Search NASA⌕ Search

Engineering topics

Cuddihy, E.

Publications and source records attributed to Cuddihy, E..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1998

Constitutive Modeling of the Mechanical Properties of Optical Fibers

Micromechanical modeling of the composite mechanical properties of optical fibers was conducted. Good agreement was obtained between the values of Young's modulus obtained by micromechanics modeling and those determined experimentally for a single mode optical fiber where the wave guide and the jacket are physically coupled. The modeling was also attempted on a polarization-maintaining optical fiber (PANDA) where the wave guide and the jacket are physically decoupled, and found not to applicable since the modeling required perfect bonding at the interface. The modeling utilized constituent physical properties such as the Young's modulus, Poisson's ratio, and shear modulus to establish bounds on the macroscopic behavior of the fiber.

Moeti, L.↗
NASA NTRS1996

Mechanical Properties of Irradiated Polarization-Maintaining Optical Fibers

Polarization-maintaining optical fibers, referred to as PANDA fibers, were subjected to Cobalt 60 radiation (300,000 Rad). The mechanical properties of the PANDA fibers were measured after exposure to gamma radiation and compared to non-irradiated PANDA fibers.

optical fibers irradiated fibers PANDA fibers pola↗
NASA NTRS1986

Flat-plate solar array project. Volume 7: Module encapsulation

The objective of the Encapsulation Task was to develop, demonstrate, and qualify photovoltaic (PV) module encapsulation systems that would provide 20 year (later decreased to 30 year) life expectancies in terrestrial environments, and which would be compatible with the cost and performance goals of the Flat-Plate Solar Array (FSA) Project. The scope of the Encapsulation Task included the identification, development, and evaluation of material systems and configurations required to support and protect the optically and electrically active solar cell circuit components in the PV module operating environment. Encapsulation material technologies summarized include the development of low cost ultraviolet protection techniques, stable low cost pottants, soiling resistant coatings, electrical isolation criteria, processes for optimum interface bonding, and analytical and experimental tools for evaluating the long term durability and structural adequacy of encapsulated modules. Field testing, accelerated stress testing, and design studies have demonstrated that encapsulation materials, processes, and configurations are available that meet the FSA cost and performance goals.

Cuddihy, E.↗
NASA NTRS1982

Photovoltaic module encapsulation design and materials selection, volume 1

Encapsulation material system requirements, material selection criteria, and the status and properties of encapsulation materials and processes available are presented. Technical and economic goals established for photovoltaic modules and encapsulation systems and their status are described. Available encapsulation technology and data are presented to facilitate design and material selection for silicon flat plate photovoltaic modules, using the best materials available and processes optimized for specific power applications and geographic sites. The operational and environmental loads that encapsulation system functional requirements and candidate design concepts and materials that are identified to have the best potential to meet the cost and performance goals for the flat plate solar array project are described. Available data on encapsulant material properties, fabrication processing, and module life and durability characteristics are presented.

Cuddihy, E.↗
NASA NTRS1976

Material and design considerations of encapsulants for photovoltaic arrays in terrestrial applications

Procedures for analyzing cyclic mechanical stresses in encapsulated photovoltaic arrays designed for terrestrial application are discussed. The concept of 'thermal stiffness', the product of alpha and Young's modulus, is presented, and its usefulness for minimizing mechanical stresses is demonstrated. The concept of the 'proportional-limit' helps indicate the upper limit of design stress for plastics. System design is considered with attention to cell dimensions, cell to substrate adhesive, single encapsulant system, double layer encapsulant, and stresses in the interconnects. The permeability of polymeric materials to gases is examined.

Carroll, W.↗