Search NASA⌕ Search

Engineering topics

Davenport, E. E.

Publications and source records attributed to Davenport, E. E..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Transonic static and dynamic stability characteristics of a finned projectile configuration

Static and dynamic stability tests were made of a finned projectile configuration with the aft-mounted fins arranged in a cruciform pattern. The tests were made at free stream Mach numbers of 0.7, 0.9, 1.1, and 1.2 in the Langley 8-foot transonic pressure tunnel. Some of the parameters measured during the tests were lift, drag, pitching moment, pitch damping, and roll damping. Configurations tested included the body with undeflected fins, the body with various fin deflections for control, and the body with fins removed. Theoretical estimates of the stability derivatives were made for the fins on configuration.

Boyden, R. P.↗
NASA NTRS1976

Static force tests of a sharp leading edge delta-wing model at ambient and cryogenic temperatures with a description of the apparatus employed

A sharp leading edge delta-wing model was tested through an angle-of-attack range at Mach numbers of 0.75, 0.80, and 0.85 at both ambient and cryogenic temperatures in the Langley 1/3-meter transonic cryogenic tunnel. Total pressure was varied with total temperature in order to hold test Reynolds number constant at a given Mach number. Agreement between the aerodynamic data obtained at ambient and cryogenic temperatures indicates that flows with leading-edge vortex effects are duplicated properly at cryogenic temperatures. The test results demonstrate that accurate aerodynamic data can be obtained by using conventional force-testing techniques if suitable measures are taken to minimize temperature gradients across the balance and to keep the balance at ambient (warm) temperatures during cryogenic operation of the tunnel.

Kilgore, R. A.↗
NASA NTRS1976

Subsonic and transonic dynamic stability characteristics of the space shuttle launch vehicle

An investigation has been conducted to determine the subsonic and transonic dynamic stability characteristics of a 0.015 scale model of the space shuttle launch vehicle. These tests were conducted in the Langley 8-foot transonic pressure tunnel over a Mach number range from 0.3 to 1.2. Forced oscillation equipment was used to determine the damping characteristics of several configurations about all three axes. The test results show that the model exhibited positive damping in pitch except at the highest Mach number (1.2) where there was a region of negative damping at 2 deg angle of attack. The yawing oscillation tests show that the model exhibited nonlinearities and negative damping at Mach numbers of 0.3 and 0.6. The model exhibited positive roll damping throughout the test angle of attack and Mach range.

Freeman, D. C., Jr.↗
NASA NTRS1976

Supersonic dynamic-stability derivatives of the space shuttle launch vehicle

An investigation was made to determine the dynamic stability characteristics of a 0.015-scale model of the space shuttle launch vehicle at supersonic speeds. These tests were made at angles of attack from -10 deg to 10 deg at Mach numbers of 2.00, 2.86, 3.96, and 4.63. The complete launch vehicle, consisting of the orbiter, external tank, and solid rocket boosters, has positive damping in pitch, roll, and yaw over the angle-of-attack and Mach number range. The orbiter external tank configuration has a region of negative angles pitch damping for small negative of attack at a Mach number of 2.00. At all other test conditions, the orbiter external tank configuration has positive damping about all three axes.

Boyden, R. P.↗
NASA NTRS1976

Supersonic dynamic stability characteristics of a space shuttle orbiter

Supersonic forced-oscillation tests of a 0.0165-scale model of a modified 089B Rockwell International shuttle orbiter were conducted in a wind tunnel for several configurations over a Mach range from 1.6 to 4.63. The tests covered angles of attack up to 30 deg. The period and damping of the basic unaugmented vehicle were calculated along the entry trajectory using the measured damping results. Some parameter analysis was made with the measured dynamic derivatives. Photographs of the test configurations and test equipment are shown.

