Engineering topics

Debra, D. B.

Publications and source records attributed to Debra, D. B..

At least 19 records

NASA NTRS1990

A continuous proportional low-thrust propulsion system

Helium gas flows continuously from a low-temperature dewar supplying propellant for satellite thrusters. Thrust is obtained by movement of a spool located between two opposing nozzles, thus differentially restricting the helium flow. The design procedure and test results of a high bandwidth, low power, linear electromagnetic actuator for the pool movement are presented. Two mathematical models are used to describe the helium flow through the thruster under different flow conditions. The experimental data measured in the vacuum chamber and the computational results from the mathematical models are compared. The models agree with the experiment to 3 percent except near a Knudsen number of 1.

Chen, J.-H.↗

NASA NTRS1985

A simple microgravity table for the Orbiter or Space Station

Methods of limiting perturbations in microgravity experiments are proposed. An acceleration level below 10 to the -4th m/s-squared is necessary to maintain an undisturbed microgravity environment. Machinery vibrations, crew motion, and the firing of vernier thrusters produce acceleration levels greate than 10 to the -4th m/s-squared. The use of a weak spring system or simple electromagnets to isolate an experimental table from these factors is described. The manners in which crew motion and vernier firing are countered by the springs are examined. The steady acceleration caused by atmospheric drag, gravity gradient force, and steady rotation can be maintained below 10 to the -th m/s-squared; however, the springs can protect the table from these accelerations if required.

Garriott, O. K.↗

NASA NTRS1982

Attitude and translation control of a low-altitude Gravsat

Dynamic simulation of the Gravsat's attitude and translation control system is used to provide an upper bound for the fuel supply and test the feasibility of the preliminary design. A preliminary design is made for the disturbance compensation system (DISCOS) sensor, the thruster control laws, reaction wheel control laws, and the onboard state estimators. The sensor analysis and noise measurements show no problems in scaling the Triad navigation satellite sensor design up to meet the Gravsat requirements, except for proof mass center-of-mass offset. A promising technique is proposed to measure and eliminate this error. The covariance analysis confirms that a sophisticated post-flight data fit will be necessary to reconstruct a scientifically useful proof mass state. The DISCOS sensor will have to be continuously calibrated from the inflight data to achieve this reconstruction.

Ray, J. C.↗

NASA NTRS1982

Elastic suspension of a wind tunnel test section

Experimental verification of the theory describing arbitrary motions of an airfoil is reported. The experimental apparatus is described. A mechanism was designed to provide two separate degrees of freedom without friction or backlash to mask the small but important aerodynamic effects of interest.

Hacker, R.↗

NASA NTRS1981

Prediction and experimental verification of transient airfoil motion in a small wind tunnel

The theory for aerodynamic loading associated with transient motion of an airfoil in a wind tunnel has been extended and verified experimentally. A generalized Theodorsen Function which includes wall effects is described, and finite-state approximations are developed for large wing-semichord to wall-spacing ratios. Finally, experimental results are presented which verify the theoretical predictions for transient airfoil motions. These results were obtained using a small, low-subsonic wind tunnel with a unique airfoil suspension design that provides uncoupled sensing and actuation for two degrees of freedom.

Rock, S. M.↗

NASA NTRS1981

Engineering aspects of the Stanford relativity gyro experiment

According to certain theoretical predictions, the Newtonian laws of motion must be corrected for the effect of a gravitational field. Schiff (1960) proposed an experiment which would demonstrate the effect predicted by Einstein's Theory of General Relativity on a gyroscope. The experiment has been under development at Stanford University since 1961. The requirements involved make it necessary that the test be performed in a satellite to take advantage of weightlessness in space. In a discussion of engineering developments related to the experiment, attention is given to the development of proportional helium thrusters, the simulation of the attitude control system, aspects of inner loop control, the mechanization of the two-loop attitude control system, the effects of helium slosh on spacecraft pointing, and the data instrumentation system.

