Engineering topics

Davis, L. P.

Publications and source records attributed to Davis, L. P..

4 records

NASA NTRS1992

Design of a D-Strut and its application results in the JPL, MIT, and LaRC test beds

High damping at very low magnitudes of vibration is provided by an 'Arched Flexure' D-Strut. Five of these devices have been incorporated in JPL's CSI truss structure, and five more in MIT's interferometer test bed. Two were also temporarily installed in the LaRC CSI test structure. Damping factors in the 50 percent category are being provided at vibration motions as small as 50 nm. The 'Arched Flexure' used in the D-Strut maximizes the volumetric stiffness parameter relative to its axial stiffness. In turn, this enables high damping factors, even in a very rigid truss structure. This paper includes a presentation and discussion of both element and system test data taken at JPL, LaRC, and MIT. Also provided is a detailed description of the D-Strut, the dynamic model, and several graphs showing design parameter variations that will make it possible to evaluate the D-Strut for other applications.

Davis, L. P.↗

NASA NTRS1989

Damper Of Small Vibrations

Vibration damper has no rubbing parts. Thus eliminates even very small static frictional forces and therefore responds to and damps extremely low levels of vibration. Damper dissipates vibration by motion of piston in volume of silicone oil. Coaxial rigid shaft holds upper and lower bellows at constant length while piston vibrates up and down. Although volumes of upper and lower bellows change continually, total volume of bellows assembly stays same.

Davis, L. P.↗

NASA NTRS1987

Workshop on Structural Dynamics and Control Interaction of Flexible Structures

The Hubble Space Telescope features the most exacting line of sight jitter requirement thus far imposed on a spacecraft pointing system. Consideration of the fine pointing requirements prompted an attempt to isolate the telescope from the low level vibration disturbances generated by the attitude control system reaction wheels. The primary goal was to provide isolation from axial component of wheel disturbance without compromising the control system bandwidth. A passive isolation system employing metal springs in parallel with viscous fluid dampers was designed, fabricated, and space qualified. Stiffness and damping characteristics are deterministic, controlled independently, and were demonstrated to remain constant over at least five orders of input disturbance magnitude. The damping remained purely viscous even at the data collection threshold of .16 x .000001 in input displacement, a level much lower than the anticipated Hubble Space Telescope disturbance amplitude. Vibration attenuation goals were obtained and ground test of the vehicle has demonstrated the isolators are transparent to the attitude control system.

Davis, L. P.↗

NASA NTRS1986

Line-of-sight performance improvement with reaction-wheel isolation

Design techniques used to isolate and damp vibrations from the reaction control wheels assembly (RCA) from the structural dynamics of the Hubble Space Telescope are described. The four RCAs can generate sufficient torque for large maneuvers and precision control during fine pointing. The RCAs are to operate continuously during observations and thereby pose the potential of inducing jitter. The image stability must be constrained to less than 0.007 arcsec rms per 24 hr and pointing accuracy must be 0.01 arcsec for 100 hr. Vibration-producing characteristics of the RCAs are identified, and test results are provided from measurements of the magnitudes of the associated disturbances. Design features and test results for the vibration isolators employed with the RCAs to effect viscous damping of RCA axial perturbations are presented. The dampers are expected to reduce jitter effects of RCA operation by a half.

Rodden, J. J.↗