Search NASA⌕ Search

Engineering topics

Dominguez, J.

Publications and source records attributed to Dominguez, J..

Bottom-Up Copper Filling of Large Scale Through Silicon Vias for MEMS Technology

An electrodeposition process for void-free bottom-up filling of sub-millimeter scale through silicon vias (TSVs) with Cu is detailed. The 600 μm deep and nominally 125 μm diameter metallized vias were filled with Cu in less than 7 hours under potentiostatic control. The electrolyte is made up of 1.25 mol/L CuSO 4 – 0.25 mol/L CH 3 SO 3 H with polyether and halide additions that selectively suppress metal deposition on the free surface and side walls. A brief qualitative discussion of the procedures used to identify and optimize the bottom-up void-free feature filling is presented.

42 ENGINEERING↗

Fabrication of quantum dots in undoped Si/Si{sub 0.8}Ge{sub 0.2} heterostructures using a single metal-gate layer

Enhancement-mode Si/SiGe electron quantum dots have been pursued extensively by many groups for their potential in quantum computing. Most of the reported dot designs utilize multiple metal-gate layers and use Si/SiGe heterostructures with Ge concentration close to 30%. Here, we report the fabrication and low-temperature characterization of quantum dots in the Si/Si{sub 0.8}Ge{sub 0.2} heterostructures using only one metal-gate layer. We find that the threshold voltage of a channel narrower than 1 μm increases as the width decreases. The higher threshold can be attributed to the combination of quantum confinement and disorder. We also find that the lower Ge ratio used here leads to a narrower operational gate bias range. The higher threshold combined with the limited gate bias range constrains the device design of lithographic quantum dots. We incorporate such considerations in our device design and demonstrate a quantum dot that can be tuned from a single dot to a double dot. The device uses only a single metal-gate layer, greatly simplifying device design and fabrication.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Probing the limits of Si:P δ -doped devices patterned by a scanning tunneling microscope in a field-emission mode

Recently, a single atom transistor was deterministically fabricated using phosphorus in Si by H-desorption lithography with a scanning tunneling microscope (STM). This milestone in precision, achieved by operating the STM in the conventional tunneling mode, typically utilizes slow (∼102 nm2/s) patterning speeds. By contrast, using the STM in a high-voltage (>10 V) field-emission mode, patterning speeds can be increased by orders of magnitude to ≳104 nm2/s. We show that the rapid patterning negligibly affects the functionality of relatively large micron-sized features, which act as contacting pads for these devices. For nanoscale structures, we show that the resulting electrical transport is consistent with the donor incorporation chemistry constraining the electrical dimensions to a scale of 10 nm even though the pattering spot size is 40 nm.

Rudolph, M.↗

Efficient probabilistic fracture mechanics analysis

A systematic and efficient method for probabilistic fracture mechanics analysis is proposed. The method is based on a most-probable-point-locus concept. The locus is obtained iteratively where the initial locus is determined using the linear approximation of the service life N(X) function about the mean values of the random variables X. Linear and quadratic approximations of N(X) are established locally at the most probable points, and the reliability analysis methods are used to compute the cumulative probabilities. By using two examples, the proposed method is demonstrated to be efficient and accurate. One example involved a random loading and N(X) was computed using cycle-by-cycle integration. The method is general and can be applied to other performance functions. It is particularly suitable when the computation of the performance function is time consuming such that Monte Carlo simulation is prohibitively costly.

Wu, Y.-T.↗