Freeman, D. C., Jr.↗
NASA NTRS1975

Dynamic-stability tests on an aircraft escape module at Mach numbers from 0.40 to 2.16

Wind-tunnel measurements of the aerodynamic damping and oscillatory stability of a model of a proposed escape module for a military aircraft have been made using a small-amplitude forced-oscillation technique in pitch and yaw at Mach numbers from 0.40 to 2.16 and in roll at Mach numbers from 0.40 to 1.20. The results in pitch indicate regions in the angle-of-attack range where the model exhibits large and rapid changes in both damping and stability with angle of attack, probably caused by vortex flow over the fins. There was no pronounced effect of change in angle of attack on damping in yaw. Except for the highest Mach number, negative damping in roll was produced at high negative angles of attack.

Davenport, E. E.↗
NASA NTRS1975

Analysis of validation tests of the Langley pilot transonic cryogenic tunnel

A pilot transonic cryogenic pressure tunnel has recently been developed and proof tested at the NASA Langley Research Center. In addition to providing an attractive method for obtaining high Reynolds number results at moderate aerodynamic loadings and tunnel power, this unique tunnel allows the independent determination of the effects of Reynolds number, Mach number, and dynamic pressure (aeroelasticity) on the aerodynamic characteristics of the model under test. The proof of concept experimental and theoretical studies are briefly reviewed. Experimental results obtained on both two- and three-dimensional models have substantiated that cryogenic test conditions can be set accurately and that cryogenic gaseous nitrogen is a valid test medium.

Ray, E. J.↗
NASA NTRS1975

Aerodynamic damping and oscillatory stability in pitch of a model of a proposed manned lifting entry vehicle at Mach Numbers of 1.80, 2.16, and 2.86

Wind tunnel tests were conducted using a model of a proposed manned lifting entry vehicle to determine the aerodynamic damping and oscillatory stability in pitch. The model was tested at Mach numbers of 1.80, 2.16, and 2.86. Angles of attack varied from minus 2 degrees to plus 30 degrees at zero angle of sideslip using a small-amplitude, forced-oscillation technique. It was determined that, in general, all the configurations have near zero or slightly positive damping in pitch throughout the angle of attack range. The effects of the deflection of flaps on aerodynamic damping are discussed.

Kilgore, R. A.↗
NASA NTRS1975

Aerodynamic damping and oscillatory stability in pitch and yaw of a model of a proposed manned lifting entry vehicle at Mach numbers from 0.20 to 1.20

Wind tunnel tests have been made at angles of attack from about -2 deg to about 22 deg at 0 deg angle of sideslip by using a small-amplitude forced-oscillation technique. Models were tested with upper and lower control flaps both deflected and undeflected. The configuration with flaps deflected has positive damping in both pitch and yaw and is stable in both pitch and yaw except at the higher angles of attack where the tail surfaces are submerged in the wake from the body.

Kilgore, R. A.↗
NASA NTRS1974

The cryogenic wind tunnel concept for high Reynolds number testing

Theoretical considerations indicate that cooling the wind-tunnel test gas to cryogenic temperatures will provide a large increase in Reynolds number with no increase in dynamic pressure while reducing the tunnel drive-power requirements. Studies were made to determine the expected variations of Reynolds number and other parameters over wide ranges of Mach number, pressure, and temperature, with due regard to avoiding liquefaction. Practical operational procedures were developed in a low-speed cryogenic tunnel. Aerodynamic experiments in the facility demonstrated the theoretically predicted variations in Reynolds number and drive power. The continuous-flow-fan-driven tunnel is shown to be particularly well suited to take full advantage of operating at cryogenic temperatures.

Kilgore, R. A.↗
NASA NTRS1974

Aerodynamic damping and oscillatory stability of a model of a proposed HL-10 vehicle in pitch at Mach numbers from 0.20 to 2.86 and in YAW at Mach numbers from 0.20 to 1.20

Wind tunnel tests of a proposed HL-10 lifting body vehicle were conducted to determine the subsonic and transonic aerodynamic characteristics. The conditions under which the tests were conducted are described. The tests indicate that the configuration has slightly positive damping in pitch except at higher angles of attack at Mach numbers of 0.8, 0.9, and 1.0. At supersonic speeds, the configuration has positive damping in pitch for all test conditions. At subsonic and transonic speed, the configuration has positive damping and positive stability in yaw for all test conditions.

