Engineering topics

David E Cox

Publications and source records attributed to David E Cox.

4 records

NASA NTRSDate not supplied

Operational Experience with the Electromagnetic Position Sensor (EPS) for the NASA 6-inch MSBS

We rebuilt the wind tunnel model position signal conditioner for the MIT 6-Inch Magnetic Suspension and Balance System (MSBS) Electromagnetic Position Sensor (EPS) that is now in use at the NASA Langley Research Center (LaRC). The effort began at LaRC in ~1990 to replace the original MIT system that was still operating with the low speed wind tunnel until its decommissioning a few years later. The MIT filtering and demodulating scheme mostly remained in the newly designed two-layer printed circuit boards (PCB) with some rearranging of order. The finished product was hampered by noise problems due to problematic grounding design etc. and never successfully operated in the MSBS. After over 20 years, the Langley unit was recovered from Old Dominion University where the MSBS was on loan from NASA but never refurbished. The EPS was brought back to LaRC in 2015 while planning for the return of the MSBS and work began to evaluate its condition and acquire supporting instrumentation. The repair, testing, operational issues, and future improvements are discussed along with an overview of the EPS as a subsystem.

Timothy D Schott↗

NASA NTRSDate not supplied

An Investigation of Bluff Body Blockage Corrections Using the NASA/ODU 6-inch MSB

Spheres of different diameters were tested in the NASA/ODU 6-inch MSBS. The objective is to develop an improved understanding of blockage corrections to be made to other bluff-body geometries. Drag coefficients are shown with classical corrections applied, along with wall pressure signatures and base pressure measurements. Anomalous behavior was observed with the largest diameter, thought to be some form of flow breakdown, hence uncorrectable interference.

blunt body↗

NASA NTRSDate not supplied

Electromagnetic Modeling of Wind tunnel Magnetic Suspension and Balance Systems

An analytical framework for the open-loop behavior of a permanent magnet element levitated within an applied magnetic field are shown, in the context of application to wind tunnel Magnetic Suspension and Balance Systems (MSBS). Various modes of motion are identified, which correlate with observed behavior of the NASA/ODU 6-inch MSBS. This system is being developed as a technology demonstrator for dynamic stability testing of atmospheric entry capsules, with possible application to a supersonic wind tunnel. The analytic equations are populated with field information from experimental measurements and a finite element model. Finally, a system simulation can provide alternative estimates of system dynamic behavior via model linearization, with preliminary comparisons presented. Taken together, the analytical framework, experimental measurement, finite element analysis, and dynamic simulation provide a complete understanding of the characteristics and behavior of the MSBS.

magnetic suspension↗

NASA NTRSDate not supplied

Distributed Thrust Takeoff for the NASA X-57 Mod IV Flight Demonstrator

The Mod IV configuration of the X-57 flight demonstrator concept featured two forms of distributed electric propulsion—one cruise propulsor at each wingtip for primary propulsion that enabled favorable interaction with the wingtip vortex, and six high-lift propulsors distributed along the leading edge of each wing to enhance low-speed flight characteristics. The power system that fed these propulsors was arranged in two independent power buses. This unique arrangement did not lend itself to traditional “one engine inoperative” methods for determining performance after a critical failure in the propulsion system. Several potential failure scenarios were identified as potential “critical loss of thrust” events, and experiments that included pilot-in-the-loop simulation with the project test pilots were conducted to determine if these events would result in adequate handling and performance. Prior research showed that a total failure of one of the cruise motors during takeoff or initial climb could result in unacceptable performance for a traditional full-power takeoff. A new technique dubbed Distributed Thrust Takeoff (DiTTo) was developed to reduce the impact of the thrust asymmetry and total loss of thrust that could occur in any of the critical loss of thrust scenarios. The results showed that adequate performance and handling qualities could be achieved in each of the critical failure scenarios when using the DiTTo technique.

Distributed Propulsion, Electric Propulsion, Criti↗