A three wavelength scheme to optimize hohlraum coupling on the National Ignition Facility
Abstract not provided
Engineering topics
Publications and source records attributed to Dixit, S.
Abstract not provided
Abstract not provided
The Hohlraum energetics experimental campaign started in the summer of 2009 on the National Ignition Facility (NIF) [E. I. Moses et al., Phys. Plasmas 16, 041006 (2009)]. These experiments showed good coupling of the laser energy into the targets [N. Meezan et al., Phys. Plasmas 17, 056304 (2010)]. They have also demonstrated controlled crossed-beam energy transfer between laser beams as an efficient and robust tool to tune the implosion symmetry of ignition capsules, as predicted by earlier calculations [P. Michel et al., Phys. Rev. Lett. 102, 025004 (2009)]. A new linear model calculating crossed-beam energy transfer between cones of beams on the NIF has been developed. The model has been applied to the subscale Hohlraum targets shot during the National Ignition Campaign in 2009. A good agreement can be found between the calculations and the experiments when the impaired propagation of the laser beams due to backscatter is accounted for.
The first series of experiments of the National Ignition Facility (NIF) [E. I. Moses et al., Phys. Plasmas 16, 041006 (2009)] tested ignition Hohlraum 'energetics', a term described by four broad goals: (1) measurement of laser absorption by the Hohlraum; (2) measurement of the x-ray radiation flux (T{sub RAD}{sup 4}) on the surrogate ignition capsule; (3) quantitative understanding of the laser absorption and resultant x-ray flux; and (4) determining whether initial Hohlraum performance is consistent with requirements for ignition. This paper summarizes the status of NIF Hohlraum energetics experiments. The Hohlraum targets and experimental design are described, as well as the results of the initial experiments. The data demonstrate low backscattered energy (<10%) for Hohlraums filled with helium gas. A discussion of our current understanding of NIF Hohlraum x-ray drive follows, including an overview of the computational tools, i.e., radiation-hydrodynamics codes that have been used to design the Hohlraums. The performance of the codes is compared to x-ray drive and capsule implosion data from the first NIF experiments. These results bode well for future NIF ignition Hohlraum experiments.
The hohlraum energetics experimental campaign started in the summer of 2009 on the national Ignition Facility (NIF) (cf. N. Meezan et al., Phys. Plasmas, this issue). These experiments have demonstrated controlled crossed-beam transfer as an efficient and robust tool to tune the implosion symmetry of ignition capsules. A new linear model calculating crossed-beam energy transfer between cones of beams on the NIF has been developed. The model has been applied to the emulator targets shot for the National Ignition Campaign in 2009. These targets have no lip liner at the laser entrance holes, which reduces the amount of energy transfer between laser beams and requires a larger wavelength separation between the cones of laser beams in order to achieve the best symmetry (with no net transfer between the inner and outer cones). A good agreement is found between the calculations and measurements; remaining discrepancies can be explained by a 10% error in modeling the flow at the laser entrance hole of ignitions hohlraums.
High-iron sediments in North Haiwee Reservoir (Olancha, CA), resulting from water treatment for removal of elevated dissolved arsenic in the Los Angeles Aqueduct system, were studied to examine arsenic partitioning between solid phases and porewaters undergoing shallow burial. To reduce arsenic in drinking water supplies, ferric chloride and a cationic polymer coagulant are added to the aqueduct upstream of Haiwee Reservoir, forming an iron-rich floc that scavenges arsenic from the water. Analysis by synchrotron X-ray absorption spectroscopy (XAS) showed that the aqueduct precipitate is an amorphous hydrous ferric oxide (HFO) similar to ferrihydrite, and that arsenic is associated with the floc as adsorbed and/or coprecipitated As(V). Arsenic-rich floc and sediments are deposited along the inlet channel as aqueduct waters enter the reservoir. Sediment core samples were collected in two consecutive years from the edge of the reservoir along the inlet channel using 30- or 90-cm push cores. Cores were analyzed for total and extractable arsenic and iron concentrations. Arsenic and iron speciation and mineralogy in sediments were examined at selected depths by synchrotron XAS and X-ray diffraction (XRD). Sediment-porewater measurements were made adjacent to the core sample sites using polyacrylamide gel probe samplers. Results showed that sediment As(V) is reduced to As(III) in all cores at or near the sediment-water interface (0--4 cm), and only As(III) was observed in deeper sediments. Analyses of EXAFS spectra indicated that arsenic is present in the sediments mostly as a bidentate-binuclear, inner-sphere sorption complex with local atomic geometries similar to those found in laboratory studies. Below about 10 cm depth, XAS indicated that the HFO floc had been reduced to a mixed Fe(II, III) solid with a local structure similar to that of synthetic green rust (GR) but with a slightly contracted average interatomic Fe-Fe distance in the hydroxide layer. There was no evidence from XRD for the formation of a crystalline GR phase. The release of dissolved iron (presumably Fe{sup 2+}) and arsenic to solution, as monitored by in situ gel probes, was variable but, in general, occurred at greater depths than arsenic reduction in the sediments by spectroscopic observations and appears to be near or below the depth at which sediment GR was identified. These data point to reductive dissolution of the sorbent iron phase as the primary mechanism of release of sorbed arsenic to solution.
