Search NASA⌕ Search

Engineering topics

Doerry, Armin W.

Publications and source records attributed to Doerry, Armin W..

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Notes on Amplitude versus Phase Comparison Monopulse Antennas for Radar

Monopulse is a technique for determining the Direction of Arrival (DOA) of a radar echo by comparing the simultaneous signal responses from two or more antenna beams or apertures. Two principal architectures are employed: 1) amplitude-comparison monopulse, and 2) phase-comparison monopulse. For a constrained-size fully and uniformly illuminated aperture, there is no meaningful difference between the DOA angle precision achievable by an amplitude monopulse architecture versus a phase monopulse architecture. DOA angle estimation precision is almost exclusively a function of antenna size, operating wavelength, and SNR, regardless of amplitude versus phase monopulse architectures.

47 OTHER INSTRUMENTATION↗
DOE OSTI2024

Notes on Linear FM Chirp for Radar

One of the most iconic of radar waveforms is the Linear FM chirp. It is well-behaved and well-understood, and has become the gold standard against which other radar waveforms are measured. It has a number of desirable attributes, but is not without some issues. It may be processed by a number of techniques with many variations. Details of the Linear FM chirp are presented and discussed in this report.

42 ENGINEERING↗
DOE OSTI2023

Performance Limits for Airborne Weather Detection Radar

An aircraft commander needs to be aware of weather phenomena that might be hazardous to his aircraft and mission. An important tool for this is airborne weather (WX) detection radar. The airborne WX radar needs to map weather for the aircraft commander that might be relevant to the safety of the aircraft, which involves both detecting a weather phenomenon, and to some extent seeing through it to detect weather phenomena behind it. Many factors influence the performance of an airborne WX radar

47 OTHER INSTRUMENTATION↗
DOE OSTI2023

Notes on Minimum Area for Radar Antenna

Perhaps no single radar component has a more profound effect on Synthetic Aperture Radar (SAR) performance than the antenna. Especially for spaceborne SAR, one particular common design constraint for the antenna is the minimum antenna area constraint. While useful, it relies on a number of assumptions and approximations that may not always be valid or applicable. Indeed, useful operational systems have been built and flown that do not strictly adhere to this constraint. A closer examination of this constraint yields insights into what the real limitations are, or might be.

42 ENGINEERING↗
DOE OSTI2023

A Study of Pulse-Doppler Radar Pulse Repetition Frequency

Measurements of both long ranges and high velocities pose a contradiction to a pulse-Doppler radar, driving the desired Pulse Repetition Frequency (PRF) in different directions. Often, making one of the measurements unambiguous will make the other ambiguous. The PRF can be adjusted to trade ambiguities in range and velocity, subject to well-defined limits. Various regions of the radar’s operating characteristics in range-velocity space have come to be termed Low-PRF, Medium-PRF, and High-PRF. Selecting a radar operating point, chiefly its PRF, will not only characterize ambiguities that are generated, but also blind ranges and blind velocities. Techniques to mitigate ambiguities and blind regions do exist, allowing substantial extension of the discernable ranges and velocities to the radar.

47 OTHER INSTRUMENTATION↗
DOE OSTI2023

Notes on Regression Analysis for Radar Parameter Estimation

A fundamental task of radar, beyond merely detecting a target, is to estimate some parameters associated with it. For example, this might include range, direction, velocity, etc. In any case, multiple measurements, often noisy, need to be processed to yield a ‘best estimate’ of the parameter. A common mathematical method for doing so is called “Regression” analysis. The goal is to minimize the expected squared error in the estimate. Even when alternate algorithms are considered, the least squared-error regression analysis is the benchmark against which alternatives are compared.

47 OTHER INSTRUMENTATION↗
DOE OSTI2022

Synthetic Aperture Radar Image Geolocation Using Fiducial Images

Synthetic Aperture Radar (SAR) creates imagery of the earth’s surface from airborne or spaceborne radar platforms. However, the nature of any radar is to geolocate its echo data, i.e., SAR images, relative to its own measured radar location. Acceptable accuracy and precision of such geolocation can be quite difficult to achieve, and is limited by any number of parameters. However, databases of geolocated earth imagery do exist, often using other imaging modalities, with Google Earth being one such example. These can often be much more accurate than what might be achievable by the radar itself. Consequently, SAR images may be aligned to some higher accuracy database, thereby improving the geolocation of features in the SAR image. Examples offer anecdotal evidence of the viability of such an approach.

