Engineering topics

Day, Timothy

Publications and source records attributed to Day, Timothy.

3 records

NASA NTRS1992

Sub-hertz relative frequency stabilization of two-diode laser-pumped Nd:YAG lasers locked to a Fabry-Perot interferometer

Two-diode laser-pumped Nd:YAG lasers have been frequency stabilized to a commercial 6.327-GHz free spectral range Fabry-Perot interferometer yielding a best-case beatnote linewidth of 330 mHz. In addition, a Fabry-Perot interferometer with a free spectral range of 680 MHz, a linewidth of 25 kHz, and a finesse of 27,500 has been built, and when substituted in place of the commercial interferometer produced a robust and easily repeatable beatnote linewidth of 700 MHz.

Day, Timothy↗

NASA NTRS1988

Gray scale operation of a multichannel optical convolver using the Semetex magnetooptic spatial light modulator

A new multichannel optical correlator/convolver architecture which uses an acoustooptic light modulator for the input channel and a Semetex magnetooptic spatial light modulator (MOSLM) for the set of parallel reference channels is presented. Details of the anamorphic optical system are discussed. Experimental results illustrate the use of the system as a convolver for performing digital multiplication by analog convolution (DMAC). A limited gray scale capability for data stored by the MOSLM is demonstrated by implementing this DMAC algorithm with trinary logic. Use of the MOSLM allows the number of parallel channels for the convolver to be increased significantly compared with previously reported techniques while retaining the capability for updating both channels at high speeds.

Davis, Jeffrey A.↗

NASA NTRS1987

Multichannel optical correlator/convolver utilizing the magnetooptic spatial light modulator

The paper describes a multichannel correlator/convolver architecture utilizing an acoustooptic light modulator for the one dimensional channel and a magnetooptic spatial light modulator (MOSLM) for the second two-dimensional parallel channel. The MOSLM allows greater parallelism to be implemented in this correlator/convolver design than was previously reported. The implementation of 24 parallel channels with a 48 x 48 device is demonstrated. Experimental data are presented and the ways of increasing the number of parallel channels using commercially available MOSLMs and other previously discussed techniques, such as frequency multiplexing, are discussed. It is shown that over 2000 parallel channels are possible at 32-bit accuracy. A technique for obtaining a limited gray scale is also discussed.

Davis, Jeffrey A.↗