Engineering topics
Publications and source records attributed to Dobson, M. C..
An International workshop was held to address how remote sensing technology could be used to support the environmental monitoring requirements of the Kyoto Protocol. An overview of the issues addressed and the findings of the workshop are discussed.
Nimbus 7 Scanning Multichannel Microwave Radiometer (SMMR) data are used to map daily freeze/thaw patterns in the upper Midwest for the Fall of 1984. The combination of a low 37 GHz radiobrightness and a negative 10.7, 18, and 37 GHz spectral gradient, Partial Derivative of Tb with Respect to f, appears to be an effective discriminant for classifying soil as frozen or thawed. The 37 GHz emissivity is less sensitive to soil moisture than are the lower frequency emissivities so that the 37 GHz radiobrightness appears to track soil surface temperature relatively well. The negative gradient for frozen ground is a consequence of volume scatter darkening at shorter microwave wavelengths. This shorter wavelength darkening is not seen in thawed moist soils.
A combination of several measurement techniques was used to investigate the dielectric properties of 80 rock samples in the microwave region. The real part of the dielectric constant, epsilon', was measured in 0.1 GHz steps from 0.5 to 18 GHz, and the imaginary part, epsilon'', was measured at five frequencies extending between 1.6 and 16 GHz. In addition to the dielectric measurements, the bulk density was measured for all the samples and the bulk chemical composition was determined for 56 of the samples. The study shows that epsilon' is frequency-dependent over the 0.5 to 18 GHz range for all rock samples, and that the bulk density rho accounts for about 50 percent of the observed variance of epsilon'. For individual rock types (by genesis), about 90 percent of the observed variance may be explained by the combination of density and the fractional contents of SiO2, Fe2O3, MgO, and TiO2. For the loss factor epsilon'', it was not possible to establish statistically significant relationships between it and the measured properties of the rock samples (density and chemical composition).
An overview of a radiative transfer model; a model computation example; and the application of the model to determine soil moisture are presented.
This paper describes procedures for characterizing agricultural crops and soils in remote sensing studies. The procedures are based on the accumulated experience of a number of researchers active in this field. Therefore, they represent a compromise between the theoretically desirable and the practically feasible, and should thus be an effective aid in further studies of this type. Although the guidelines were prepared specifically for microwave studies, adjustments were made to render the procedures applicable to optical studies as well. Given the increasing number of research teams involved in remote sensing applied to agriculture, there is an opportunity to acquire a broad data base on soils and crops in various geographic regions. To allow intercomparisons of such data, they must be obtained in a consistent manner. By following the proposed procedures and reporting results using the parameters described here, such intercomparisons should be possible on a continental or a global scale.
A simple, compact, indoor measurement system has been developed to study the radar backscattering properties of a variety of simulated geological surfaces and volumes. The media include a homogeneous layer of fine sand observed for various levels of surface roughness, a sand layer covered with a layer of rocks, and a layer of rocks sandwiched between layers of sand. Four different sizes of rocks were investigated varying from about 1 cm in size to 6 cm in size. The results provide information on the penetration depth of sand, the relative importance of the coherent and incoherent backscattering components, and the magnitude of volume scattering by a layer of rocks relative to surface scattering by a random surface.
Data collected by the Shuttle Imaging Radar-B (SIR-B) on two ascending orbits over a site in west-central Illinois were used to establish end-to-end transfer functions for conversion of the digital numbers on the eight-bit image to values of the radar backscattering coefficient, sigma(0). The transfer function for each data take was defined by the SIR response to an array of six calibrated point targets of known radar cross section and to a large number of area-extended targets, also with a known cross section, as measured by externally calibrated, truck-mounted scatterometers. In spite of variance in the SIR transmit power, end-to-end transfer functions generated from either point targets or area-extended targets were found to yield close agreement for a given pass, indicating that targets of known radar cross section can be used to provide transfer functions for orbital SAR. Although the use of area-extended targets yielded the most satisfactory results, the use of point targets is far simpler and may be the preferred alternative for many situations.
