Engineering topics

Davis, S. H.

Publications and source records attributed to Davis, S. H..

At least 19 records

NASA NTRS1999

Directional Solidification of a Binary Alloy into a Cellular Convective Flow: Localized Morphologies

A steady, two dimensional cellular convection modifies the morphological instability of a binary alloy that undergoes directional solidification. When the convection wavelength is far longer than that of the morphological cells, the behavior of the moving front is described by a slow, spatial-temporal dynamics obtained through a multiple-scale analysis. The resulting system has a "parametric-excitation" structure in space, with complex parameters characterizing the interactions between flow, solute diffusion, and rejection. The convection stabilizes two dimensional disturbances oriented with the flow, but destabilizes three dimensional disturbances in general. When the flow is weak, the morphological instability behaves incommensurably to the flow wavelength, but becomes quantized and forced to fit into the flow-box as the flow gets stronger. At large flow magnitudes the instability is localized, confined in narrow envelopes with cells traveling with the flow. In this case the solutions are discrete eigenstates in an unbounded space. Their stability boundary and asymptotics are obtained by the WKB analysis.

Chen, Y.- J.↗

NASA NTRS1998

Interactions Between Solidification and Compositional Convection in Alloys

This project combined theoretical and experimental ground-based studies of the interactions between convection and solidification of binary melts. Particular attention was focused on the alteration of the composition and microstructure of castings caused by convective flows through the interstices of mushy layers. Two different mechanisms causing convection were investigated. (i) Compositional, buoyancy driven convection is known to cause chimneys and freckles in directionally cast alloys on Earth. The analytical studies provide quantitative criteria for the formation of chimneys that can be used to assess the expediency of producing alloys in Space. (ii) Flow of the melt is also driven by the contraction (expansion) that typically occurs during change of phase. Such convection will occur even in the absence of gravity, and may indeed be the primary cause of macrosegregation during the production of alloys in Space. The studies will employed asymptotic methods in order to determine conditions for the stability of various states of solidifying systems. Further, simple macroscopic models of complete systems were developed and solved. These analytical studies were augmented by laboratory experiments using aqueous solutions, in which the convective flows could be easily observed and the effects of convection could be readily measured. These y experiments guided the development of the theoretical models and provided data against which the predictions of the models can be tested.

Davis, S. H.↗

NASA NTRS1993

Thermal effects in rapid directional solidification - Linear theory

We study the morphological instability of the planar solid/liquid interface for a unidirectionally-solidified dilute binary mixture. We use a model developed by Boettinger et al. (1985, 1986), Aziz (1982), and Jackson et al. (1980), which allows for nonequilibrium effects on the interface through velocity-dependent segregation and attachment kinetics. Two types of instabilities are found in the linear stability analysis: (1) a cellular instability, and (2) an oscillatory instability driven by disequilibrium effects. Merchant and Davis (1990) characterized these instabilities subject to the frozen-temperature approximation (FTA). The present work relaxes the FTA by including the effects of latent heat and the full temperature distribution. Thermal effects slightly postpone the onset of the cellular instability but dramatically postpone the onset of the oscillatory instability; however, the absolute-stability conditions, at which at high speed the cellular and oscillatory instabilities are suppressed, remain unchanged from the FTA.

Huntley, D. A.↗

NASA NTRS1993

Morphological instability in epitaxially strained dislocation-free solid films - Linear stability theory

The morphological instability of a growing epitaxially strained dislocation-free solid film is analyzed. An evolution equation for the film surface is derived in the dilute limit of vacancies based on surface diffusion driven by a stress-dependent chemical potential. From the time-dependent linear stability problem the conditions for which a growing film is unstable are determined. It is found that the instability is driven by the lattice mismatch between the film and the substrate; however, low temperatures as well as elastically stiff substrates are stabilizing influences. The results also reveal that the critical film thickness for instability depends on the growth rate of the film itself. Detailed comparison with experimental observations indicates that the instability described exhibits many of the observed features of the onset of the 'island instability'.

Spencer, B. J.↗

NASA NTRS1992

Cellular instability in rapid directional solidification - Bifurcation theory

Merchant and Davis performed a linear stability analysis on a model for the directional solidification of a dilute binary alloy valid for all speeds. The analysis revealed that nonequilibrium segregation effects modify the Mullins and Sekerka cellular mode, whereas attachment kinetics has no effect on these cells. In this paper, the nonlinear stability of the steady cellular mode is analyzed. A Landau equation is obtained that determines the amplitude of the cells. The Landau coefficient here depends on both nonequilibrium segregation effects and attachment kinetics. This equation gives the ranges of parameters for subcritical bifurcation (jump transition) or supercritical bifurcation (smooth transition) to cells.

