Engineering topics

Divan, Ralu

Publications and source records attributed to Divan, Ralu.

10 records

DOE OSTI2026

Magnonic spontaneous oscillation induced by parametric pumping

Spontaneous dynamic systems have attracted significant attention for their rich underlying physics such as phase-locking and synchronization. In this work, we report a new mechanism of generating magnetic spontaneous oscillation via parametric pumping. By applying a pump tone to excite propagating spin waves in a yttrium iron garnet delay line, four-wave mixing converts the pump mode into two phase-autonomous propagating magnon modes, i.e. a spontaneous mode with nearly twice the wavenumber of the pump mode and an idler mode with nearly zero wavenumber. This allows us to reliably generate ultrasharp spin wave dynamics with broad frequency tunability from the pump and magnetic field. We show that the spontaneous mode can be phase-locked to a probe tone, similar to an auto-oscillator. Furthermore, the spontaneous dynamics can be used to implement a high-gain magnonic parametric amplifier with a gain up to 40 dB. Our results open a new avenue for studying nonlinear magnonics and synchronization physics in propagating magnon geometry and for developing new magnonic devices.

Li, Yi↗

DOE OSTI2025

Single-shot electrical detection of short-wavelength magnon pulse transmission in a magnonic thin-film waveguide

Abstract The advance of magnon spintronics requires understanding of time-domain magnon pulse transmission in order to develop high-speed information processing protocols. In this work, we demonstrate single-shot electrical detection of narrow-band magnon pulse transmission in a yttrium iron garnet thin-film delay line. The high signal-to-background ratio of magnon transmission band allows us to directly probe the magnon transmission electrically using a fast oscilloscope and to study its spectral evolution using Fast Fourier Transform (FFT) of the time-domain transmitted signal. At elevated input power, we show a magnon transmission reduction and a spectral distortion, which can be understood by the nonlinear magnon excitation in the transmission band defined by the antenna geometry. In addition, we also find that the higher- (lower-) frequency magnon spectral component exhibits a lower (higher) magnon group velocity, showing a dispersion agreeing with the Damon-Eshbach dependence. Our results provide important guidance of magnon pulse engineering for their applications in spin wave computing and coherent magnon information processing.

Song, Moojune↗

DOE OSTI2024

Mechanical properties of freestanding few-layer graphene/boron nitride/polymer heterostacks investigated with local and non-local techniques

van der Waals two-dimensional materials and heterostructures combined with polymer films continue to attract research attention to elucidate their functionality and potential applications. This study presents the fabrication and mechanical testing of 2D material heterostacks, consisting of few-layer boron nitride and graphene heterostructures synthesized via chemical vapor deposition, capped with a polymethyl methacrylate layer and suspended across ∼200 μm wide trenches using a combined wet–dry transfer method. The mechanical characterization of the heterostacks was performed using two independent approaches: (a) non-local testing with a custom-built tensile testing platform and (b) local load–displacement testing employing atomic force microscopy probes, complemented by finite element simulations. Both approaches provided new results, which are in good agreement with each other. Overall, our findings offer new insights into a combined load capacity in complex multi-material two-dimensional systems, and can contribute to advancing micro and nano-scale device designs and implementations.

Lespasio, Marcus↗

DOE OSTI2024

Microwave Flow Cytometric Detection and Differentiation of Escherichia coli

Label-free measurement and analysis of single bacterial cells are essential for food safety monitoring and microbial disease diagnosis. We report a microwave flow cytometric sensor with a microstrip sensing device with reduced channel height for bacterial cell measurement. Escherichia coli B and Escherichia coli K-12 were measured with the sensor at frequencies between 500 MHz and 8 GHz. The results show microwave properties of E. coli cells are frequency-dependent. A LightGBM model was developed to classify cell types at a high accuracy of 0.96 at 1 GHz. Thus, the sensor provides a promising label-free method to rapidly detect and differentiate bacterial cells. Nevertheless, the method needs to be further developed by comprehensively measuring different types of cells and demonstrating accurate cell classification with improved machine-learning techniques.

59 BASIC BIOLOGICAL SCIENCES↗

DOE OSTI2024

Extended Kohler's rule of magnetoresistance in TaCo 2 Te 2

TaCo 2 Te 2 is recently reported to be an air-stable, high mobility van der Waals material with probable magnetic order. Here we investigate the scaling behavior of its magnetoresistance. Here we measured both the longitudinal (p xx ) and Hall (p xy ) magnetoresistivities of TaCo 2 Te 2 crystals in magnetic fields parallel to the c axis and found that the magnetoresistance violates the Kohler's rule MR similar to f [H/p 0 ] while obeying the extended Kohler's rule MR ~ f [H/(n T p 0 )], where MR ~ [p xx (H) - p 0 ]/p 0 , H is the magnetic field, n T is a thermal factor, and p xx (H) and p 0 are the resistivities at H and zero field, respectively. Further, while deviating from those of the densities of electrons (n e ) and holes (n h ) obtained from the two-band model analysis of the magnetoconductivities, the temperature dependence of n T is close to that of the Hall carrier densities n H calculated from the slopes of p xy (H) curves at low magnetic fields, providing a different way to obtain the thermal factor in the extended Kohler's rule.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Sequential infiltration of two-photon polymerized 3D photonic crystals for mid-IR spectroscopic applications

