Dibble, Robert | Search NASA

DOE OSTI2018

The Influence of Intake Pressure and Ethanol Addition to Gasoline on Single- and Dual-Stage Autoignition in an HCCI Engine

Autoignition in HCCI engines is known to be controlled by the combustion kinetics of the in-cylinder fuel/air mixture which is highly influenced by the amount of low-temperature and intermediate-temperature heat release (LTHR and ITHR) that occurs. At lower intake pressures (typically <1.4 bar absolute), it has been observed that gasoline behaves as a single-stage heat release fuel, while at higher intake pressures (typically >1.8 bar absolute) gasoline behaves as a two-stage heat release fuel. Furthermore, ethanol blending into gasoline strongly affects heat release characteristics, and this warrants further investigation. This paper experimentally investigates the conditions under which gasoline transitions from a single-stage heat release fuel to a two-stage heat release fuel as intake pressure is increased. Experiments were performed in single-cylinder HCCI engine fueled with two research-grade gasolines, FACE A and FACE C. These gasolines were tested neat, and with 10% and 20% (by volume) ethanol addition. In addition, these results were compared to results previously obtained for PRF 85, and new results for PRF 84 with 10% and 20% ethanol addition. Moreover, the engine experiments were supported by rapid compression machine (RCM) ignition delay data for the same fuels. The engine experiments revealed that there were minimal differences between the heat release profiles of the two gasolines, FACE A and FACE C, a result which was supported by the RCM experiments that showed similar ignition delay times for the two FACE fuels and PRF 84. On the other hand, with ethanol addition to these gasolines and PRF 84, the occurrence of LTHR shifted to higher intake pressures compared to ethanol-free cases, from 1.4 bar intake pressure for neat fuel to 2.2 bar with 20% ethanol. Consequently, the intake temperatures required to achieve constant combustion phasing for all mixtures were drastically altered. Simulations using a detailed chemical kinetic model were utilized to understand the effects of ethanol blending on the ignition characteristics of PRF 84. The addition of ethanol was found to act as a radical sink where it inhibits the radical pool formation during the low (<850 K) and intermediate (850–1050 K) temperature chemistry regimes resulting in lower reactivity. These results help explain ethanol’s significant antiknock qualities under boosted conditions in spark-ignition engines.

42 ENGINEERING↗

DOE OSTI2016

Predictive Engineering Tools for Novel Fuels

This project was funded through the Campus Executive Fellowship at University of California (UC) Berkeley, and had two principal aims. First, it sought to explore predictive tools for estimating fuel properties based on molecular structure, with the goal of identifying promising candidates for new fuels to be synthesized. Second, it sought to investigate the possibility of increasing engine efficiency by substituting air for a working fluid with higher efficiency potential employed in a closed loop, namely a mixture of argon and oxygen. In pursuing the predictive tool for novel fuels, a new model was built that proved to be highly predictive of autoignition characteristics for a wide variety of hydrocarbons, esters, ethers and alcohols, and reasonably predictive for furan and tetrahydrofuran compounds, the target class of novel fuels. Obtaining more “training data” for the model improved its predictive capabilities, and further reductions in the uncertainty of the predictions would be possible with more training data. In investigating the concept of a closed-loop engine cycle using an argon-oxygen working fluid, substantial progress was made. Initial engineering models were built showing the feasibility of the concept; numerous collaborations were formed with industry and academic partners; external funding was secured from the California Energy Commission (CEC) to build a dedicated engine platform for research; and this engine platform was designed and constructed. Experimental work and associated modeling studies will take place in late 2016 and early 2017.

10 SYNTHETIC FUELS↗