Braun, R. J.↗

NASA NTRS1992

Pulsatile instability in rapid directional solidification - Strongly-nonlinear analysis

In the rapid directional solidification of a dilute binary alloy, analysis reveals that, in addition to the cellular mode of Mullins and Sekerka (1964), there is an oscillatory instability. For the model analyzed by Merchant and Davis (1990), the preferred wavenumber is zero; the mode is one of pulsation. Two strongly nonlinear analyses are performed that describe this pulsatile mode. In the first case, nonequilibrium effects that alter solute rejection at the interface are taken asymptotically small. A nonlinear oscillator equation governs the position of the solid-liquid interface at leading order, and amplitude and phase evolution equations are derived for the uniformly pulsating interface. The analysis provides a uniform description of both subcritical and supercritical bifurcation and the transition between the two. In the second case, nonequilibrium effects that alter solute rejection are taken asymptotically large, and a different nonlinear oscillator equation governs the location of the interface to leading order. A similar analysis allows for the derivation of an amplitude evolution equation for the uniformly pulsating interface. In this case, the bifurcation is always supercritical. The results are used to make predictions about the characteristics of solute bands that would be frozen into the solid.

Merchant, G. J.↗

NASA NTRS1992

Pulsatile instability in rapid directional solidification: Strongly-nonlinear analysis

In models of rapid directional solidification, non-equilibrium interfacial conditions are employed. As a result, there is an oscillatory mode of instability, as well as the steady cellular mode, found in the equilibrium model of Mullins and Sekerka. When the temperature field is decoupled from the problem, the preferred wave number for the oscillatory mode is zero, and the interface pulsates in time while remaining spatially uniform. Results from multiple scale analyses in the two limiting cases of the parameters are reported. In these limits, it is found that the instability is a bifurcation to relaxation oscillations; these nonlinear oscillations may be related to the observed microstructure that results from rapid solidification processes such as laser surface remelting.

Braun, Richard J.↗

NASA NTRS1992

The effect of compositionally-generated elastic stresses on morphological instability during directional solidification

The effect of compositionally-generated elastic stresses on the conditions for morphological instability during directional solidification of a dilute, ideal binary alloy is investigated using the Gibbs-Thomson equations for an elastically-stressed solid with zero surface stress in equilibrium with a liquid. It is found that these stresses lead to a small stabilization of the Mullins and Sekerka cellular mode of instability. The steady mode is stabilized by a stress-induced modification to the interfacial concentration of the solid, which in turn alters the amount of solute rejected to inhibit the growth of perturbations. The presence of elastic stresses could generate a new oscillatory instability which is most likely to be found in experiments near absolute stability for materials with segregation coefficients near unity and large solute expansion coefficients.

Spencer, B. J.↗

NASA NTRS1992

Growth from a hypercooled melt near absolute stability

The stability of a solid-liquid interface in a hypercooled melt is studied, taking into account attachment kinetics, surface energy, and surface energy in the heat balance. There is a basic-state solution with the planar interface moving at constant speed. Linear-stability theory gives a long-wave absolute-stability limit. Near this point a string model is introduced in which a thermal-boundary-layer approximation is used and an evolution equation for the interface is obtained. In a limiting case this interface equation reduces to a Kuromoto-Sivashinsky equation. Comparison with experimental and numerical results are discussed, and a conceptual picture of unconstrained growth for all undercoolings is addressed.

Umantsev, A.↗

NASA NTRS1992

Benard convection in binary mixtures with Soret effects and solidification

Benard convection was studied in a two-component liquid which displayed Soret effects (Soret, 1879; DeGroot and Mazur, 1969) and in which the temperatures of the horizontal boundaries spanned the solidification temperature of the mixture. A steady basic state was observed, in which the layer is partly liquid (near the lower, heated plate) and partly solid (near the upper, cooled plate) with the interface being planar, and in which all transport is by conduction and diffusion. Linear stability of the basic state was examined to determine how the presence of solid and the ability of the material to solidify or melt under disturbance affects the critical conditions from the onset of instability. The theoretical results obtained for cases when the phase change is absent and when the Soret effects are absent (but the phase change is present) are compared with an experiment using alcohol-water mixtures.