Photonic crystals (PhCs) are spatially organized structures with lattice parameters equivalent to the operational wavelength of light. PhCs have been subject to extensive research efforts in the last two decades and are known for controlling light propagation with applications in sensing and time-delayed communication due to the slow-light phenomenon. Despite their exceptional properties, PhCs are difficult to fabricate using planar micromachining techniques due to their periodic structures. Techniques like two-photon stereolithography have been discussed for PhC fabrication in the literature, but the inherent disadvantage of poor refractive index (RI) contrast results in limited application. In this work, we present sequential infiltration synthesis performed on two-photon stereolithographically printed 3D PhCs for infiltration with zinc oxide to increase the RI of 3D PhCs. Further, finite element analysis was performed over a range of RI contrast values to study the change in photonic bandgap (PBG) with RI contrast. The transmission spectra were recorded on 3D PhCs before and after infiltration to demonstrate the change experimentally. An increase in the PBG width and absorbance is seen postinfiltration due to enhanced RI. This work presents the first, to our knowledge, sequentially infiltrated enhanced 3D PhC fabricated with two-photon stereolithography.

3D printing↗

DOE OSTI2023

Nanofabrication and Demonstration of a Direct-Write Microevaporator

Direct-write vapor deposition is a new technique that would enable one-step 3D maskless nanofabrication on a variety of substrates. A novel silicon chip-based microevaporator is developed that allows evaporant to exit through 2000–300 nm nozzles while held at distances comparable to the nozzle diameter from the substrate by a three-axis nanopositioning stage in vacuum. This results in a localized deposition on the substrate, which may be scanned relative to the substrate to produce direct-write patterns. The performance of the microevaporator is tested by creating localized depositions of various materials and the line-writing potential is demonstrated. The relationship between linewidth and source-to-substrate distance is investigated by the application of Knudsen's cosine law and Monte-Carlo simulations, and then utilized to approximate the source-to-substrate distance from performed depositions.

36 MATERIALS SCIENCE↗

DOE OSTI2023

Shape tuning of large area silicon nanotip arrays through reactive ion etching

Nanostructures formed in silicon form an important class of structures that span a broad spectrum of application areas. Of these, columnar structures of silicon featuring tiplike apexes have their own niche applications. Here, the ability to afford shape tunability for these structures further enhances their application potential. In this paper, we present our findings on the large area fabrication of silicon nanotips defined through microsphere lithography and shape tuned through a combination of different reactive ion etching (RIE) techniques. The self-sharpening mechanism of the tips when using nonplanar etch masks (microspheres) under anisotropic etching conditions is elucidated. We further show that depending on the manner of etching (continuous versus discrete multistep etch), identical anisotropic etching recipes produce vastly different tip morphologies. Hourglass-shaped silicon tips were obtained when silicon was subjected to anisotropic followed by isotropic etching conditions. Sharp silicon tips with tip apex radii on the order of 2 nm have been successfully realized when the RIE shape tuned tips were subjected to a series of oxidative sharpening steps.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2023

Tunable nanotextured materials

A material with nanopillar structures extending from a substrate. The nanopillars are engageable by organisms to cause an interaction, such as cellular destruction.

Laible, Philip D.↗

DOE OSTI2023

Field orientation dependent magnetic phases in the Weyl semimetal Co 3 ⁢Sn 2 ⁢S 2

Magnetism plays a key role in the emergence of topological phenomena in the Weyl semimetal Co 3 ⁢Sn 2 ⁢S 2 , which exhibits ferromagnetic interactions along the c-axis of the crystal and antiferromagnetic (AFM) interactions within the ab plane. Extensive studies on the temperature dependence of the magnetism with the magnetic field along the c-axis have uncovered a number of magnetic phases. Currently, the nature and origins of the reported magnetic phases are under debate. Here, in this work, we report on magnetic field orientation effects on the magnetism in Co 3 ⁢Sn 2 ⁢S 2 . The shape of the hysteresis loop of the Hall resistance at a fixed temperature is found to change from rectangular to bow tie-like as the magnetic field is tilted from the c-axis toward the ab plane, resembling that reported for magnetic fields along the c-axis as the temperature approaches the Curie temperature from below. Unlike their temperature-dependent counterparts, the newly observed bow tie-like hysteresis loops show exchange bias. Our results showcase the contribution of the in-plane AFM interactions to the magnetism in Co 3 ⁢Sn 2⁢ S 2 and demonstrate a new way to tune its magnetic phases. They also shed light on the temperature-dependent magnetic phases occurring in the magnetic field along the c-axis of the crystal.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