Search NASASearch

Engineering topics

Diem, H. G.

Publications and source records attributed to Diem, H. G..

Orbit transfer vehicle advanced expander cycle engine point design study. Volume 2: Study results

The design characteristics of the baseline engine configuration of the advanced expander cycle engine are described. Several aspects of engine optimization are considered which directly impact the design of the baseline thrust chamber. Four major areas of the power cycle optimization are emphasized: main turbine arrangement; cycle engine source; high pressure pump design; and boost pump drive.

Diem, H. G.

Linear aerospike engine study

Parametric data on split-combustor linear engine propulsion systems are presented for use in mixed-mode single-stage-to-orbit (SSTO) vehicle studies. Preliminary design data for two selected engine systems are included. The split combustor was investigated for mixed-mode operations with oxygen/hydrogen propellants used in the inner combustor in Mode 2, and in conjunction with either oxygen/RP-1, oxygen/RJ-5, O2/CH4, or O2/H2 propellants in the outer combustor for Mode 1. Both gas generator and staged combustion power cycles were analyzed for providing power to the turbopumps of the inner and outer combustors. Numerous cooling circuits and cooling fluids (propellants) were analyzed and hydrogen was selected as the preferred coolant for both combustors and the linear aerospike nozzle. The maximum operating chamber pressure was determined to be limited by the availability of hydrogen coolant pressure drop in the coolant circuit.

Diem, H. G.

Design of inducers for two-phase operation

A mathematical model and a digital computer program were developed for the design and evaluation of inducers for pumping two-phase oxygen. The mathematical model indicated that any design would have to be run at relatively low speeds to pump two-phase oxygen and that the J-2S oxygen inducer was close to optimum and should perform the task. A J-2S pump was built up and tested in two-phase oxygen at speeds indicated by the mathematical model. The pump was able to handle two-phase oxygen over a wide range of inducer incidence angles and up to a vapor content of 37 percent by volume with very little loss in head. The pump was still able to produce some head at vapor fractions approaching 60 percent.

King, J. A.

Cast segment evaluation

Evaluation program to determine feasibility of fabricating segmented rocket engine thrust chambers using low cost, lightweight castings extends state of the art in areas of casting size and complexity, and in ability to provide thin sections and narrow, deep, cooling channels. Related developments are discussed.

Diem, H. G.