Engineering topics

Cullers, D. K.

Publications and source records attributed to Cullers, D. K..

8 records

NASA NTRS1996

A matched filter method for ground-based sub-noise detection of terrestrial extrasolar planets in eclipsing binaries: application to CM Draconis

The photometric detection of extrasolar planets by transits in eclipsing binary systems can be significantly improved by cross-correlating the observational light curves with synthetic models of possible planetary transit features, essentially a matched filter approach. We demonstrate the utility and application of this transit detection algorithm for ground-based detections of terrestrial-sized (Earth-to-Neptune radii) extrasolar planets in the dwarf M-star eclipsing binary system CM Draconis. Preliminary photometric observational data of this system demonstrate that the observational noise is well characterized as white and Gaussian at the observational time steps required for precision photometric measurements. Depending on planet formation scenarios, terrestrial-sized planets may form quite close to this low-luminosity system. We demonstrate, for example, that planets as small as 1.4 Earth radii with periods on the order of a few months in the CM Draconis system could be detected at the 99.9% confidence level in less than a year using 1-m class telescopes from the ground. This result contradicts commonly held assumptions limiting present ground-based efforts to, at best, detections of gas giant planets after several years of observation. This method can be readily extended to a number of other larger star systems with the utilization of larger telescopes and longer observing times. Its extension to spacecraft observations should also allow the determination of the presence of terrestrial-sized planets in nearly 100 other known eclipsing binary systems.

NASA Discipline Number 52-10↗

NASA NTRS1991

Gas chromatographic concepts for the analysis of planetary atmospheres

Over the last few years, new gas chromatographic (GC) concepts were developed for use on board spacecraft or any other restricted environments for determining the chemical composition of the atmosphere and surface material of various planetary bodies. Future NASA Missions include an entry probe that will be sent to Titan and various spacecraft that will land on Mars. In order to be able to properly respond to the mission science requirements and physical restrictions imposed on the instruments by these missions, GC analytical techniques are being developed. Some of these techniques include hardware and mathematical techniques that will improve GC sensitivity and increase the sampling rate of a GC descending through a planetary atmosphere. The technique of Multiplex Gas Chromatography (MGC) is an example of a technique that was studied in a simulated Titan atmosphere. In such an environment, the atmospheric pressure at instrument deployment is estimated to be a few torr. Thus, at such pressures, the small amount of sample that is acquired might not be enough to satisfy the detection requirements of the gas chromatograph. In MGC, many samples are pseudo-randomly introduced to the chromatograph without regard to elution of preceding components. The resulting data is then reduced using mathematical techniques such as cross-correlation of Fourier Transforms. Advantages realized from this technique include: improvement in detection limits of several orders of magnitude and increase in the number of analyses that can be conducted in a given period of time. Results proving the application of MGC at very low pressures emulating the same atmospheric pressures that a Titan Probe will encounter when the instruments are deployed are presented. The sample used contained hydrocarbons that are expected to be found in Titan's atmosphere. In addition, a new selective modulator was developed to monitor water under Martian atmospheric conditions. Since this modulator is selective only to water, the need for a GC column is eliminated. This results in further simplification of the instrument.

Valentin, J. R.↗

NASA NTRS1991

Computational problems and signal processing in SETI

The Search for Extraterrestrial Intelligence (SETI), currently being planned at NASA, will require that an enormous amount of data (on the order of 10 exp 11 distinct signal paths for a typical observation) be analyzed in real time by special-purpose hardware. Even though the SETI system design is not based on maximum entropy and Bayesian methods (partly due to the real-time processing constraint), it is expected that enough data will be saved to be able to apply these and other methods off line where computational complexity is not an overriding issue. Interesting computational problems that relate directly to the system design for processing such an enormous amount of data have emerged. Some of these problems are discussed, along with the current status on their solution.

Deans, Stanley R.↗

NASA NTRS1986

Sensitive detection of narrowband pulses

Highly monochromatic signals, such as TV carriers, can be detected sensitively by using a narrow filter (b < or = 1 Hz) and performing power accumulation on its output. If instead a low-duty-cycle pulsed signal of the same total energy is present, the sensitivity of a square law device, followed by a thresholding operation (to eliminate most samples containing only noise), followed by the algorithm to be described, is greater by about 7 dB in typical cases. This is particularly interesting to SETI because such a pulsed signal is exactly what is sent by a rotating beacon with a directional antenna. Such a pulsed signal is, therefore, a good candidate for an extraterrestrial beacon. Software for detecting this signal type is now ready for field testing with the NASA Multichannel Spectrum Analyzer (MCSA).

NASA Discipline Number 52-60↗

NASA NTRS1985

Signal processing in SETI

It is believed that the Galaxy might contain ten billion potential life sites. In view of the physical inaccessibility of extraterrestrial life on account of the vast distances involved, a logical first step in a search for extraterrestrial intelligence (SETI) appears to be an attempt to detect signals already being radiated. The characteristics of the signals to be expected are discussed together with the search strategy of a NASA program. It is pointed out that all presently planned searches will use existing radio-astronomy antennas. If no extraterrestrial intelligence signals are discovered, society will have to decide whether SETI justifies a dedicated facility of much greater collecting area. Attention is given to a multichannel spectrum analyzer, CW signal detection, pulse detection, the pattern detector, and details of SETI system operation.

Cullers, D. K.↗

NASA NTRS1985

Software implementation of detection algorithms for the MCSA

The NASA Multichannel Spectrum Analyzer supplies data in several formats and in a wide range of frequency resolutions. To decide if an extraterrestrial signal is present, this data is searched using detection algorithms particularly sensitive to signals concentrated in frequency and/or time. The algorithms, whose ultimate sensitivities are determined by theoretical considerations, are also constrained by available computing power. At present, practical detection of repetitive pulses is possible at an average power about five times lower than that for incoherent CW detection. After a period of field testing, the best detection algorithms, presently implelmented in software, will be converted to hardware to increase their speed.

Cullers, D. K.↗

NASA NTRS1984

Sensitive detection of narrowband signals

It is pointed out that an effective search for extraterrestrial intelligence (SETI) presents a signal processing task with unusual requirements. In the first place, algorithms with a very low false alarm probability are needed. This implies, that the interpretation of noise as a signal must be rare. Secondly in a SETI, attention must be given to signals having narrow-band or pulsed features. Theoretical considerations are discussed along with aspects of pulse detector motivation, independent pulse trains and the false alarm rate, and software considerations.

Cullers, D. K.↗

NASA NTRS1977

The large-scale ionospheric electric field - Its variation with magnetic activity and relation to terrestrial kilometric radiation

Four days of simultaneous auroral zone electric field measurements on balloons flown from six sites spanning 180 deg of magnetic longitude have been analyzed. The average electric field behavior during this magnetically quiet epoch is consistent with earlier single-point measurements, although the average auroral zone electric field was more affected by corotation effects than it was during more disturbed times. When these data, which primarily reflect the large-scale (several hundred kilometer) ionospheric electric field, are mapped to the equator, a steady dawn to dusk component is apparent only on the average, while instantaneously the field is quite variable. The ionospheric electric field during isolated substorms is shown to have differing signatures east and west of 2200 LT. A worldwide positive correlation is shown to exist between the auroral zone electric field strength and the intensity of terrestrial kilometric radiation.

Holzworth, R. H.↗