Kilgore, R. A.↗
NASA NTRS1974

Supersonic dynamic stability derivatives of a modified 089B shuttle orbiter

An experimental test program was conducted to measure the dynamic stability derivatives of a modified 089B shuttle orbiter. Supersonic forced oscillation tests were conducted in the Langley Unitary Plan Wind Tunnel over a range of Mach numbers from 1.6 to 4.63 for angles of attack up to 30 deg. The data were measured at the model resonant frequency with pitch and yaw amplitudes of 1 deg and a roll amplitude of 2.5 deg.

Freeman, D. C.↗
NASA NTRS1974

Aerodynamic characteristics of three slender sharp-edge 74 degrees swept wings at subsonic, transonic, and supersonic Mach numbers

Slender sharp-edge wings having leading-edge sweep angles of 74 deg have been studied at Mach numbers from 0.60 to 2.80, at angles of attack from about minus 4 deg to 22 deg, and at angles of sideslip from 0 deg to 5 deg. The wings had delta, arrow, and diamond planforms. The experimental tests were made in the Langley 8-foot transonic pressure tunnel and the Langley Unitary Plan wind tunnel test section number 1. The theoretical predictions were made using the theories of NASA TN D-3767 and NASA TN D-6243. The results of the study indicated that the lift and drag characteristics as affected by planform and Mach number could be reasonably well predicted for the delta wing in the subsonic and transonic Mach number range. In the supersonic range, the delta and diamond wings were about equally good in the degree of agreement between experiment and theory. In making drag-due-to-lift predictions the vortex lift effects must be taken into account if reasonable results are to be obtained at moderate or high lift coefficients.

Davenport, E. E.↗
NASA NTRS1974

Test results from the Langley high Reynolds number cryogenic transonic tunnel

NASA has recently developed and proof tested a pilot cryogenic transonic pressure tunnel. In addition to providing an attractive method for obtaining high Reynolds number results at moderate aerodynamic loadings and tunnel power, this unique facility enables the independent determination of the effects of Reynolds number, Mach number, and aeroelasticity. The proof-of-concept experimental and theoretical studies are briefly reviewed. Experimental results are included which indicate pressure distributions for a two-dimensional airfoil and strain-gage balance characteristics for a three-dimensional delta wing model.

Ray, E. J.↗
NASA NTRS1973

Wind-tunnel roll-damping measurements of a winged space shuttle configuration in launch attitude

Ground-wind load studies were conducted on three model configurations to assess the importance of aeroelastic instabilities of erected space shuttle vehicles. Roll damping was measured on a fuselage-alone model, which had a D cross section, and a fuselage and tail surfaces in combination with either a clipped-delta wing or a low-sweep tapered wing as the primary lifting surface. The largest negative roll-damping coefficients were measured with the fuselage-alone configuration and were a function of wind azimuth. At the wind azimuths at which the wing-fuselage configuration was unstable, the negative roll-damping coefficients were a function of reduced frequency.

Hess, R. W.↗
NASA NTRS1972

Aerodynamic characteristics of some modified conical bodies with low lift-drag ratios at Mach numbers of 2.30 and 4.63

A wind-tunnel investigation was conducted at Mach numbers of 2.30 and 4.63 to determine the static aerodynamic characteristics of three 60 deg half-angle cone models. Configuration 1 was obtained by raking off a symmetrical cone at a base angle of 6.15 deg, and configuration 2 and 3 were obtained by adding flaps to a symmetrical cone. The models were tested at angles of attack from about -5 deg to about 20 deg at roll angles of 0 deg to -180 deg and at a freestream Reynolds number of 1.09 x one million, based on body diameter. The results showed that all three configurations produced finite values of lift-drag ratio useful for lifting planetary entry. All three configurations exhibited increases in yawing moment and side force with roll angle; thus, the capability for lateral trajectory control is provided.

Davenport, E. E.↗