Search NASA⌕ Search

Engineering topics

DeBoo, J C

Publications and source records attributed to DeBoo, J C.

Electron profile stiffness and critical gradient studies

Electron profile stiffness was studied in DIII-D L-mode discharges by systematically varying the heat flux in a narrow region with electron cyclotron heating and measuring the local change produced in {nabla}T{sub e}. Electron stiffness was found to slowly increase with toroidal rotation velocity. A critical inverse temperature gradient scale length 1/L{sub C} {approx} 3 m{sup -1} was identified at {rho}=0.6 and found to be independent of rotation. Both the heat pulse diffusivity and the power balance diffusivity, the latter determined by integrating the measured dependence of the heat pulse diffusivity on -{nabla}T{sub e}, were fit reasonably well by a model containing a critical inverse temperature gradient scale length and varying linearly with 1/L{sub T} above the threshold.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Contributions of Electron Cyclotron Waves to Performance in Advanced Regimes on DIII-D

High-power electron cyclotron (EC) waves are used to increase performance in several Advanced Tokamak (AT) regimes on DIII-D where there is a simultaneous need for high noninductive current and high beta. In the Quiescent High-confinement mode (QH-mode), a direct measurement of the electron cyclotron current drive (ECCD) profile is made using modulation techniques, and a trapped electron mode (TEM) dominated regime with core T{sub e}>T{sub i} is created. In the 'highq{sub min}' AT scenario, ECCD provides part of the off-axis noninductive current and helps to produce a tearing stable equilibrium. In the hybrid regime, strong central current drive from EC waves and other sources increases the noninductive current fraction to {approx_equal}100%. Surprisingly, the core safety factor remains above unity, meaning good alignment between the current drive profile and the desired plasma current profile is not necessary in this scenario.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Multi-field/multi-scale turbulence response to electron cyclotron heating of DIII-D ohmic plasmas

The multi-field/multi-scale core ({rho}{approx} 0.5-0.8) turbulence response to electron cyclotron heating (ECH) of DIII-D Ohmic plasmas is reported for the first time. Long wavelength (low-k) electron temperature (T-tilde{sub e}/T{sub e}) and high-k density turbulence levels (n-tilde{sub e}/n{sub e}) are observed to strongly increase during ECH. In contrast, low-k and intermediate-k n-tilde{sub e}/n{sub e} showed little change, whereas the cross-phase between local low-k electron temperature and density fluctuations ({alpha}{sub n{sub eT{sub e}}}) was significantly modified. The increase in the electron thermal diffusivity determined from power balance is consistent with the increased turbulent transport correlated with the measured increases in low-k T-tilde{sub e}/T{sub e} and high-k n-tilde{sub e}/n{sub e}. Linear stability analysis using the trapped gyro-Landau fluid (TGLF) model indicates an enhanced growth rate for electron modes [e.g., trapped electron mode (TEM)] at low-k consistent with the observed modifications in T-tilde{sub e}/T{sub e} and {alpha}{sub n{sub eT{sub e}}}. TGLF also predicts an increase in high-k electron mode growth rates for normalized wavenumbers k{sub {theta}}{rho}{sub s} > 7, where electron temperature gradient (ETG) modes exist, which is consistent with the observed increase in high-kn-tilde{sub e}/n{sub e} turbulence.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Advances in validating gyrokinetic turbulence models against L- and H-mode plasmas

Robust validation of predictive turbulent transport models requires quantitative comparisons to experimental measurements at multiple levels, over a range of physically relevant conditions. Toward this end, a series of carefully designed validation experiments has been performed on the DIII-D tokamak [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] to obtain comprehensive multifield, multipoint, multiwavenumber fluctuation measurements and their scalings with key dimensionless parameters. The results of two representative validation studies are presented: an elongation scaling study performed in beam heated L-mode discharges and an electron heating power scan performed in quiescent H-mode (QH-mode) discharges. A 50% increase in the elongation {kappa} is observed to lead to a {approx}50% increase in energy confinement time {tau}{sub e} and accompanying decrease in fluctuation levels, qualitatively consistent with a priori theoretical predictions and nonlinear GYRO [J. Candy and R. E. Waltz, J. Comput. Phys. 186, 545 (2003)] simulations. However, these simulations exhibit clear quantitative differences from experiment in the predicted magnitudes and trends with radius of turbulent fluxes and fluctuation levels which cannot be fully accounted for by uncertainties due to transport stiffness. In the QH-mode study, local nonlinear GYRO simulations that neglect fast ion effects show a similar proportional response to the applied electron cyclotron heating as the experiment, but overpredict the magnitudes of transport and fluctuation levels by a factor of 10 or more. Possible sources of this overprediction, namely nonlocal effects and self-consistent fast beam ions, are identified and discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Balancing Current Drive and Heating in DIII-D High Noninductive Current Fraction Discharges Through Choice of the Toroidal Field