Two predawn ascending data-takes by the Shuttle Imaging Radar-B (SIR-B) were used to evaluate the effects of surface roughness, crop canopy, and soil moisture on radar backscatter. The two images, separated by three days, were both obtained at 30-deg local angle of incidence, but with opposite azimuth viewing directions. The imagery was externally calibrated with respect to the radar backscattering coefficient sigma(0) via response to arrays of point and area-extended targets of known radar cross section. Three land-cover classes: (1) corn, (2) corn stubble and plowed bare soil, and (3) disked bare soil, soybeans, soybean stubble, alfalfa, and clover could be readily separated for either observation date on the basis of image tone alone. The dependence of sigma(0) on the surface roughness and canopy brightness inhibits the capability of SIR to globally estimate the near-surface soil moisture from the value of sigma(0) for single date observations, unless the surface roughness or canopy cover conditions are accounted for. However, within given ranges of these conditions, the sigma(0) was found to be highly correlated with the soil moisture.
Data-takes on two ascending orbits of the Shuttle Imaging Radar-B (SIR-B) over an agricultural test site in west-central Illinois were used to establish end-to-end transfer functions for conversion of the digital numbers on the 8-bit image to values of the radar backscattering coefficient sigma sup 0 (sq m/sq. m) in dB. The transfer function for each data-take was defined by the SIR-B response to an array of six calibrated point targets of known radar cross-section (transponders) and to a large number of area-extended targets also with known radar cross-section as measured by externally calibrated, truck-mounted scatterometers. The radar cross-section of each transponder at the SIR-B center frequency was measured on an antenna range as a function of local angle of incidence. Two truck-mounted scatterometers observed 20 to 80 agricultural fields daily at 1.6 GHz with HH polarization and at azimuth viewing angles and incidence angles equivalent to those of the SIR-B. The form of the transfer function is completely defined by the SIR-B receiver and the incoherent averaging procedure incorporated into production of the standard SIR-B image product.
Multipolarized airborne Synthetic Aperture Radar (SAR) data were acquired over a largely agricultural test site near Macomb, Illinois, in conjunction with the Shuttle Imaging Radar (SIR-B) experiment in October 1984. The NASA/JPL L-band SAR operating at 1.225 GHz made a series of daily overflights with azimuth view angles both parallel and orthogonal to those of SIR-B. The SAR data was digitally recorded in the quadpolarization configuration. An extensive set of ground measurements were obtained throughout the test site and include biophysical and soil measurements of approximately 400 agricultural fields. Preliminary evaluation of some of the airborne SAR imagery indicates a great potential for crop discrimination and assessment of canopy condition. False color composites constructed from the combination of three linear polarizations (HH, VV, and HV) were found to be clearly superior to any single polarization for purposes of crop classification. In addition, an image constructed using the HH return to modulate intensity and the phase difference between HH and VV returns to modulate chroma indicates a clear capability for assessment of canopy height and/or biomass. In particular, corn fields heavily damaged by infestations of corn borer are readily distinguished from noninfested fields.
Microwave frequency measurements of moist soil dielectric properties are noted to challenge the validity of percent-of-field-capacity as a moisture indicator that is independent of soil texture in terms of microwave sensitivity. In arriving at this view, gravimetric, volumetric, and percent-of-field-capacity were tested for their ability to reduce dielectric behavior divergence between soil textures at 1.4 and 5.0 GHz. The most congruent dielectric behavior between soil textures is found to occur when soil moisture is expressed on a volumetric basis that is proportional to the number of water dipoles/unit volume. An inadequate characterization of soil bulk density in the field, combined with the dependency of bulk density on water retention at field capacity, offers the most plausible explanation for the earlier conclusions.
Four areas of L-band radar remote sensing of terrain were examined: (1) the behavior of the radar backscatter coefficient of distributed surface and volumes as a function of the targets' dielectric and geometric parameters and as a fnction of their physical parameters; (2) the correspondence of the angular behavior of the relative backscatter coefficient as extracted from SIR-B digital imagery and truck mounted L-band scatterometer measurements for about 100 fields; (3) the statistical behavior of SIR-B image density for targets that appear homogeneous on Thematic Mapper (TM) optical imagery and/or color IR photography; and (4) the applicability of SIR-B imagery both alone and in conjunction with TM imagery for the classification and monitoring of land cover and renewable resources.
