Engineering topics

Diskin, Glenn S.

Publications and source records attributed to Diskin, Glenn S..

39 records · Page 3

NASA NTRS1987

Dual Stokes cars measurements in supersonic combusting flow

Coherent antiStokes Raman spectroscopy (CARS) was used to make simultaneous measurements of temperature, nitrogen and oxygen density in a reacting supersonic flow. A supersonic burner (SSB) was designed to provide supersonic flow in which combustion can be studied in the laboratory. Measurements made with the CARS system will be used for validation of computational fluid dynamic (CFD) codes. Preliminary results of the CFD calculations are presented.

Jarrett, Olin, Jr.↗

NASA NTRS1987

Mach 2 combustion characteristics of hydrogen/hydrocarbon fuel mixtures

The combustion of H2/CH4 and H2/C2H4 mixtures containing 10-70 vol pct hydrocarbon at cumbustor inlet Mach number 2 and temperatures 2000-4000 R is investigated experimentally, applying direct-connect test hardware and techniques similar to those described by Diskin and Northam (1987) in the facilities of the NASA Langley Hypersonic Propulsion Branch. The experimental setup, procedures, and data-reduction methods are described; and the results are presented in extensive tables and graphs and characterized in detail. Fuel type and mixture are found to have little effect on the wall heating rate measured near the combustor exit, but H2/C2H4 is shown to burn much more efficiently than H2/CH4, with no pilot-off blowout at equivalence ratios greater than 0.5. It is suggested that H2/hydrocarbon mixtures are feasible fuels (at least in terms of combustion efficiency) for scramjet SSTO vehicles operating at freestream Mach numbers above 4.

Diskin, Glenn S.↗

NASA NTRS1987

Effects of scale on supersonic combustor performance

A series of tests has been carried out to investigate the effects of various scale parameters on the direct connect scramjet combustor performance. The calculated combustion efficiency appears to be independent of scale for the same geometry, but tests with more precise scaling of the entire combustor are required to verify this. Combustion, however, can be strongly dependent on geometry for the same scale. It is suggested that the beneficial aspects of certain geometric or scale variations can be combined to improve the overall performance.

Diskin, Glenn S.↗