In order to maintain stationary values of the stored energy and the plasma current in a tokamak discharge with all of the current driven noninductively, the sum of the alpha-heating power and the power required to provide externally driven current must be equal to the power required to maintain the pressure against transport losses. In a study of high noninductive current fraction discharges in the DIII-D tokamak, it is shown that in the case of present-day tokamaks with no alpha-heating, adjustment of the toroidal field strength (B(T)) is a tool to obtain this balance between the required current drive and heating powers with other easily modifiable discharge parameters (beta(N), q(95), discharge shape, n(e)) fixed at values chosen to satisfy specific constraints. With all of the external power sources providing both heating and current drive, and beta(N) and q(95) fixed, the fraction of externally driven current scales with B(T) with little change in the bootstrap current fraction, thus allowing the noninductive current fraction to be adjusted.

Ferron, J R↗

Probing plasma turbulence by modulating the electron temperature gradient

The local value of a/L{sub Te}, a turbulence drive term, was modulated with electron cyclotron heating in L-mode discharges on DIII-D [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] and the density and electron temperature fluctuations in low, intermediate, and high-k regimes were measured and compared with nonlinear gyrokinetic turbulence simulations using the GYRO code [J. Candy and R. E. Waltz, J. Comput. Phys. 186, 545 (2003)]. The local drive term at rhoapprox0.6 was reduced by up to 50%, which produced comparable reductions in electron temperature fluctuations at low-k. At intermediate k, k{sub t}hetaapprox4 cm{sup -1} and k{sub t}hetarho{sub s}approx0.8, a very interesting and unexpected result was observed where density fluctuations increased by up to 10% when the local drive term was decreased by 50%. Initial comparisons of simulations from GYRO with the thermal diffusivity from power balance analysis and measured turbulence response are reported. Simulations for the case with the lowest drive term are challenging as they are near the marginal value of a/L{sub Te} for trapped electron mode activity.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Measurements of the cross-phase angle between density and electron temperature fluctuations and comparison with gyrokinetic simulations

This paper presents new measurements of the cross-phase angle, alpha{sub n{sub eT{sub e}}}, between long-wavelength (k{sub t}hetarho{sub s}<0.5) density, n-tilde{sub e}, and electron temperature, T-tilde{sub e}, fluctuations in the core of DIII-D [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] tokamak plasmas. The coherency and cross-phase angle between n-tilde{sub e} and T-tilde{sub e} are measured using coupled reflectometer and correlation electron cyclotron emission diagnostics that view the same plasma volume. In addition to the experimental results, two sets of local, nonlinear gyrokinetic turbulence simulations that are performed with the GYRO code [J. Candy and R. E. Waltz, J. Comput. Phys. 186, 545 (2003)] are described. One set, called the pre-experiment simulations, was performed prior to the experiment in order to predict a change in alpha{sub n{sub eT{sub e}}} given experimentally realizable increases in the electron temperature, T{sub e}. In the experiment the cross-phase angle was measured at three radial locations (rho=0.55, 0.65, and 0.75) in both a 'Base' case and a 'High T{sub e}' case. The measured cross-phase angle is in good qualitative agreement with the pre-experiment simulations, which predicted that n-tilde{sub e} and T-tilde{sub e} would be out of phase. The pre-experiment simulations also predicted a decrease in cross-phase angle as T{sub e} is increased. Experimentally, this trend is observed at the inner two radial locations only. The second set of simulations, the postexperiment simulations, is carried out using local parameters taken from measured experimental profiles as input to GYRO. These postexperiment simulation results are in good quantitative agreement with the measured cross-phase angle, despite disagreements with transport fluxes. Directions for future modeling and experimental work are discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Simultaneous measurement of core electron temperature and density fluctuations during electron cyclotron heating on DIII-D

