Excellence tasked to do research in electronics manufacturing. For the past seven years, the EMPF has performed extensive research in various cleaning materials and processes that have recently been made available to printed circuit board assemblers. This paper outlines our research and points out the positive and negative aspects that need to be considered when choosing an alternative process.