Engineering topics

Crossman, G. R.

Publications and source records attributed to Crossman, G. R..

5 records

NASA NTRS1979

Torque requirement of rotating rods in airflow

Experiments were performed to determine the torque required for rotating a rotor disk fitted with a number of radially arranged rods placed into a ducted airflow. An array of stationary rods, also radially arranged, was placed upstream close to the rotor with a small gap between the rods to cause wake interference. The results show that torque generally increased with airflow and the rate of increase varied considerably. At lower values of airflow, the rate of increase was larger than at higher airflow, and definite torque peaks occurred at certain airflow rates, where the torque attained a maximum within the test airflow range. During the test, a maximum blade passage frequency of 2037 Hz was attained. The results also show that the torque peaks occurred at the same Strouhal number for all speeds.

Barna, P. S.↗

NASA NTRS1976

Experimental studies on the aerodynamic performance and dynamic response of flow direction sensing vanes

Systematic investigations were performed on a variety of aerodynamic surfaces to obtain their potential for possible application to wind vanes. Among the surfaces tested were: (1) single vanes consisting of flat plates of various planforms having aspect ratios between 0.5 and 5; (2) bi-vanes with aspect ratio 2.5; (3) various cone and box vanes; and (4) various cruciform configurations. The models were subjected to windtunnel tests. In addition to lift and drag force measurements, damping and frequency test were performed under a variety of flow conditions.

Barna, P. S.↗

NASA NTRS1974

Power requirement of rotating rods in airflow

Experiments were performed to determine the power required for rotating a rotor disc fitted with a number of radially arranged rods placed into a ducted airflow. An array of stationary rods, also radially arranged, were placed upstream close to the rotor with a small gap between the rods to cause wake interference. The results show that power increased with increasing airflow and the rate of increase varied considerably. At lower values of airflow the rate of increase was larger than at higher airflow and definite power peaks occurred at certain airflow rates, where the power attained a maximum within the test airflow range. During the test a maximum blade passage frequency of 2037 Hz was attained.

Barna, P. S.↗

NASA NTRS1974

Fast response vanes for sensing flow patterns in helicopter rotor environment

Wind tunnel experiments were conducted on four small-scale flow-direction vanes for the determination of aerodynamic response. The tests were further extended to include a standard sized low-inertia vane currently employed in aircraft flight testing. The four test vanes had different aspect ratios and were about 35 percent of the surface area of the standard vane. The test results indicate satisfactory damping and frequency response for all vanes tested and compare favorably with the standard design.

Barna, P. S.↗

NASA NTRS1972

Catalytic considerations in temperature measurement.

Literature discussing catalytic activity in platinum group temperature sensors is surveyed. Methods for the determination and/or elimination of catalytic activity are reported. A particular application of the literature is discussed in which it is possible to infer that a shielded platinum total temperature probe does not experience significant catalytic activity in the wake of a supersonic hydrogen burner, while a bare iridium plus rhodium, iridium thermocouple does. It is concluded that catalytic data corrections are restricted and that it is preferable to coat the temperature sensor with a noncatalytic coating. Furthermore, the desirability of transparent coatings is discussed.

Ash, R. L.↗