Engineering topics

Cull, Ronald C.

Publications and source records attributed to Cull, Ronald C..

15 records

NASA NTRS1994

Method of locating ground faults

The present invention discloses a method of detecting and locating current imbalances such as ground faults in multiwire systems using the Faraday effect. As an example, for 2-wire or 3-wire (1 ground wire) electrical systems, light is transmitted along an optical path which is exposed to magnetic fields produced by currents flowing in the hot and neutral wires. The rotations produced by these two magnetic fields cancel each other, therefore light on the optical path does not read the effect of either. However, when a ground fault occurs, the optical path is exposed to a net Faraday effect rotation due to the current imbalance thereby exposing the ground fault.

Patterson, Richard L.↗

NASA NTRS1992

Electromagnetic powered vehicles (EMPV) for Mars exploration

Microwave power beamed down from a Mars synchronous nuclear reactor power source to a rectifying antenna on a Mars rover is examined and compared to isotope, reactor, or photovoltaic systems as a power source to move a rover. Large ranges and higher power levels are possible with this microwave powered concept. The advantage of using higher frequencies, in the range of 500 to 1000 GHz, is examined and found to be substantial.

Christian, Jose L., Jr.↗

NASA NTRS1992

Integrated solar power satellites: An approach to low-mass space power

Previous concepts for solar power satellites have used conventional-technology photovoltaic arrays, feeding a power collection and transmission system connected to microwave tubes for direct current to radio frequency DC to RF conversion, which in turn are coupled to a phased array antenna. This paper proposes using thin-film photovoltaics with an integrated solid-state phased-array to design an ultra-lightweight solar power satellite. The status of the enabling technologies, conceptual designs, possible applications, and development steps are discussed. It is found that as these technologies evolve, their use in this design results in a potential reduction in weight by a factor of ten to a hundred over conventional concepts for solar power satellites, and increases the utility by allowing service to smaller receivers at multiple receiving sites.

Landis, Geoffrey A.↗

NASA NTRS1991

Enabling the space exploration initiative: NASA's exploration technology program in space power

Space power requirements for Space Exploration Initiative (SEI) are reviewed, including the results of a NASA 90-day study and reports by the National Research Council, the American Institute of Aeronautics and Astronautics (AIAA), NASA, the Advisory Committee on the Future of the U.S. Space Program, and the Synthesis Group. The space power requirements for the SEI robotic missions, lunar spacecraft, Mars spacecraft, and human missions are summarized. Planning for exploration technology is addressed, including photovoltaic, chemical and thermal energy conversion; high-capacity power; power and thermal management for the surface, Earth-orbiting platform and spacecraft; laser power beaming; and mobile surface systems.

Bennett, Gary L.↗

NASA NTRS1991

Enabling the Space Exploration Initiative - NASA's Exploration Technology Program in space power

Space power requirements for SEI are reviewed, including the results of a NASA 90-day study and reports by the National Research Council, AIAA, NASA, the Advisory Committee on the Future of the U.S. Space Program, and the Synthesis Group. The space power requirements for the SEI robotic missions, lunar spacecraft, Mars spacecraft, and human missions are summarized. Planning for the exploration technology is addressed, including: photovoltaic, chemical, and thermal energy conversion; power management; thermal management; space nuclear power; high-capacity power; power and thermal management for the surface, earth-orbiting platform, and spacecraft; laser power beaming; and mobile surface systems.

Bennett, Gary L.↗

NASA NTRS1991

Issues and status of power distribution options for space exploration

The Space Exploration Initiative (SEI) will need a wide variety of manned systems with requirements significantly different than those for existing systems. The concept of a space power utility is discussed and the impact of this concept on the engineering of space power systems is examined. Almost all existing space power systems use low voltage direct current. Although they have been very succesful, increasing power system requirements in recent years have exposed their inherent limitations and led to the proposal of a number of alternatives including high voltage DC and AC at various frequencies. Drawing on the experience gained from Space Station Freedom and SEI systems studies, factors that may affect the choice of frequency standards on which to build such a space power utility are discussed.

Bercaw, Robert W.↗

NASA NTRS1991

Electrical system options for space exploration

The need for a space power utility concept is discussed and the impact of this concept on the engineering of space power systems is examined. Experiences gained from Space Station Freedom and SEI systems studies are used to discuss the factors that may affect the choice of frequency standards on which to build such a space power utility. Emphasis is given to electrical power control, conditioning, and distribution subsystems.

Bercaw, Robert W.↗

NASA NTRS1991

A mass sensitivity analysis of lunar orbiting beam power systems

At NASA Lewis Research Center, the feasibility of beaming power from orbiting satellites to the surface of the moon was studied. Reference microwave and laser beam power concepts were found to be 1/3 to 1/6 the mass of surface solar systems. Further analysis was performed to determine the sensitivity of the reference concepts to technology performance levels and mission architecture scenarios, such as beaming to multiple surface sites and lunar rovers. Previous studies concluded that frequencies above 35 GHz for the microwave systems were not critical for reducing the main base mass; however, when multiple sites and rovers are considered, this may become necessary. In addition, for the laser system, the pointing accuracy of the satellites becomes a critical factor for rover applications. These issues and other important results of the parametric studies, are discussed.