Everitt, C. W. F.↗

NASA NTRS1978

Comments on the drag-free control of a solar probe relativity mission

A spacecraft going within 4 solar radii of the Sun experiences an acceleration up to .00005 g from solar radiation pressure, and significant (though smaller) accelerations from the solar wind. To obtain satisfactory information about relativistic effects and the Sun's quadrupole mass coefficient, these non-gravitational accelerations are either measured or compensated out by making the spacecraft drag free. A proof mass inside the spacecraft structure is shielded from the external forces, so that it follows a nearly ideal gravitational orbit, and a control system activates gas jets (or other translational forcers) to make the vehicle follow the mass. The problems are mechanizing the control laws and minimizing extraneous effects such as the self gravitational pull of the spacecraft. The extraneous forces can be averaged in one plane by having a spinning vehicle.

Everitt, C. W. F.↗

NASA NTRS1977

Study to develop gradiometer techniques

The primary goal of the current gravity gradiometer research at Stanford has been to establish the feasibility of using a gravity gradiometer with 1 E accuracy, as the primary sensor in various applications. The two applications considered here in detail are geodesy missions and inertial navigation systems. Preliminary sections on gravity models and gravity gradiometer bias estimation are also included.

Schaechter, D.↗

NASA NTRS1977

To perform a gyro test of general relativity in a satellite and develop associated control technology

A satellite configuration having two gyroscopes with axes parallel to the boresight of a telescope and two at right angles to the telescope and approximately parallel and perpendicular to the earth's axis is proposed for measuring geodetic precessions due to the earth's motion about the sun, higher order geodetic terms calculated from the earth's quadrapole mass moment (0.010 arc-sec/year in a 400 nautical mile polar orbit), and deflection by the sun of the starlight signal for the reference telescope. Data from the experiment also contain large periodic signals due to the annual and orbital aberrations of starlight which are useful in providing a built in reference signal of known amplitude for scaling the relativity signals, and should yield a singularly precise measurement of the parallax of the reference star. The development of the gyroscope and its readout system are discussed, as well as signal integration, drag-free control, and attitude control.

Fairbank, W. M.↗

NASA NTRS1977

Application of microelectronic technology to general aviation flight control

This paper presents several different methods that can be used to determine the aircraft orientation (attitude) without direct measurement. The methods combine state estimation techniques with measurements from solid state pressure sensors, accelerometers, and magnetometers to determine the aircraft state. The paper demonstrates how the estimation algorithms were validated and compared using flight test data, and it presents results of performance sensitivity analyses of sensor error, modeling inaccuracies, and wind disturbance effects on the attitude estimation errors. If implemented, the methods presented could make it possible to eliminate directional and vertical gyros and to change from many isolated sensors to an integrated, small, reliable sensing package for determining the aircraft state.

Sorensen, J. A.↗

NASA NTRS1976

Control methods for aiding a pilot during STOL engine failure transients

Candidate autopilot control laws that control the engine failure transient sink rates by demonstrating the engineering application of modern state variable control theory were defined. The results of approximate modal analysis were compared to those derived from full state analyses provided from computer design solutions. The aircraft was described, and a state variable model of its longitudinal dynamic motion due to engine and control variations was defined. The classical fast and slow modes were assumed to be sufficiently different to define reduced order approximations of the aircraft motion amendable to hand analysis control definition methods. The original state equations of motion were also applied to a large scale state variable control design program, in particular OPTSYS. The resulting control laws were compared with respect to their relative responses, ease of application, and meeting the desired performance objectives.

Nelson, E. R.↗

NASA NTRS1976

On the applicability of integrated circuit technology to general aviation orientation estimation

The criteria of the significant value of the panel instruments used in general aviation were examined and kinematic equations were added for comparison. An instrument survey was performed to establish the present state of the art in linear and angular accelerometers, pressure transducers, and magnetometers. A very preliminary evaluation was done of the computers available for data evaluation and estimator mechanization. The mathematical model of a light twin aircraft employed in the evaluation was documented, the results of the sensor survey and the results of the design studies were presented.

