Search NASA⌕ Search

Engineering topics

Culbertson, Philip, Jr.

Publications and source records attributed to Culbertson, Philip, Jr..

Docking Fixture and Mechanism for a Protective Suit

A suitlock assembly that comprises a docking fixture and mechanism has been invented to facilitate and accelerate donning and doffing of a sealed protective suit and/or to enable ingress and egress between the protective suit and a sealed vessel. The sealed protective suit could be a space suit, in which case the sealed vessel could be a spacecraft. Alternatively, the sealed suit could be an environmental protective suit of a type worn on Earth during cleanup of a hazardous-material site, in which case the sealed vessel could be a vehicle equipped to maintain a safe interior environment for workers in transit to and from the site. Figure 1 depicts a typical situation in which several crewmembers are working inside such a vehicle, one is working outside in a protective suit, and one is donning or doffing a protective suit while holding onto an overhead bar for support.

Culbertson, Philip, Jr.↗

Suitlock Docking Mechanism

An environmental protective suit used for hazardous clean-up or space applications includes a suitlock docking mechanism that allows for easy egress and ingress of a crew member between a sealed vessel and a possibly contaminated environment. The suitlock docking mechanism comprises a single actuator that controls latches which, in turn, respectfully control rack and pinion assemblies that allow for easy removal and attachment of a life support equipment enclosure shell to the environmental protective suit or to the vehicle from which the operator performs his/her duties.

Culbertson, Philip, Jr.↗

AX-5 space suit bearing torque investigation

The symptoms and eventual resolution of a torque increase problem occurring with ball bearings in the joints of the AX-5 space suit are described. Starting torques that rose 5 to 10 times initial levels were observed in crew evaluation tests of the suit in a zero-g water tank. This bearing problem was identified as a blocking torque anomaly, observed previously in oscillatory gimbal bearings. A large matrix of lubricants, ball separator designs and materials were evaluated. None of these combinations showed sufficient tolerance to lubricant washout when repeatedly cycled in water. The problem was resolved by retrofitting a pressure compensated, water exclusion seal to the outboard side of the bearing cavity. The symptoms and possible remedies to blocking are discussed.

Loewenthal, Stuart↗