Zimmermann, G.↗

NASA NTRS1991

Buoyancy effects of a growing, isolated dendrite

The buoyancy effect of a growing isolated dendrite on the solidification process in the undercooling liquid material was investigated by developing an analytic solution to the growth/convection problem in powers of a buoyancy parameter G. The solution depends on the Prandtl number P and the Stefan number S (undercooling) for the local velocity and thermal fields and also the buoyant alteration of the interface shape. Results suggest that buoyancy effect for metals (low P) may be qualitatively different from that for organics (high P).

Canright, D.↗

NASA NTRS1991

The linear stability of plane stagnation-point flow against general disturbances

The linear-stability theory of plane stagnation-point flow against an infinite flat plate is re-examined. Disturbances are generalized from those of Goertler type to include other types of variations along the plate. It is shown that Hiemenz flow is linearly stable and that the Goertler-type modes are those that decay slowest. This work then rationalizes the use of such self-similar disturbances on Hiemenz flow and shows how questions of disturbance structure can be approached on other self-similar flows.

Brattkus, K.↗

NASA NTRS1990

Morphological instability in rapid directional solidification

Mullins and Sekerka (1964) showed for fixed temperature gradient that the planar interface is linearly stable for all pulling speeds V above some critical value, the absolute stability limit. Near this limit, where solidification rates are rapid, the assumption of local equilibrium at the interface may be violated. Here, nonequilibrium effects are incorporated into a linear stability analysis of the planar front by allowing the segregation coefficient and interface temperature to depend on V in a thermodynamically consistent way. The absolute stability limit of the cellular mode is modified. A new oscillatory state is formed which, in the absence of latent heat, has a critical wavenumber of zero; by itself this instability would lead to the formation of solute bands in the solid. This mode has its own absolute-stability limit determined by solute trapping and kinetics. Under certain conditions, there exists a window of stability above the steady absolute-stability boundary and below the oscillatory-stability boundary; here the planar segregation-free state is restabilized.

Merchant, G. J.↗

NASA NTRS1990

Long-wave morphological instabilities in the directional solidification of a dilute binary mixture

Long-wave instabilities in a directionally-solidified binary mixture may occur in several limits. Sivashinsky (1983) identified a small-segregation-coefficient limit and obtained a weakly nonlinear evolution equation governing subcritical two-dimensional bifurcation. Brattkus and Davis (1988) identified a near-absolute-stability limit and obtained a strongly nonlinear evolution equation governing supercritical two-dimensional bifurcation. The present investigation identifies a third strongly nonlinear evolution equation, arising in the small-segregation-coefficient, large-surface-energy limit. This equation links both of the former and describes the change from the sub- to super-critical bifurcations. This study sets the previous long-wave analyses into a logical framework.

Riley, D. S.↗

NASA NTRS1990

Long-wave interactions in morphological and convective instabilities

A binary liquid that undergoes directional solidification is susceptible to morphological and solutal-convective instabilities that cause the solid/liquid interface to change from a planar to a cellular state. This paper gives derivations for those long-wave evolution equations that describe the weak couplings between convection and interface morphology and gives some analytical results obtainable from these.

Riley, D. S.↗

NASA NTRS1989

Flow-induced morphological instabilities due to temporally-modulated stagnation-point flow

The influence of periodically-modulated planar stagnation-point flow on the morphological stability of a directionally-solidifying interface is presently considered with a view to the effect of unsteady nonparallel flows on single-crystal growth. The modeling of the system assumes that the viscous boundary layer thickness is much greater than that of the solute boundary layer, and that the modulation frequency is much smaller than the strength of plane stagnation-point flow. The solidifying interface is either stabilized or destabilized depending on the ratio of the period of modulation to the solute-diffusion time.

Merchant, G. J.↗

NASA NTRS1989

Shallow cells in directional solidification

The existing theory on two-dimensional transitions (appropriate to thin parallel-plate geometries) is presented in such a way that it is possible to identify easily conditions for the onset of shallow cells. Conditions are given under which succinonitrile-acetone mixtures should undergo supercritical bifurcation in experimentally accessible ranges. These results suggest a means for the quantitative test of the Mullins and Sekerka (1964) model and its weakly nonlinear extensions.

Merchant, G. J.↗

NASA NTRS1989

Similarity solutions for phase-change problems

A modification of Ivantsov's (1947) similarity solutions is proposed which can describe phase-change processes which are limited by diffusion. The method has application to systems that have n-components and possess cross-diffusion and Soret and Dufour effects, along with convection driven by density discontinuities at the two-phase interface. Local thermal equilibrium is assumed at the interface. It is shown that analytic solutions are possible when the material properties are constant.

Canright, D.↗