47 OTHER INSTRUMENTATION↗
DOE OSTI2021

Suitability of Altair FEKO's Computational Electromagnetic Techniques for Tree Model Scattering and Penetration at Ku-band

Foliage penetration (FOPEN) radar at lower frequencies (VHF, UHF) is a well-studied area with many contributions. However, there is growing interest in using higher Ku-band frequencies (12-18 GHz) for FOPEN. Specifically, the reduced wavelength sizes provide some key saliencies for developing more optimized detection solutions. The disadvantage is that exploiting Ku-band for FOPEN is complicated because higher frequencies have pronounced scattering effects due to their smaller wavelengths. A methodology h as been developed to model and simulate FOPEN problems that characterize the phenomenology of Ku-band electromagnetic ( EM ) wave transmissions through moderate foliage. The details of this research (i.e. the realistic tree models, simulation setup and results) are documented in multiple reports. The main focus of this report is to describe the preliminary validation and verification of Altair FEKO, the computational EM (CEM) software used for this research, as well as present a simplified symmetrical tree model and an introductory CAD tree model.

42 ENGINEERING↗
DOE OSTI2021

SAR Geolocation Using Range-Doppler Multilateration

Radar is by its basic nature a ranging instrument. If radar range and range-rate measurements from multiple directions can be made and assembled, then multilateration allows locating a feature common to the set of Synthetic Aperture Radar (SAR) images to an accurate 3-D coordinate. The ability to employ effective multilateration algorithms is highly dependent on the geometry of the data collections, and the accuracy with which relative range measurements can be made. The problem can be cast as a least-squares exercise, and the concept of Dilution of Precision can describe the accuracy and precision with which a 3-D location can be made.

42 ENGINEERING↗
DOE OSTI2021

Impulse Response Results from FOPEN Simulations

Foliage penetration (FOPEN) radar at lower frequencies (VHF, UHF) is a well-studied area with many contributions. However, there is growing interest in using higher Ku-band frequencies (12-18 GHz) for FOPEN. Specifically, the reduced wavelength sizes provide some key saliencies for developing more optimized detection solutions. The disadvantage is that exploiting Ku-band for FOPEN is complicated because higher frequencies have pronounced scattering effects due to their smaller wavelengths. A methodology has been developed to model and simulate FOPEN problems that characterize the phenomenology of Ku-band EM wave transmissions through moderate foliage. The details of this research are documented in multiple reports. The main focus of this report is to describe the FOPEN model simulation scene setup, validation and results.

42 ENGINEERING↗
DOE OSTI2021

SAR Geolocation Using Range-Only Multilateration

Radar is by its basic nature a ranging instrument. If radar range measurements from multiple directions can be made and assembled, then multilateration allows locating a feature common to the set of Synthetic Aperture Radar (SAR) images to an accurate 3-D coordinate. The ability to employ effective multilateration algorithms is highly dependent on the geometry of the data collections, and the accuracy with which relative range measurements can be made. The problem can be cast as a least-squares exercise, and the concept of Dilution of Precision can describe the accuracy and precision with which a 3-D location can be made.

47 OTHER INSTRUMENTATION↗
DOE OSTI2021

Synthetic Aperture Radar Height of Focus

Synthetic Aperture Radar (SAR) projects a 3-D scene’s reflectivity into a 2-D image. In doing so, it generally focusses the image to a surface, usually a ground plane. Consequently, scatterers above or below the focal/ground plane typically exhibit some degree of distortion manifesting as a geometric distortion and misfocusing or smearing. Limits to acceptable misfocusing define a Height of Focus (HOF), analogous to Depth of Field in optical systems. This may be exacerbated by the radar’s flightpath during the synthetic aperture data collection. It might also be exploited for target height estimation and offer insight to other height estimation techniques.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2020

Modeling Tree Foliage for Microwave Radar Transparency Study

The motivation for this report is to discuss and present some realistic tree models employed in computational electromagnetics (EM) simulations to study foliage penetration (FOPEN) at Ku-band. The detail obtained in these trees is unprecedented in FOPEN modeling since many studies in this area focus on lower frequencies where precise tree parameters are not required due to the associated large wavelengths relative to the tree dimensions. The focus of this study is in the Ku-band range where the wavelength is notably smaller and the details of the trees have more of an influence on EM waves (i.e. scattering, attenuating, reflecting, diffracting etc.). Therefore, explicit tree parameters are modeled. Also, moderate foliage is of most interest because with less dense foliage t here is a higher percentage of Ku-band transmission. The EM wave and foliage interaction s are simulated with the computational electromagnetics (CEM) Altair FEKO software. The realistic tree model s implemented for simulations are created in the computer-aided design (CAD) software Arbaro and the module CADFEKO that is offered in FEKO. Details of these tree models are provided, and EM simulation results will be discussed in a follow-on report

59 BASIC BIOLOGICAL SCIENCES↗
DOE OSTI2020

Stripmap SAR Data Collection Geometry on a Round Earth

A stripmap Synthetic Aperture Radar (SAR) image is a long SAR image along some centerline, and formed from multiple synthetic apertures. At issue is that the centerline in the image actually corresponds to an arc on a round earth, and multiple strategies exist for fitting the image centerline to the round earth. Some of those strategies involve Rhumb lines, great circle paths, and great ellipse paths. Some are better than others in polar regions. Notions of parallel flight paths for the radar during data collection also require careful consideration of the geometry of a round earth.

47 OTHER INSTRUMENTATION↗