A new laser-wire has been installed in the extraction line of the ATF at KEK. It aims at demonstrating that laser-wires can be used to measure micrometre scale beam size. In parallel, studies have been made to specify a laser suitable for the ILC laser-wires.
The full scale modeling of power transfer between laser beams crossing in plasmas is presented. A new model was developed, allowing calculations of the propagation and coupling of pairs of laser beams with their associated plasma wave in three dimensions. The complete set of laser beam smoothing techniques used in ignition experiments is modeled and their effects on crossed-beam energy transfer are investigated. A shift in wavelength between the beams can move the instability in or out of resonance and hence allows tuning of the energy transfer. The effects of energy transfer on the effective beam pointing and on symmetry have been investigated. Several ignition designs have been analyzed and compared, indicating that a wavelength shift of up to 2 A between cones of beams should be sufficient to control energy transfer in ignition experiments.
Recent experiments on the National Ignition Facility (NIF) have demonstrated the facility's power balance capability. Power balance is a measure of the temporal uniformity among multiple beams or beam groups in a multi-beamline laser. Users of the NIF facility will need precise control of the laser for a wide range of experiments. For example, in indirect drive Inertial Confinement Fusion (ICF) experiments, the NIF laser beams will be delivered onto the interior surface of a hohlraum, generating x-rays. In order for the x-rays emitted to be sufficiently uniform to symmetrically compress the spherical ignition capsule at the center of the hohlraum, each beamline needs to precisely deliver the requested temporal power profile to its intended target. The achieved power balance precision is determined by both the accuracy of the pulse shaping hardware and the repeatability of the energetics of the laser. The precision that is required for ICF targets is a function of time and power level during the pulse. We have developed a model that predicts the time-dependent power balance performance of an arbitrary pulse shape. In this model, performance is determined by a handful of dominant terms, whose magnitude we have characterized. The model and the power balance requirements for the current National Ignition Campaign (NIC) as well as the most recent demonstrated performance on 96-beam and full 192-beam NIF shots will be discussed.
Radiative hydrodynamics simulations of ignition experiments show that energy transfer between crossing laser beams allows tuning of the implosion symmetry. A new full-scale, three-dimensional quantitative model has been developed for crossed-beam energy transfer, allowing calculations of the propagation and coupling of multiple laser beams and their associated plasma waves in ignition hohlraums. This model has been implemented in a radiative-hydrodynamics code, demonstrating control of the implosion symmetry by a wavelength separation between cones of laser beams.
Abstract not provided
The full scale modeling of power transfer between laser beams crossing in plasmas is presented. A new model was developed, allowing calculation of the propagation and coupling of pairs of laser beams with their associated plasma wave in three dimensions. The full laser beam smoothing techniques used in ignition experiments are modeled, and their effects on crossed-beam energy transfer is investigated. A shift in wavelength between the beams can move the instability off resonance and reduce the transfer, hence preserving the symmetry of the capsule implosion.
Radiative hydrodynamics simulations of ignition experiments show that energy transfer between crossing laser beams allows tuning of the implosion symmetry. A new full-scale, three dimensional quantitative model has been developed for crossed-beam energy transfer, allowing calculations of the propagation and coupling of multiple laser beams and their associated plasma waves in ignition hohlraums. This model has been implemented in a radiative-hydrodynamics code, demonstrating control of the implosion symmetry by a wavelength separation between cones of laser beams.
Hohlraum energetics and implosion-symmetry experiments were conducted on the OMEGA Laser System using laser beams arranged in three cones and smoothed with elliptical phase plates. The peak radiation temperature (Tr) increased by 17 eV, with phase plates for gas-filled halfraums irradiated with 20 beams using a ~7-kJ shaped laser pulse (PS26), corresponding to a 44% increase in the peak x-ray flux. The improved coupling correlates with reduced, cone-dependent losses from stimulated Raman scattering (SRS) and stimulated Brillouin scattering (SBS). Phase plates reduce SRS and SBS by controlling the on-target laser-intensity envelope and the speckle modal power spectrum. An implosion symmetry scan was performed by varying the length and beam pointing of vacuum and gas-filled, thin-walled (3 um) Au hohlraums irradiated with 40 beams using a ~14-kJ PS26. Gated-x-ray (hv > 3 keV) images taken along radial and axial views of the self-emission from Ar-doped, D2-filled, plastic-shell implosions quantified the indirect-drive-implosion symmetry. A shift in symmetry was observed between vacuum and gas-filled hohlraums having identical beam pointing. The ratio of x-ray drive at the poles of the capsule relative to the waist increased for the gas-filled hohlraum. Levels of hard-x-ray production (hv > 20 keV) and SRS were reduced with trace amounts of high-Z dopants (i.e., Ne, Kr) in the hohlraum plasma, while the peak Tr increased ~5 eV.