Search NASA⌕ Search

Engineering topics

Donitz, Benjamin

Publications and source records attributed to Donitz, Benjamin.

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2021

Thermal Analysis of Landers using Radioisotope Power Systems on Ice Worlds

The surfaces of Ice Worlds record evidence of interior processes, chemical potential, habitability, and potentially life within the interior. Volatile and organic chemistry at the surface is critical in determining habitability and detecting the presence of past or extant life. Radioisotope Power Systems (RPS) could be an enabling technology for in situ missions to ice worlds, providing both power and heat for long durations where solar power would not be feasible. However, it is necessary to understand the potential impact of RPS upon the local environment, to ensure that the rejected heat from RPS does not compromise science measurements or planetary protection requirements. To address these concerns, an RPS Ice World Lander Study was carried out in 2019 to investigate possible requirements on RPS surface mission concepts and approaches to excess heat management. The study focused on two destinations that are representative of the range of potential environments: Europa and Enceladus.Initial analysis showed that, due to the very low pressures on the surfaces of most ice world targets, surface melting does not occur because the water ice does not meet the triple-point. A 4 kW heat source suspended above the surface of Europa or Enceladus would not cause any melting, only sublimation.The study used a surface sublimation limit of 10 cm over a two-year period (the baseline for the recent Europa Lander study). To stay within this limit, Europa, with its relatively warm surface, could tolerate only 10 W/m2 of surface heat flux. Enceladus, with its relatively cold pure ice composition, could tolerate up to 100 W/m2.Various lander and heat shield configurations were analyzed for their heat flux radiated from the RPS to the surface. For a given heat shield configuration, the study team determined the minimum height of the RPS above the surface for which the heat flux would be within the accepted parameters for Europa and for Enceladus. Based on these thermal analyses, such RPS-powered landers could remain compliant with science investigation and planetary protection requirements with only modest mass allocated to spacecraft thermal accommodations.

Perl, Scott↗
NASA NTRS2020

Icy and Ocean World Exploration Enabled by Radioisotope Power Systems

As the interest in exploring icy and ocean worlds gains increasing traction among scientists and mission communities, there are many potential icy and ocean world targets for in-situ lander missions. Potential targets include Europa, Enceladus, Titan, Triton, Ceres, Pluto, and more, which will allow the scientific community to address icy and ocean world related questions for understanding the distribution of life in the Solar System. Beyond Jupiter, solar power is infeasible for any landed missions and primary batteries are infeasible for long-duration missions. Radioisotope Power Systems (RPS) can be enabling for these long-duration in-situ missions. However, the interaction of RPS waste heat with icy world surfaces must be understood to assure the science and mission communities that RPS are a safe, enabling option to explore the surface of icy bodies. This paper describes a study for the RPS Program that was conducted by the RPS Mission Analysis Team and JPL’s Team X to investigate the system-level impact of a heat rejection system that would be required for RPS-enabled exploration of icy and ocean worlds.

Lee, Young H↗
NASA NTRS2019

Solar Power System and Radioisotope Thermoelectric Generation Technologies at Jupiter-Saturn-Uranus Environments: New Insights and Paradigms

Power system selection for outer planet destinations, such as Jupiter, Saturn, and Uranus and beyond, is complex, involving and dependent on many interdisciplinary factors such as power system mass, specific power, cost, mechanical and electrical integration, and natural radiation environment. Low solar irradiance at Jupiter, Saturn, and Uranus systems (i.e., 50, 15, and 4 W/m2 , respectively) makes solar power systems challenging in mechanical / electrical integration and accommodating radiation environments. More costly radioisotope thermoelectric generator (RTG) systems can help proposed missions overcome radiation environment and spacecraft control challenges at Jupiter, Saturn, and Uranus. NASA’s Jet Propulsion Laboratory (JPL) has recently made significant strides in demonstrating high-efficiency, radiation-hard solar cell technologies for low-irradiance, low-temperature (LILT) applications, and high-efficiency thermoelectric (TE) materials and modules for higher-specific-power RTGs. Stateof-art multi-junction solar cells now routinely demonstrate high efficiencies of 30-34% at LILT (9.5AU and -165°C), making solar arrays a viable option for many near-term Saturn mission concepts. Emerging technologies like LILToptimized solar cells have recently demonstrated even higher efficiencies of 37% at 9.5AU and -165°C and 30% lower mass than the state-of-art, offering the prospect of ~3W/kg array-level, end-of-life specific powers under Saturn conditions. Having already demonstrated the tremendous utility of RTGs on Mars and in deep-space missions (e.g., Galileo at Jupiter, New Horizons at Pluto), NASA is now developing and demonstrating new TE materials and modules (e.g., skutterudites, La3-x Te4, and Zintls) for increasing RTG specific power (up to >8.5 W/kg), which strongly impacts an RTG’s mass, fuel utilization, and modularity in the power system trade domain. New accomplishments in both areas highlight the renewed requisite for updated comparisons and trade-offs in power output, specific power and mass, cost, mechanical and electrical integration, new technology timelines, and natural radiation impacts between new LILT-optimized photovoltaic technologies and next-generation RTG technologies. This work discusses and demonstrates how new LILT-based technologies are now allowing one to consider and design solar power systems for Saturn orbit and beyond, and are changing the potential cost-mass trade-offs between emerging solar power technologies and newly-envisioned RTG technologies. Key updated system mass and cost trade-offs between high-performance LILT solar technologies and new RTG technologies are presented, reinforcing and refining power selection criteria supporting possible future NASA deep-space science and exploration missions to Mars, the Jupiter system (Europa, Ganymede), the Saturn system (Titan, Enceladus), Uranus, and beyond. Key trade-offs in other above-mentioned interdisciplinary factors between these two power technologies are also discussed.

Bairstow, Brian K.↗