Search NASA⌕ Search

Engineering topics

Dera, Przemyslaw

Publications and source records attributed to Dera, Przemyslaw.

Graphene Activated Magnesium Diboride for Moderate Pressure and Temperature Hydrogenation to Magnesium Borohydride

The hydrogenation conditions of magnesium diboride (MgB2) to magnesium borohydride (Mg(BH4)2) can be significantly enhanced through the discovery of improved modifiers. This study demonstrates that the modification of MgB2 by mechanical milling with graphene nanoplatelets significantly reduces the hydrogenation conditions of MgB2 from 900 bar and 400 degrees C for pure MgB2 to 400 bar and 300 degrees C while achieving 77% conversion to Mg(BH4)2. The introduction of the graphene additives coupled with milling leads to a reduction of the temperature and pressure required for bulk hydrogenation by 100 degrees C and 500 bar, respectively, from that of pure MgB2. The identification of graphene additives that drastically improve the hydrogenation conditions of MgB2 represents an important step toward improving hydrogen uptake kinetics to Mg(BH4)2.

complex hydrides↗

Fast Seismic Anomalies Under Continents Explained by the Delaminated Lower Continental Crust—Implications From High Pressure‐Temperature Elasticity of Jadeite

Seismic tomography has shown that the shear wave velocities (Vs) under continents, especially under cratons, are extremely fast at 100–200 km depth, which is difficult to explain by low temperatures or high Mg#. Alternatively, delaminated eclogitic lower continental crust has been proposed to account for these fast seismic anomalies. However, the thermoelastic properties of jadeite which constitutes up to 60–80 mol% of clinopyroxene in the potentially delaminated lower continental crust are not well constrained. In this study, we measured the single-crystal elasticity of jadeite by Brillouin spectroscopy under simultaneous high pressure and temperature conditions for the first time. We found that the temperature dependence of Vs of jadeite is extremely small if not negligible. The seismic velocities of the potentially delaminated lower continental crusts were subsequently modeled and found to match the widely observed fast seismic anomalies under cratons between 100 and 200 km depth.

Geology↗

Pressure-induced phase transitions in Ni-bearing ferrosilite (Ni-En31Fs65)

Abstract Orthopyroxene is an abundant mineral in subducting slabs. Studying its phase transitions at high pressure is important to the understanding of mineralogy of subducting slabs in the deep Earth. Synchrotron-based single-crystal X-ray diffraction experiments were conducted on a synthetic Ni-bearing ferrosilite (Ni-En31Fs65) at pressures up to 33.8 GPa. Three phase transitions were observed at 12.1(6), 15.6(6), and 31.3(25) GPa. The first two phase transitions in Ni-En31Fs65 resemble the previously described phase transitions in Ni-free Fe-rich orthopyroxenes, i.e., the initial α-opx (Pbca) transforms to β-opx (P21/c), then the latter transforms to γ-opx (Pbca). This indicates that the incorporation of a few mol% NiSiO3 does not influence the phase transition path of Fe-rich orthopyroxene. After the third phase transition, the structure (P21ca) of Ni-En31Fs65 resembles the previously reported β-popx observed in En90 at high pressure, although the onset pressure of the phase transition in Ni-En31Fs65 is ~7 GPa lower than that in En90. β-popx has a post-pyroxene structure that contains fivefold- and sixfold-coordinated Si cations. Our results indicate that the post-pyroxene structure is β-popx (P21ca) for either Fe-poor or Fe-rich orthopyroxenes, although the phase transition path before the pyroxene → post-pyroxene is compositionally dependent. Additionally, unlike the second and third transitions, whose onset pressures are monotonously decreased by increasing Fe content, the Fe effect on shifting the first transition is much more significant for orthopyroxenes within En <50 mol% than that within En >50 mol%.

Geochemistry & Geophysics↗