Engineering topics

Demetriades, A.

Publications and source records attributed to Demetriades, A..

3 records

NASA NTRS1990

Transition in high-speed free shear layers

The laminar free-shear layers considered in the study are formed by combinations of the velocities and momentum thicknesses of two adjacent parallel flows. Transition in wakes, pure free-shear layers of the Chapman type, and separate and partition flows are discussed. A stability-transition connection is emphasized, and it is suggested that a recurring deficiency in some stability calculations is the use of overly simplified laminar profiles. It is also noted that physical principles can be used for estimating the transition location or providing the factors affecting it. One such approach, a threshold theory, is discussed by way of example.

Demetriades, A.↗

NASA NTRS1985

Mean-flow measurements in a supersonic three-dimensional turbulent boundary layer

Measurements are presented of the mean flow in a supersonic turbulent boundary layer subjected to a constant weak transverse pressure gradient. The temperature and longitudinal velocity and the axial shear stress were only slightly affected by the three-dimensionality but a clearly defined crossflow component appeared, in the manner suggested by theory and confirmed in earlier experiments. The flow deflection angle and transverse-velocity component achieved a self-preserving form so long as the transverse-pressure gradient remained constant, and both achieved a maximum at the sublayer edge; the deflection angle seemed to decrease again between the latter and the surface. An empirical relation was found between the pressure-gradient strength and the maximum in the crossflow, and the dependence of the latter on distance from the surface was used to test analytical crossflow predictions. The data are in general agreement with Van Den Berg's law of the wall. The data also support the so-called parabolic law following a relaxation distance, especially if inviscid gradients are accounted for, and if the normal coordinate is contracted by the compressibility transformation.

Demetriades, A.↗

NASA NTRS1979

Turbulent shear stresses in compressible boundary layers

Hot-wire anemometer measurements of turbulent shear stresses in a Mach 3 compressible boundary layer were performed in order to investigate the effects of heat transfer on turbulence. Measurements were obtained by an x-probe in a flat plate, zero pressure gradient, two dimensional boundary layer in a wind tunnel with wall to freestream temperature ratios of 0.94 and 0.71. The measured shear stress distributions are found to be in good agreement with previous results, supporting the contention that the shear stress distribution is essentially independent of Mach number and heat transfer for Mach numbers from incompressible to hypersonic and wall to freestream temperature ratios of 0.4 to 1.0. It is also found that corrections for frequency response limitations of the electronic equipment are necessary to determine the correct shear stress distribution, particularly at the walls.

Laderman, A. J.↗