Engineering topics

Cutler, Andrew Hall

Publications and source records attributed to Cutler, Andrew Hall.

3 records

NASA NTRS1992

Aluminum-fueled rockets for the space transportation system

Aluminum-fueled engines, used to propel orbital transfer vehicles (OTV's), offer benefits to the Space Transportation System (STS) if scrap aluminum can be scavenged at a reasonable cost. Aluminum scavenged from Space Shuttle external tanks could replace propellants hauled from Earth, thus allowing more payloads to be sent to their final destinations at the same Shuttle launch rate. To allow OTV use of aluminum fuel, two new items would be required: a facility to reprocess aluminum from external tanks and an engine for the OTV which could burn aluminum. Design of the orbital transfer vehicle would have to differ substantially from current concepts for it to carry and use the aluminum fuel. The aluminum reprocessing facility would probably have a mass of under 15 metric tons and would probably cost less that $200,000,000. Development of an aluminum-burning engine would no doubt be extremely expensive (1 to 2 billion dollars), but this amount would be adequately repaid by increased STS throughput. Engine production cost is difficult to estimate, but even an extremely high cost (e.g., $250,000,000 per engine) would not significantly increase orbit-raising expenses.

Cutler, Andrew Hall↗

NASA NTRS1992

Tethers

A tether of sufficient strength, capable of being lengthened or shortened and having appropriate apparatuses for capturing and releasing bodies at its ends, may be useful in propulsion applications. For example, a tether could allow rendezvous between spacecraft in substantially different orbits without using propellant. A tether could also allow co-orbiting spacecraft to exchange momentum and separate. Thus, a reentering spacecraft (such as the Shuttle) could give its momentum to one remaining on orbit (such as the space station). Similarly, a tether facility could gain momentum from a high I(sub sp)/low thrust mechanism (which could be an electrodynamics tether) and transfer than momentum by means of a tether to payloads headed for many different orbits. Such a facility would, in effect, combine high I(sub sp) with high thrust, although only briefly. An electrodynamic tether could propel a satellite from its launch inclination to a higher or lower inclination. Tethers could also allow samples to be taken from bodies such as the Moon. Three types of tether operations are illustrated. The following topics are discussed: (1) tether characteristics; (2) tether propulsion methods--basics, via momentum transfer, and electrodynamic tether propulsion; and (3) their use in planetary exploration.

Cutler, Andrew Hall↗

NASA NTRS1991

Comparative economics of space resource utilization

Physical economic factors such as mass payback ratio, total payback ratio, and capital payback time are discussed and used to compare the economics of using resources from the Moon, Mars and its moons, and near Earth asteroids to serve certain near term markets such as propellant in low Earth orbit or launched mass reduction for lunar and Martian exploration. Methods for accounting for the time cost of money in simple figures of merit such as MPRs are explored and applied to comparisons such as those between lunar, Martian, and asteroidal resources. Methods for trading off capital and operating costs to compare schemes with substantially different capital to operating cost ratio are presented and discussed. Areas where further research or engineering would be extremely useful in reducing economic uncertainty are identified, as are areas where economic merit is highly sensitive to engineering performance - as well as areas where such sensitivity is surprisingly low.

Cutler, Andrew Hall↗