Search NASA⌕ Search

Engineering topics

Crombe, K

Publications and source records attributed to Crombe, K.

Self consistent radio-frequency wave propagation and peripheral direct current plasma biasing: Simplified three dimensional non-linear treatment in the 'wide sheath' asymptotic regime

A minimal two-field fluid approach is followed to describe the radio-frequency (RF) wave propagation in the bounded scrape-off layer plasma of magnetic fusion devices self-consistently with direct current (DC) biasing of this plasma. The RF and DC parts are coupled by non-linear RF and DC sheath boundary conditions at both ends of open magnetic field lines. The physical model is studied within a simplified framework featuring slow wave (SW) only and lateral walls normal to the straight confinement magnetic field. The possibility is however kept to excite the system by any realistic 2D RF field map imposed at the outer boundary of the simulation domain. The self-consistent RF + DC system is solved explicitly in the asymptotic limit when the width of the sheaths gets very large, for several configurations of the RF excitation and of the target plasma. In the case of 3D parallelepipedic geometry, semi-analytical results are proposed in terms of asymptotic waveguide eigenmodes that can easily be implemented numerically. The validity of the asymptotic treatment is discussed and is illustrated by numerical tests against a quantitative criterion expressed from the simulation parameters. Iterative improvement of the solution from the asymptotic result is also outlined. Throughout the resolution, key physical properties of the solution are presented. The radial penetration of the RF sheath voltages along lateral walls at both ends of the open magnetic field lines can be far deeper than the skin depth characteristic of the SW evanescence. This is interpreted in terms of sheath-plasma wave excitation. Therefore, the proper choice of the inner boundary location is discussed as well as the appropriate boundary conditions to apply there. The asymptotic scaling of various quantities with the amplitude of the input RF excitation is established.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Comparison of Edge and Internal Transport Barriers in Drift Wave Predictive Simulations

We have simulated the formation of an internal transport barrier on JET including a self-consistent treatment of ion and electron temperatures and poloidal and toroidal momentum.Similar simulations of edge transport barriers, including the L-H transition have also been made. However, here only poloidal momentum and the temperatures were simulated. The internal barrier included an anomalous spinup of poloidal momentum similar to that in the experiment. Also the edge barrier was accompanied by a spinup of poloidal momentum. The experimental density (with no barrier) was used and kept fixed for the internal barrier. For the edge barrier the edge density was varied and it turned out that a lower edge density gave a stronger barrier. Electromagnetic and nonlocal effects were important for both types of barriers.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Influence of Magnetic Field Ripple on the Intrinsic Rotation of Tokamak Plasmas

Using the unique capability of JET to monotonically change the amplitude of the magnetic field ripple, without modifying other relevant equilibrium conditions, the effect of the ripple on the angular rotation frequency of the plasma column was investigated under the conditions of no external momentum input. The ripple amplitude was varied from 0.08% to 1.5% in Ohmic and ion-cyclotron radio-frequency (ICRF) heated plasmas. In both cases the ripple causes counterrotation, indicating a strong torque due to nonambipolar transport of thermal ions and in the case of ICRF also fast ions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Fundamental ion cyclotron resonance heating of JET deuterium plasmas

Radio frequency heating of majority ions is of prime importance for understanding the basic role of auxiliary heating in the activated D T phase of ITER. Majority deuterium ion cyclotron resonance heating (ICRH) experiments at the fundamental cyclotron frequency were performed in JET. In spite of the poor antenna coupling at 25 MHz, this heating scheme proved promising when adopted in combination with D neutral beam injection (NBI). The effect of fundamental ICRH of a D population was clearly demonstrated in these experiments: by adding ~25% of heating power the fusion power was increased up to 30 50%, depending on the type of NBI adopted. At this power level, the ion and electron temperatures increased from Ti ~ 4.0 keV and Te ~ 4.5 keV (NBI-only phase) to Ti ~ 5.5 keV and Te ~ 5.2 keV (ICRH + NBI phase), respectively. The increase in the neutron yield was stronger when 80 keV rather than 130 keV deuterons were injected in the plasma. It is shown that the neutron rate, the diamagnetic energy and the electron as well as the ion temperature scale roughly linearly with the applied RF power. A synergistic effect of the combined use of ICRF and NBI heating was observed: (i) the number of neutron counts measured by the neutron camera during the combined ICRF + NBI phases of the discharges exceeded the sum of the individual counts of the NBI-only and ICRF-only phases; (ii) a substantial increase in the number of slowing-down beam ions was detected by the time of flight neutron spectrometer when ICRF power was switched on; (iii) a small D subpopulation with energies slightly above the NBI launch energy was detected by the neutral particle analyzer and -ray spectroscopy.

