Search NASA⌕ Search

Engineering topics

D'Addario, Larry R.

Publications and source records attributed to D'Addario, Larry R..

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2016

An Integrated Circuit for Radio Astronomy Correlators Supporting Large Arrays of Antennas

Radio telescopes that employ arrays of many antennas are in operation, and ever larger ones are being designed and proposed. Signals from the antennas are combined by cross-correlation. While the cost of most components of the telescope is proportional to the number of antennas N, the cost and power consumption of cross-correlationare proportional to N2 and dominate at sufficiently large N. Here we report the design of an integrated circuit (IC) that performs digital cross-correlations for arbitrarily many antennas in a power-efficient way. It uses an intrinsically low-power architecture in which the movement of data between devices is minimized. In a large system, each IC performs correlations for all pairs of antennas but for a portion of the telescope's bandwidth (the so-called "FX" structure). In our design, the correlations are performed in an array of 4096 complex multiply-accumulate (CMAC) units. This is sufficient to perform all correlations in parallel for 64 signals (N=32 antennas with 2 opposite-polarization signals per antenna). When N is larger, the input data are buffered in an on-chipmemory and the CMACs are re-used as many times as needed to compute all correlations. The design has been synthesized and simulated so as to obtain accurate estimates of the IC's size and power consumption. It isintended for fabrication in a 32 nm silicon-on-insulator process, where it will require less than 12mm2 of silicon area and achieve an energy efficiency of 1.76 to 3.3 pJ per CMAC operation, depending on the number of antennas. Operation has been analyzed in detail up to N = 4096. The system-level energy efficiency, including board-levelI/O, power supplies, and controls, is expected to be 5 to 7 pJ per CMAC operation. Existing correlators for the JVLA (N = 32) and ALMA (N = 64) telescopes achieve about 5000 pJ and 1000 pJ respectively usingapplication-specific ICs in older technologies. To our knowledge, the largest-N existing correlator is LEDA atN = 256; it uses GPUs built in 28 nm technology and achieves about 1000 pJ. Correlators being designed for the SKA telescopes (N = 128 and N = 512) using FPGAs in 16nm technology are predicted to achieve about 100 pJ.

ASIC↗
NASA NTRS2016

A Low-Power Correlator ASIC for Arrays with Many Antennas

We report the design of a new application-specific integrated circuit (ASIC) for use in radio telescope correlators. It supports the construction of correlators for an arbitrarily large number of signals. The ASIC uses an intrinsically low-power architecture along with design techniques and a process that together result in unprecedentedly low power consumption. The design is flexible in that it can support telescopes with almost any number of antennas N. It is intended for use in an "FX" correlator, where a uniform filter bank breaks each signal into separate frequency channels prior to correlation.

radio telescopes↗
NASA NTRS2011

Achieving Exact and Constant Turnaround Ratio in a DDS-Based Coherent Transponder

A report describes a non-standard direct digital synthesizer (DDS) implementation that can be used as part of a coherent transponder so as to allow any rational turnaround ratio to be exactly achieved and maintained while the received frequency varies. (A coherent transponder is a receiver-transmitter in which the transmitted carrier is locked to a pre-determined multiple of the received carrier's frequency and phase. That multiple is called the turnaround ratio.) The report also describes a general model for coherent transponders that are partly digital. A partially digital transponder is one in which analog signal processing is used to convert the signals between high frequencies at which they are radiated and relatively low frequencies at which they are converted to or from digital form, with most of the complex processing performed digitally. There is a variety of possible architectures for such a transponder, and different ones can be selected by choosing different parameter values in the general model. Such a transponder uses a DDS to create a low-frequency quasi-sinusoidal signal that tracks the received carrier s phase, and another DDS to generate an IF or near-baseband version of the transmitted carrier. With conventional DDS implementations, a given turnaround ratio can be achieved only approximately, and the error varies slightly as the received frequency changes. The non-conventional implementation employed here allows any rational turnaround ratio to be exactly maintained.

D'Addario, Larry R.↗
NASA NTRS2011

Low-Power Architectures for Large Radio Astronomy Correlators

The architecture of a cross-correlator for a synthesis radio telescope with N greater than 1000 antennas is studied with the objective of minimizing power consumption. It is found that the optimum architecture minimizes memory operations, and this implies preference for a matrix structure over a pipeline structure and avoiding the use of memory banks as accumulation registers when sharing multiply-accumulators among baselines. A straw-man design for N = 2000 and bandwidth of 1 GHz, based on ASICs fabricated in a 90 nm CMOS process, is presented. The cross-correlator proper (excluding per-antenna processing) is estimated to consume less than 35 kW.

signal processing↗
NASA NTRS2007

Antenna and Electronics Cost Tradeoffs For Large Arrays

This viewgraph presentation describes the cost tradeoffs for large antenna arrays. The contents include: 1) Cost modeling for large arrays; 2) Antenna mechanical cost over a wide range of sizes; and 3) Cost of per-antenna electronics.

antenna mechanical costs↗
NASA NTRS2006

Applications of Microwave Photonics in Radio Astronomy and Space Communication

An overview of narrow band vs wide band signals is given. Topics discussed included signal transmission, reference distribution and photonic antenna metrology. Examples of VLA, ALMA, ATA and DSN arrays are given. . Arrays of small antennas have become more cost-effective than large antennas for achieving large total aperture or gain, both for astronomy and for communication. It is concluded that emerging applications involving arrays of many antennas require low-cost optical communication of both wide bandwidth and narrow bandwidth; development of round-trip correction schemes enables timing precision; and free-space laser beams with microwave modulation allow structural metrology with approx 100 micrometer precision over distances of 200 meters.

microwave↗