Simulated C-band radar imagery for a 124-km by 108-km test site in eastern Kansas is used to classify soil moisture. Simulated radar resolutions are 100 m by 100 m, 1 km by 1km, and 3 km by 3 km. Distributions of actual near-surface soil moisture are established daily for a 23-day accounting period using a water budget model. Within the 23-day period, three orbital radar overpasses are simulated roughly corresponding to generally moist, wet, and dry soil moisture conditions. The radar simulations are performed by a target/sensor interaction model dependent upon a terrain model, land-use classification, and near-surface soil moisture distribution. The accuracy of soil-moisture classification is evaluated for each single-date radar observation and also for multi-date detection of relative soil moisture change. In general, the results for single-date moisture detection show that 70% to 90% of cropland can be correctly classified to within +/- 20% of the true percent of field capacity. For a given radar resolution, the expected classification accuracy is shown to be dependent upon both the general soil moisture condition and also the geographical distribution of land-use and topographic relief. An analysis of cropland, urban, pasture/rangeland, and woodland subregions within the test site indicates that multi-temporal detection of relative soil moisture change is least sensitive to classification error resulting from scene complexity and topographic effects.
The SEASAT-A SAR and SIR-A imagery was examined to evaluate the quality and type of information that can be extracted and used to monitor renewable resources on Earth. Two tasks were carried out: (1) a land cover classification study which utilized two sets of imagery acquired by the SEASAT-A SAR, one set by SIR-A, and one LANDSAT set (4 bands); and (2) a change detection to examine differences between pairs of SEASAT-A SAR images and relates them to hydrologic and/or agronomic variations in the scene.
A vegetation and soil-moisture experiment was conducted in order to examine the microwave emission and backscattering from vegetation canopies and soils. The data-acquisition methodology used in conjunction with the mobile radar scatterometer (MRS) systems is described and associated ground-truth data are documented. Test fields were located in the Kansas River floodplain north of Lawrence, Kansas. Ten fields each of wheat, corn, and soybeans were monitored over the greater part of their growing seasons. The tabulated data summarize measurements made by the sensor systems and represent target characteristics. Target parameters describing the vegetation and soil characteristics include plant moisture, density, height, and growth stage, as well as soil moisture and soil-bulk density. Complete listings of pertinent crop-canopy and soil measurements are given.
The reduction in sensitivity of the microwave brightness temperature to soil moisture content due to vegetation cover is analyzed using airborne observations made at 1.4 and 5 GHz. The data were acquired during six flights in 1978 over a test site near Colby, Kansas. The test site consisted of bare soil, wheat stubble, and fully mature corn fields. The results for corn indicate that the radiometric sensitivity to soil moisture S decreases in magnitude with increasing frequency and with increasing angle of incidence (relative to nadir). The sensitivity reduction factor, defined in terms of the radiometric sensitivities for bare soil and canopy-covered conditions Y = 1 - Scan/Ss was found to be equal to 0.65 for normal incidence at 1.4 GHz, and increases to 0.89 at 5 GHz. These results confirm previous conclusions that the presence of vegetation cover may pose a serious problem for soil moisture detection with passive microwave sensors.
Simulated C-band radar imagery for a 124-km by 108-km test site in eastern Kansas is used to classify soil moisture. Simulated radar resolutions are 100 m by 100 m, 1 km by 1 km, and 3 km by 3 km, and each is processed using more than 23 independent samples. Moisture classification errors are examined as a function of land-cover distribution, field-size distribution, and local topographic relief for the full test site and also for subregions of cropland, urban areas, woodland, and pasture/rangeland. Results show that a radar resolution of 100 m by 100 m yields the most robust classification accuracies.
Supervised maximum-likelihood classifications of Seasat, SIR-A, and Landsat pixel data demonstrated that SIR-A data provided the most accurate discrimination (72 percent) between five land-cover categories. Spatial averaging of the SAR data improved classification accuracy significantly due to a reduction in both fading and within-field variability. The best multichannel classification accuracy (97.5 percent) was achieved by combining the SIR-A data with two Seasat images (ascending and descending orbits). In addition, semiquantitative analysis of Seasat-A digital data shows that orbital SAR imagery can be successfully used for multitemporal detection of change related to hydrologic and agronomic conditions by using simple machine processing techniques.