Search NASASearch

Engineering topics

Dickinson, H C

Publications and source records attributed to Dickinson, H C.

Comparison of hecter fuel with export aviation gasoline

Among the fuels which will operate at compression ratios up to at least 8.0 without preignition or "pinking" is hecter fuel, whence a careful determination of its performance is of importance. For the test data presented in this report the hecter fuel used was a mixture of 30 per cent benzol and 70 per cent cyclohexane, having a low freezing point, and distilling from first drop to 90 per cent at nearly a constant temperature, about 20 degrees c. below the average distillation temperature ("mean volatility") of the x gasoline (export grade). The results of these experiments show that the power developed by hecter fuel is the same as that developed by export aviation gasoline at about 1,800 r.p.m. at all altitudes. At lower speeds differences in the power developed by the fuels become evident. Comparisons at ground level were omitted to avoid any possibility of damaging the engine by operating with open throttle on gasoline at so high a compression. The fuel consumption per unit power based on weight, not volume, averaged more than 10 per cent greater with hecter than with x gasoline. The thermal efficiency of the engine when using hecter is less than when using gasoline, particularly at higher speeds. A generalization of the difference for all altitudes and speeds being 8 per cent. A general deduction from these facts is that more hecter is exhausted unburnt. Hecter can withstand high compression pressures and temperature without preignition. (author)

Dickinson, H C

A High-speed Engine Pressure Indicator of the Balanced Diaphragm Type

This report describes a pressure-measuring device especially adapted for use in mapping indicator diagrams of high-speed internal combustion engines. The cards are obtained by a point-to-point method giving the average of a large number of engine cycles. The principle involved is the balancing of the engine cylinder pressure against a measured pressure on the opposite side of the metal a diaphragm of negligible stiffness. In its application as an engine indicator the phase of the engine cycle to which a pressure measurement corresponds is selected by a timing device. The report discusses briefly the errors which must be avoided in the development of an indicator for light high-speed engines, where vibration is serious, and outlines the principles underlying the design of this instrument in order to be free of such errors. A detailed description of the instrument and accessories follows together with operating directions.

Dickinson, H C

Synopsis of aeronautic radiator investigations for years 1917 and 1918

Extensive series of experiments have been conducted at the Bureau of Standards to determine the properties of cooling radiator cores manufactured for airplanes and to develop improvements in design. The analysis of the problem on which this work was based, and consequently the experimental method employed, is different from that commonly used. Instead of attempting to test complete radiators, either full size or in model, uniform sections representing different types of core construction have been tested and an analysis of the results made with a view to determining independently the various factors which influence its performance. This report describes referenced method of analysis in predicting the performance of radiators designed for aeronautic use.

Dickinson, H C

The Altitude Laboratory for the Test of Aircraft Engines

Report presents descriptions, schematics, and photographs of the altitude laboratory for the testing of aircraft engines constructed at the Bureau of Standards for the National Advisory Committee for Aeronautics.

Dickinson, H C

Spark Plug Defects and Tests

The successful operation of the spark plug depends to a large extent on the gas tightness of the plug. Part 1 of this report describes the method used for measuring the gas tightness of aviation spark plugs. Part 2 describes the methods used in testing the electrical conductivity of the insulation material when hot. Part 3 describes the testing of the cold dielectric strength of the insulation material, the resistance to mechanical shock, and the final engine test.

Silsbee, F B

Results of Tests on Radiators for Aircraft Engines

Part 1 is to present the results of tests on 56 types of core in a form convenient for use in the study of the performance of and possible improvements in existing designs. Working rules are given by which the data contained in the report may be used, and the most obvious conclusions as to the behavior of cores are summarized. Part 2 presents the results of tests made to determine the pressure necessary to produce water flows up to 50 gallons per minute through an 8-inch square section of radiator core. These data are of special value in evaluating the hydraulic head against which the circulating pump is required to operate.

Dickinson, H C

Effect of Compression Ratio, Pressure, Temperature, and Humidity on Power

Among other factors which affect the horsepower of an airplane engine are the atmospheric pressure, and consequently the altitude at which the engine is working, and the compression ratio, or cylinder volume divided by clearance volume. The tests upon which this report is based were selected from a large number of runs made during the intercomparison of various gasolines to determine the variation of horsepower with altitude at three different compression ratios. The test results and conclusions are presented in this report.

Dickinson, H C

Metering Characteristics of Carburetors

Report presents the results of an extensive experimental investigation of the performance of different types of carburetors as effecting the maintenance under all conditions of correct ratio between the weights of fuel and air. It also gives a description of the Bureau of Standards carburetor test plant, test equipment and measuring instruments used to determine the metering characteristics of carburetors.

Tice, Percival S

General Analysis of Airplane Radiator Problems

Report embodies the results of a very extensive research, both theoretical and experimental, into the problems involved in the dissipation of heat by means of the airplane radiator.

Dickinson, H C

General Discussion of Test Methods for Radiators

Report describes the methods and apparatus developed and used in the extensive experimental research into the problems involved in the dissipation of heat by means of the airplane radiator.

Dickinson, H C

Aeronautic Power Plant Investigations

Report presents the design of radiators, spark plugs and test equipment used to test the performance of aeronautic engines at high altitudes.

Dickinson, H C