Debra, D. B.↗

NASA NTRS1976

Exospheric density measurements from the drag-free satellite Triad

The Triad satellite is maintained within 1 mm of its proof mass (a small metal ball) in a purely gravitational orbit, using a drag-free control system, named Discos, as the disturbance compensation system. The Discos proof mass is surrounded by an outer shell which holds fuel tanks and cold gas jets. The shell shields the proof mass from such nongravitational forces as radiation pressure, atmospheric drag, and micrometeorite impact. Whenever these forces displace the outer shell relative to the proof mass, an error signal is generated by a capacitive bridge sensor, and the satellite is propelled by gas jets to remain centered on the proof mass when the error reaches 1 mm. Local atmospheric densities near 800 km were measured, using ball position data, and the observed accelerations were corrected for the effects of solar radiation pressure. The measured densities reveal a greater dependence on latitude than that indicated by balloon satellites, and also a dependence on longitude. Only a small dependence on Kp, however, was observed in the region where the measurements were made.

Moe, K.↗

NASA NTRS1976

Caging Mechanism for a drag-free satellite position sensor

A disturbance compensation system for satellites based on the drag-free concept was mechanized and flown, using a spherical proof mass and a cam-guided caging mechanism. The caging mechanism controls the location of the proof mass for testing and constrains it during launch. Design requirements, design details, and hardware are described.

Hacker, R.↗

NASA NTRS1976

Complex symmetric root square locus with an application to a spinning drag-free satellite

The parameters and relations associated with optimal systems are examined, taking into account a quadratic performance index and a root square locus plot, including the characteristic roots of the optimal system and its adjoint system as a function of the cost function weights. The calculation of the locus is described and the employment of the considered relations in studies of a drag-free satellite is discussed. Attention is given to weights regarding the initial states, questions of rotating integral control, approaches for experimental verification, and the performance of various methods for the reduction of fuel consumption due to center of spin offsets.

Tashker, M. G.↗

NASA NTRS1975

Perform a gyro test of general relativity in a satellite and develop associated control technology

The progress accomplished in the Stanford Gyro Relativity program during the period November 1974 to October 1975 was described. Gyro developments were continued in the main laboratory dewar, concentrating on the operation of a three axis gyro readout and on improvements to the methods of canceling trapped fields in the rotor; these efforts culminated in the first successful observation of the London moment in the spinning gyro rotor in March 1975. Following a review meeting at that time, a new goal was formulated for the next 12 to 18 months, namely to operate a gyroscope in the new ultra-low field facility with readout resolution approaching 1 arc-second. The following other tasks were also completed: (1) sputtering work, (2) magnetometry, (3) construction and installation of the North Star simulator, (4) analysis of torques on the gyro, especially in inclined orbits, (5) equivalence principle accelerometer, and (6) analysis of a twin-satellite test of relativity.

Fairbank, W. M.↗

NASA NTRS1975

Attitude translation coupling in a rotating drag-free satellite

The translational and attitude control of a drag-free, rotating satellite are usually designed to be independent of each other. However, coupling may exist which can produce instability. The different types of coupling and the stability conditions are studied, using root locus type techniques. The resulting root loci have unusual shapes due to the nonlinearity of the characteristic polynomial in terms of the coupling parameters. It is possible, however, to use standard root loci techniques by appropriate factoring and subsequent superposition of loci. The effect of the main parameters upon the overall stability of the system is studied. Both, attitude and translation instabilities eventually arise - the former being more critical for typical satellite designs. An analytical expression for the stability boundary is developed.

Sanz Fernandez De Cordova, S.↗

NASA NTRS1975

Mass center estimation of a drag-free satellite

The mass center location of a spinning drag-free satellite can be estimated because there is control required to accelerate the mass center along the axis of spin as long as there is some nutation in the spinning motion. Linear and nonlinear models are compared and observability discussed. Online estimation fails when nutation is damped so an offline mechanization is proposed. A new sensor has been designed to permit greater relative motion than was possible on the drag-free satellite flown in 1972 (JH-1). Experimental laboratory results using a spinning vehicle with the new sensor mounted 30 cm from a spherical air bearing support are presented which confirm earlier simulation results.

Sanz Fernandez De Cordova, S.↗