Engineering topics

Danilovic, Nemanja (ORCID:0000000320366977)

Publications and source records attributed to Danilovic, Nemanja (ORCID:0000000320366977).

4 records

DOE OSTI2023

Tailoring the Mass Transport to Achieve High-Performing Unitized Regenerative Fuel Cells Considering Practical Operating Conditions

Unitized regenerative fuel cells (URFCs) convert electrical energy to chemical bonds in hydrogen during charge and convert chemical energy to output electricity during discharge, offering a promising solution to long-term energy storage. Recent studies indicate that the round-trip-voltaic efficiency (RTE) and longevity of URFCs are limited by complex mass transport during charging and discharging. Here, we first investigate how different porous transport layer (PTL) structures can impact URFC performance. The preferred PTL has a low tortuosity and high porosity, leading to a high RTE above 50% at 1 A cm −2 using Nafion 212. Moreover, thicker membranes, such as Solvay 90, are required to ensure mechanical stability and minimize H 2 crossover when operating under high differential pressure. Although this assembly inevitably leads to a higher ohmic loss, the RTE can be improved by further tailoring the electrode structures to facilitate mass transport by using supported catalyst, which still achieves over 50% RTEs at 1 A cm −2 . Optimization of porous structure to mitigate mass transport resistance with appropriate materials down selection considering practical application requirements can be a key design principle for achieving high-performing URFCs.

25 ENERGY STORAGE↗

DOE OSTI2022

Performance and Durability of Proton Exchange Membrane Vapor-Fed Unitized Regenerative Fuel Cells

With a growing demand for electricity, clean hydrogen production and usage can be an asset not only to mitigate emissions but for long-term energy storage as well. Hydrogen gas, a high-density energy carrier, can be made through electrolysis in charging mode and generate electricity via a fuel cell in discharging mode in a unitized regenerative fuel cell (URFC). While URFCs reduce cost by combining the charging and discharging modes into a singular device, switching between modes becomes burdensome, and water management is a major challenge. One way to mitigate these issues is to operate the entire system in the vapor phase. Vapor-phase operation simplifies the physics of the system but will introduce losses within the system, primarily ohmic and mass transport during the charging mode. In this study, we explore the performance of a Proton-Exchange-Membrane (PEM)-URFC under vapor-phase conditions and the impact of different PEMs, feed gases, and relative humidity on the performance and durability. By tailoring operating conditions and membrane, the vapor-URFC achieves a roundtrip efficiency of 42% and a lifetime of 50,000 accelerated stress test cycles for fully humidified feeds. Discussion of vapor-URFC for energy storage and extensions to look at various applications shows the promise of this technology.

25 ENERGY STORAGE↗

DOE OSTI2022

Influence of Supporting Electrolyte on Hydroxide Exchange Membrane Water Electrolysis Performance: Catholyte

Alkaline or hydroxide exchange membrane water electrolysis (HEMWE) is a promising technology for green hydrogen production using platinum group metal-free catalysts and stainless steel, an advantage of alkaline water electrolysis (AWE), and a gas-impermeable membrane, a parallel to proton exchange membrane electrolysis (PEMWE). However, the HEMWE requires supporting electrolytes and there is minimal understanding of their role on the respective reactions. Without SELs, HEMWE performance and durability are worse than PEMWE systems. Herein, consistently feeding potassium hydroxide anolyte, we systematically study the effects of catholyte SELs in HEMWEs including dry vs. wet operation, cation effects, anion effects, and cation/OH ratios on cell potential and stability. We report that (i) hydration of the cathode improves high current density operation by preventing dehydration of the hydroxide exchange membrane (HEM), (ii) there was no correlation between cation type and cell potential, (iii) cell potential and high frequency resistance did not correlate with SEL conductivity, (iv) cathodic carbonate SEL had a significant negative effect on cell performance, (v) increased cation/OH ratio also caused increased cell potentials. Overall, this study concludes that feeding water or potassium hydroxide solution is desirable to improve the AEMWE performance.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Method—Using Microelectrodes to Explore Solid Polymer Electrolytes

Solid polymer electrolytes are an emerging technology in electrochemistry driven by their use in energy applications such as fuel cells, electrolyzers, and solid-state batteries. Compared to traditional liquid electrolytes, solid polymer electrolytes provide safer, cheaper, and potentially improved device performance. However, there is a lack of standard experimental methods for studying solid electrolytes. Microelectrodes have inherent benefits capable of filling this experimental gap due primarily to their integration into model electrochemical cells with solid electrolytes that represent complex interfaces, enabling additional insight into reaction processes. In this tutorial review, we explore the use of microelectrodes to study solid polymer electrolytes, beginning with a brief history of the field including common experimental cell designs and their benefits and drawbacks. Methods of evaluating essential kinetic and mass-transport parameters are then examined. In addition, the key studies of the past 30 years utilizing microelectrode cells and solid polymer electrolytes are summarized, with important results highlighted and compared. Finally, future studies of solid polymer electrolytes with microelectrodes and potential new avenues of research are commented on.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