Search NASA⌕ Search

Engineering topics

Dai, Gaofeng

Publications and source records attributed to Dai, Gaofeng.

Nitrogen evolution, NO X formation and reduction in pressurized oxy coal combustion

Oxy-combustion is one of the most prominent solutions for reducing CO 2 emissions from coal-fired power plants using carbon-capture-and-utilization technology. However, when compared to air combustion at atmospheric pressure, oxy-combustion is very expensive, owing to the significant efficiency penalties associated with air separation, flue gas recirculation (FGR), treatment, compression, and storage or transit of CO 2 . In comparison, pressurized oxy-combustion (POC) is more efficient as it recovers a significant amount of heat energy from the flue gas moistures. Nevertheless, CO 2 derived from pressurized oxy coal combustion has impurities, e.g., acid gases (NO X and SO X ) that can corrode the plant equipment, transport lines as well as deteriorating effect on the environment. Fortunately, in pressurized combustion systems, both NO X and SO X can be scrubbed by a single-column direct contact cooler (DCC), but this requires a minimum ratio of NO X to SO X at the inlet to be efficiently removed. Therefore, NOx is one of the important hindering parameters in commercializing the pressurized oxy-combustion. Although NOx evolution during oxy-coal combustion has been explored extensively at 1 atm, higher pressure studies are rare. Much still needs to be done to better understand the NO X mechanism and the effects of different parameters on NO X emissions under these conditions. Here, this paper reviews the published literature on nitrogen evolution, NO X formation and reduction in pressurized oxy-coal combustion. At higher pressures, the NO X from fuel-bound nitrogen is generated through volatiles, tar and char, all of which are discussed. Where literature is not available, the effect of pressure on NOx evolution in different stages of coal combustion is predicted through CHEMKIN simulation. Homogeneous and heterogeneous pathways of NO X formation and their destruction in pressurized oxy-coal combustion are evaluated. Additionally, the effect of pressure on a few mature and commercialized NOx abatement methods is explored. In the last, the future perspective and recommendation are given. This review will aid in the provision of basic knowledge about NOx evolution and control in pressurized fuel combustion, as well as the identification of new research areas to pursue.

01 COAL, LIGNITE, AND PEAT↗

A kinetic evaluation on NO 2 formation in the post-flame region of pressurized oxy-combustion process

Pressurized oxy-combustion is a promising technology that can significantly re-duce the energy penalty associated with first generation oxy-combustion for CO 2 capture in coal-fired power plants. However, higher pressure enhances the production of strong acid gases, including NO 2 and SO 3 , aggravating the corrosion threat during flue gas re-circulation. In the flame region, high temperature NO x exists mainly as NO, while conversion from NO to NO 2 happened in post-flame region. In this study, the conversion of NO → NO 2 has been kinetically evaluated under representative post-flame conditions of pressurized oxy-combustion after validating the mechanism (80 species and 464 reactions), which includes nitrogen and sulfur chemistry based on GRI-MECH 3.0. The effects of residence time, temperature, pressure, major species (O 2 /H 2 O), and minor or trace species (CO/SO x ) on NO 2 formation are studied. The calculation results show that when pressure is increased from 1 to 15 bar, NO 2 is increased from 1 to 60 ppm, and the acid dew point increases by over 80°C. Higher pressure and temperature greatly reduce the time required to reach equilibrium. With increasing pressure and decreasing temperature, O plays a much more important role than HO 2 in the oxidation of NO. A higher water vapor content accelerates NO 2 formation in all cases by providing more O and HO 2 radicals. The addition of CO or SO 2 also promotes the formation of NO 2 . The NO 2 formation in a pressurized oxy-combustion furnace can be over 10 times that of an atmospheric air-combustion furnace.

01 COAL, LIGNITE, AND PEAT↗