Krasilnikov, A V↗

JET (3He)-D scenarios relying on RF heating: survey of selected recent experiments

Recent JET experiments have been devoted to the study of (3He) D plasmas involving radio frequency (RF) heating. This paper starts by discussing the RF heating efficiency theoretically expected in such plasmas, covering both relevant aspects of wave and of particle dynamics. Then it gives a concise summary of the main conclusions drawn from recent experiments that were either focusing on studying RF heating physics aspects or that were adopting RF heating as a tool to study plasma behavior. Depending on the minority concentration chosen, different physical phenomena are observed. At very low concentration (X[3He] < 1%), energetic tails are formed which trigger MHD activity and result in loss of fast particles. Alfv n cascades were observed and gamma ray tomography indirectly shows the impact of sawtooth crashes on the fast particle orbits. Low concentration (X[3He] < 10%) favors minority heating while for X[3He] 10% electron mode conversion damping becomes dominant. Evidence for the Fuchs et al standing wave effect (Fuchs et al 1995 Phys. Plasmas 2 1637 47) on the absorption is presented. RF induced deuterium tails were observed in mode conversion experiments with large X[3He] (18%). As tentative modeling shows, the formation of these tails can be explained as a consequence of wave power absorption by neutral beam particles that efficiently interact with the waves well away from the cold D cyclotron resonance position as a result of their substantial Doppler shift. As both ion and electron RF power deposition profiles in (3He) D plasmas are fairly narrow giving rise to localized heat sources the RF heating method is an ideal tool for performing transport studies. Various of the experiments discussed here were done in plasmas with internal transport barriers (ITBs). ITBs are identified as regions with locally reduced diffusivity, where poloidal spinning up of the plasma is observed. The present know-how on the role of RF heating for impurity transport is also briefly summarized.

16 TIDAL AND WAVE POWER↗

Radial electric field in JET advanced tokamak scenarios with toroidal field ripple

A dedicated campaign has been run on JET to study the effect of toroidal field (TF) ripple on plasma performance. Radial electric field measurements from experiments on a series of plasmas with internal transport barriers (ITBs) and different levels of ripple amplitude are presented. They have been calculated from charge exchange measurements of impurity ion temperature, density and rotation velocity profiles, using the force balance equation. The ion temperature and the toroidal and poloidal rotation velocities are compared in plasmas with both reversed and optimized magnetic shear profiles. Poloidal rotation velocity (v ) in the ITB region is measured to be of the order of a few tens of km s 1, significantly larger than the neoclassical predictions. Increasing levels of the TF ripple are found to decrease the ion temperature gradient in the ITB region, a measure for the quality of the ITB, and the maximum value of v is reduced. The poloidal rotation term dominates in the calculations of the total radial electric field (Er), with the largest gradient in Er measured in the radial region coinciding with the ITB.

plasma h-mode↗

H-mode access on JET and Implications for ITER

One of the critical issues for ITER is access to an H-mode regime with good confinement, H98 = 1. The most basic scaling laws for power threshold for the L H transition, Pth, take the variation with plasma density, magnetic field and plasma size into account. However, the large variations in the Pth data from the values estimated with such simple scaling laws indicate other underlying dependencies. Another important consideration for ITER is that H-modes with higher values of energy confinement factors are often obtained with input power values much greater than Pth. This paper presents results from recent studies on JET to assess possible hidden variables for H-mode access over a wide range of plasma conditions. Experimental results demonstrate that sensitivity to the magnetic shaping and divertor geometry could account for some of the scatter in the international power threshold database. Hysteresis in the L H transition Pth has been studied in detail for the first time on JET by comparing values of Pth at the forward and back H-mode transitions over a range of densities. The impact of the edge plasma rotation on H-mode access has also been considered on JET with a toroidal field ripple scan across the L H and H L transitions. Finally, the total input power required relative to the measured value of Pth for access to a steady-state H-mode with H98 = 1 has been examined for a highly shaped magnetic configuration. The implications of these results for the attainment of H-mode with good confinement on ITER are discussed.

plasma h-mode↗