Stavnes, Mark W.↗

NASA NTRS1990

Applications of thin film technology toward a low-mass solar power satellite

Previous concepts for solar power satellites have used conventional-technology photovoltaics and microwave tubes. The authors propose using thin film photovoltaics and an integrated solid state phased array to design an ultra-lightweight solar power satellite, resulting in a potential reduction in weight by a factor of ten to a hundred over conventional concepts for solar power satellites.

Landis, Geoffrey A.↗

NASA NTRS1990

Lunar orbiting microwave beam power system

A microwave beam power system using lunar orbiting solar powered satellite(s) and surface rectenna(s) was investigated as a possible energy source for the Moon's surface. The concept has the potential of reduced system mass by placing the power source in orbit. This can greatly reduce and/or eliminate the 14 day energy storage requirement of a lunar surface solar system. Also propellants required to de-orbit to the surface are greatly reduced. To determine the practicality of the concept and the most important factors, a zero-th order feasibility analysis was performed. Three different operational scenarios employing state of the art technology and forecasts for two different sets of advanced technologies were investigated. To reduce the complexity of the problem, satellite(s) were assumed in circular equatorial orbits around the Moon, supplying continuous power to a single equatorial base through a fixed horizontal rectenna on the surface. State of the art technology yielded specific masses greater than 2500 kg/kw, well above projections for surface systems. Using advanced technologies the specific masses are on the order of 100 kg/kw which is within the range of projections for surface nuclear (20 kg/kw) and solar systems (500 kg/kw). Further studies examining optimization of the scenarios, other technologies such as lasers transmitters and nuclear sources, and operational issues such as logistics, maintenance and support are being carried out to support the Space Exploration Initiative (SEI) to the Moon and Mars.

Fay, Edgar H.↗

NASA NTRS1990

An analysis of space power system masses

Various space electrical power system masses are analyzed with particular emphasis on the power management and distribution (PMAD) portion. The electrical power system (EPS) is divided into functional blocks: source, interconnection, storage, transmission, distribution, system control and load. The PMAD subsystem is defined as all the blocks between the source, storage and load, plus the power conditioning equipment required for the source, storage and load. The EPS mass of a wide range of spacecraft is then classified as source, storage or PMAD and tabulated in a database. The intent of the database is to serve as a reference source for PMAD masses of existing and in-design spacecraft. The PMAD masses in the database range from 40 kg/kW to 183 kg/kW across the spacecraft systems studied. Factors influencing the power system mass are identified. These include the total spacecraft power requirements, total amount of load capacity and physical size of the spacecraft. It is found that a new utility class of power systems, represented by Space Station Freedom, is evolving.

Kenny, Barbara H.↗

NASA NTRS1990

An analysis of space power system masses

Kenny, Barbara H.↗

NASA NTRS1990

Lunar orbiting microwave beam power system

A microwave-beam power system using lunar orbiting solar-powered satellite(s) and surface rectenna(s) is investigated as a possible energy source for the moon's surface. The concept has the potential of achieving reduced system mass by placing the power source in orbit. This can greatly reduce and/or eliminate the 14-d energy storage requirement of a lunar surface solar system. Also, propellants required to de-orbit to the surface are greatly reduced. To determine the practicality of the concept and the most important factors, a zeroth-order feasibility analysis is performed. Three different operation scenarios employing state of the art technology and forecasts for two different sets of advanced technologies are investigated. To reduce the complexity of the problem, satellite(s) are assumed to be in circular equatorial orbits around the moon, supplying continuous power to a single equatorial base through a fixed horizontal rectenna on the surface. State of the art technology yields specific masses greater than 2500 kg/kw, well above projections for surface systems. The specific masses are on the order of 100 kg/kW using advanced technologies, which is within the range of projections for surface nuclear (20 kg/kW) and solar systems (500 kg/kW). Further studies examining optimization of the scenarios, other technologies, such as laser transmitters and nuclear sources, and operational issues, such as logistics, maintenance, and support, are being carried out to support the Space Exploration Initiative (SEI) to the moon and Mars.

Fay, Edgar H.↗

NASA NTRS1989

Power for the moon: Is microwave power beaming an option?

Microwave power beaming options for powering lunar bases are presented in viewgraph form. Information is given on power dependent system masses, a solar source beam power system, a nuclear source beam power system, a three satellite beam power system, antenna configurations, and antenna design.

Cull, Ronald C.↗

NASA NTRS1988

A role for high frequency superconducting devices in free space power transmission systems

Major advances in space power technology are being made in photovoltaic, solar thermal, and nuclear systems. Despite these advances, the power systems required by the energy and power intensive mission of the future will be massive due to the large collecting surfaces, large thermal management systems, and heavy shielding. Reducing this mass on board the space vehicle can result in significant benefits because of the high cost of transporting and moving mass about in space. An approach to this problem is beaming the power from a point where the massiveness of the power plant is not such a major concern. The viability of such an approach was already investigated. Efficient microwave power beam transmission at 2.45 GHz was demonstrated over short range. Higher frequencies are desired for efficient transmission over several hundred or thousand kilometers in space. Superconducting DC-RF conversion as well as RF-DC conversion offers exciting possibilities. Multivoltage power conditioning for multicavity high power RF tubes could be eliminated since only low voltages are required for Josephson junctions. Small, high efficiency receivers may be possible using the reverse Josephson effects. A conceptual receiving antenna design using superconducting devices to determine possible system operating efficiency is assessed. If realized, these preliminary assessments indicate a role for superconducting devices in millimeter and submillimeter free space power transmission systems.

Christian, Jose L., Jr.↗