New measurements show that long-wavelength (k{sub t}hetarho{sub s}<0.5) electron temperature fluctuations can play an important role in determining electron thermal transport in low-confinement mode (L-mode) tokamak plasmas. In neutral beam-heated L-mode tokamak plasmas, electron thermal transport and the amplitude of long-wavelength electron temperature fluctuations both increase in cases where local electron cyclotron heating (ECH) is used to modify the plasma profiles. In contrast, the amplitude of simultaneously measured long-wavelength density fluctuations does not significantly increase. Linear stability analysis indicates that the ratio of the trapped electron mode (TEM) to ion temperature gradient (ITG) mode growth rates increases in the cases with ECH. The increased importance of the TEM drive relative to the ITG mode drive in the cases with ECH may be associated with the increases in electron thermal transport and electron temperature fluctuations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Demonstration of ITER operational scenarios on DIII-D

The DIII-D programme has recently initiated an effort to provide suitably scaled experimental evaluations of four primary ITER operational scenarios. New and unique features of this work are that the plasmas incorporate essential features of the ITER scenarios and anticipated operating characteristics; e. g. the plasma cross-section, aspect ratio and value of I/aB of the DIII-D discharges match the ITER design, with size reduced by a factor of 3.7. Key aspects of all four scenarios, such as target values for beta(N) and H(98), have been replicated successfully on DIII-D, providing an improved and unified physics basis for transport and stability modelling, as well as for performance extrapolation to ITER. In all four scenarios, normalized performance equals or closely approaches that required to realize the physics and technology goals of ITER, and projections of the DIII-D discharges are consistent with ITER achieving its goals of >= 400MW of fusion power production and Q >= 10. These studies also address many of the key physics issues related to the ITER design, including the L-H transition power threshold, the size of edge localized modes, pedestal parameter scaling, the impact of tearing modes on confinement and disruptivity, beta limits and the required capabilities of the plasma control system. An example of direct influence on the ITER design from this work is a modification of the physics requirements for the poloidal field coil set at 15 MA, based on observations that the inductance in the baseline scenario case evolves to a value that lies outside the original ITER specification.

CONFINEMENT↗

Validation of on- and off-axis neutral beam current drive against experiment in DIII-D

Neutral beam current drive (NBCD) experiments in DIII-D using vertically shifted plasmas to move the current drive away from the axis have clearly demonstrated robust off-axis NBCD. Time-dependent measurements of magnetic field pitch angles by the motional Stark effect diagnostic are used to obtain the evolution of the poloidal magnetic flux, which indicates a broad off-axis NBCD profile with a peak at about half the plasma minor radius. In most cases, the measured off-axis NBCD profile is consistent with calculations using an orbit-following Monte Carlo code for the beam ion slowing down including finite-orbit effects provided there is no large-scale magnetohydrodynamic activity such as Alfven eigenmodes modes or sawteeth. An alternative analysis method shows good agreement between the measured pitch angles and those from simulations using transport-equilibrium codes. Two-dimensional image of Doppler-shifted fast ion D{sub {alpha}} light emitted by neutralized energetic ions shows clear evidence for a hollow profile of beam ion density, consistent with classical beam ion slowing down. The magnitude of off-axis NBCD is sensitive to the alignment of the beam injection relative to the helical pitch of the magnetic field lines. If the signs of toroidal magnetic field and plasma current yield the proper helicity, both measurement and calculation indicate that the efficiency is as good as on-axis NBCD because the increased fraction of trapped electrons reduces the electron shielding of the injected ion current, in contrast with electron current drive schemes where the trapping of electrons degrades the efficiency. The measured off-axis NBCD increases approximately linearly with the injection power, although a modest amount of fast ion diffusion is needed to explain an observed difference in the NBCD profile between the measurement and the calculation at high injection power.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Plasma Shape Optimization for Steady-State Tokamak Development in DIII-D

For a more detailed account of the results summarized here and for references, see C.T. Holcomb et al., Phys. Plasmas 16, 056116 (2009). Advanced tokamak research on DIII-D is focused on developing a high fusion gain, steady-state scenario that would eliminate or greatly reduce the demands on an inductive transformer in future machines. Steady-state operation requires the inductively driven current density (j{sub Ind}) be zero everywhere. Most of the total current I{sub p} is typically from self-driven bootstrap current, with the remainder driven by external noninductive sources, such as neutral beam and radiofrequency current drive. This paper describes an extension of the fully noninductive condition (f{sub NI} {approx} 100%) to {approx}0.7 current relaxation times that was achieved by a combination of more available ECCD and new scientific insights. The insights are an optimization of performance through variation of the plasma shape parameter known as squareness ({zeta}) and an optimization of divertor magnetic balance. These optimizations simultaneously improve stability, confinement, and density control. These are each essential for achieving fully noninductive operation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