Engineering topics

Del Castillo, Hector M.

Publications and source records attributed to Del Castillo, Hector M..

3 records

NASA NTRS1997

Long-wavelength PTSI infrared detectors and method of fabrication thereof

Extended cutoff wavelengths of PtSi Schottky infrared detectors in the long wavelength infrared (LWIR) regime have been demonstrated for the first time. This result was achieved by incorporating a 1-nm-thick p+ doping spike at the PtSi/Si interface. The extended cutoff wavelengths resulted from the combined effects of an increased electric field near the silicide/Si interface due to the p+ doping spike and the Schottky image force. The p+ doping spikes were grown by molecular beam epitaxy at 450 degrees Celsius using elemental boron as the dopant source, with doping concentrations ranging from 1.times.10.sup.19 to 1.times.10.sup.21 cm.sup.-3. The cutoff wavelengths were shown to increase with increasing doping concentrations of the p+ spikes.

Lin, True-Lon↗

NASA NTRS1992

Digital Extraction Of Doppler Shift In An Advanced Receiver

Report describes demonstration of ability of Advanced Receiver II (ARX II) to extract Doppler shifts in radio telemetry signals from spacecraft by digital processing. Frequency of sampling clock fixed and derived from frequency-and-timing subsystem. Although this can result in noninteger number of samples per symbol, it enables digital extraction of Doppler shift. ARX II operates with older receiver called "Block IV". ARX II performed at least as well as, and in most cases better than, Block IV.

Hinedi, Sami M.↗

NASA NTRS1991

Digital Doppler measurement with spacecraft

Digital and analog phase-locked loop (PLL) receivers were operated in parallel, each tracking the residual carrier from a spacecraft. The PLL tracked the downlink carrier and measured its instantaneous phase. This information, combined with a knowledge of the uplink carrier and the transponder ratio, permitted the computation of a Doppler observable. In this way, two separate Doppler measurements were obtained for one observation window. The two receivers agreed on the magnitude of the Doppler effect to within 1 mHz. There was less jitter on the data from the digital receiver. This was due to its smaller noise bandwidth. The demonstration and its results are described.

Kinman, Peter W.↗