Search NASASearch

Engineering topics

Doty, J. P.

Publications and source records attributed to Doty, J. P..

At least 19 records

The AXAF CCD imaging spectrometer

The current status of the instrument design and the status of the CCDs being fabricated for the AXAF CCD Imaging Spectrometer (ACIS) are summarized. The instrument consists of an image recording array of CCDs and a linear arrangement of CCDs to record the spectra formed by the objective grating spectrometer. Both arrays employ CCDs with pixel dimensions which correspond to about 0.5 arcsec samples of the image. The CCDs provide moderate spectral resolution and good detection efficiency over the energy range 0.5 to 10 keV. Spectral resolution of 200 or more is achievable using the objective grating with the grating array. Radiation damage effects are shown to degrade the energy resolution of CCDs. Specially designed CCD pixel architecture is employed together with shielding and low temperature operation to slow the effects of radiation damage.

Garmire, G. P.

Design of low noise, high performance X-ray charge-coupled-device cameras

This paper describes some of the critical details of the MIT X-ray CCD camera design. Special attention is given to those portions of the system that deviate from conventional practice in the design of CCD cameras. Furthermore, an attempt has been made to generalize the design so that both optical and X-ray requirements can be satisfied whenever possible. Currently, noise levels of less than 8 electrons rms are routinely achieved with this design, and even lower levels (less than 5 electrons) should be realizable.

Doty, J. P.

Charge-coupled-device X-ray detector performance model

A model that predicts the performance characteristics of CCD detectors being developed for use in X-ray imaging is presented. The model accounts for the interactions of both X-rays and charged particles with the CCD and simulates the transport and loss of charge in the detector. Predicted performance parameters include detective and net quantum efficiencies, split-event probability, and a parameter characterizing the effective thickness presented by the detector to cosmic-ray protons. The predicted performance of two CCDs of different epitaxial layer thicknesses is compared. The model predicts that in each device incomplete recovery of the charge liberated by a photon of energy between 0.1 and 10 keV is very likely to be accompanied by charge splitting between adjacent pixels. The implications of the model predictions for CCD data processing algorithms are briefly discussed.

Bautz, M. W.

A high-speed, dual-CCD imaging photometer

The SNAPSHOT is a high-speed, dual-CCD imaging photometer, with special capability for occultation observations. It is capable of recording occultation light curves in the presence of bright, nonuniform background illumination, such as occultations of stars by Saturn's rings or by comets. Such events are difficult or impossible to observe with conventional photometers. The fundamental idea that makes high time-resolution observations possible is to reduce the data rate by digitizing only those pixels in subframes containing the objects of interest.

Dunham, E. W.

The HEAO 1 A-4 catalog of high-energy X-ray sources

Results are reported from an all-sky survey carried out at high X-ray energies (13-180 keV) from August 1977 until January 1979 using data obtained with the UCSD/MIT Hard X-Ray and Low-Energy Gamma-Ray Instrument on the HEAO 1 satellite. Visual displays are presented which indicate qualitatively the location, intensities, and time variability of the detected high-energy X-ray sources. A model-dependent procedure for the quantitative analysis of the sky survey data is described. The results of this procedure are presented in tabular form and include fitted count rates in four broad energy bands for about 70 sources. All sources which were detected at a level of statistical significance of not less than about 6 sigma were clearly evident in the visual displays of sky survey data. The survey is therefore complete, except in regions of source confusion, down to an intensity level of about 1/75 of the Crab Nebula in the 13-80 keV band. Forty-four sources were detected in the 40-80 keV energy band, and 14 were detected in the 80-180 keV band. Although most of the detected sources are galactic, seven are extragalactic.

Levine, A. M.

The explosive transient camera (ETC) - An instrument for identification of gamma ray burst optical counterparts

The ETC is a wide-field (3-steradian) electronic camera array which can detect coincident optical flashes with durations of 0.1 to 100 sec. Each array element is a 20 x 30 deg FOV, cooled CCD detector. An optical transient (possibly associated with a gamma ray burst) as faint as B = +11 (1 sec duration) can be detected with an S/N of not less than 20, and its position determined to an accuracy of + or - 10 arcsec. Candidate events 1000 times fainter than the archived event (plate taken in 1928) reported for the November 19, 1978 gamma ray burst by Schaefer (1981) should be detectable in real time. A prototype camera was tested in April 1982 to establish sky background levels and spurious event rejection schemes; a 1/2-ster test version of the ETC was planned for operation in early 1984; expansion to the full 3-ster complement of 16 detectors at each of two sites was planned for the 1984-1985 period.

Ricker, G. R.

Rapid variability of 10-140 keV X-rays from Cygnus X-1

On five occasions in 1977 and 1978, Cygnus X-1 was observed using the low-energy detectors of the UCSD/MIT Hard X-ray and Low-Energy Gamma Ray experiment on the HEAO 1 satellite. Rapid (times between 0.08 and 1000 sec) variability was found in the 10-140 keV band. The power spectrum was white for frequencies between 0.001 and 0.05 Hz and was proportional to the inverse of the frequency for frequencies between 0.05 and 3 Hz, indicating correlations on all time scales less than approximately 20 s. The shape of the energy spectrum was correlated with intensity; it was harder at higher intensity. If the emission is produced by Comptonization of a soft photon flux in a hot cloud, the heating of the cloud cannot be constant; it must vary on time scales up to approximately 20 s. A variable accretion rate could cause the observed effects.

Nolan, P. L.

SAS 3 observations of GX 1 + 4

GX 1 + 4 is one of the brightest celestial sources of high-energy X-rays. It is a pulsar with a period of approximately 2 min (perhaps a multiple of 2 min), decreasing at a variable rate which, since 1971, has averaged approximately 2% per year, but which can be larger than 5% per year. This is the largest rate of decrease observed for any pulsar. The rate of decrease appears to be correlated with the luminosity, in support of the idea that the period decrease is produced by accretion torques acting upon a neutron star. No evidence is seen for a Doppler shift due to motion of the pulsar in a binary orbit; this is consistent with the results of optical observations which suggest that any orbital period is fairly long (months to years). The spectrum of GX 1 + 4 is measured as a function of pulse phase, as well as the phase-averaged total spectrum, and the average spectrum of the pulses alone. The shape of the average pulsed spectrum suggests that the pulsations may be produced by 'hot spots' which are a few hundred meters in extent, with temperatures of approximately 10 to the 8th K (kT being approximately equal to 8 keV).

Doty, J. P.

An absorption feature in the spectrum of the pulsed hard X-ray flux from 4U0115 + 63

A spectral feature, apparently an absorption line, has been observed at an energy of 20.1 + or - 0.5 keV in the pulsed flux of the 3.61-s X-ray pulsar 4U 0115+63 by using the UCSD/MIT instrument on HEAO 1. The line strength, expressed as equivalent width, is 3.1 + or - 0.5 keV. Although essentially unresolved, the feature has a depth more than 60% of the continuum flux. If the feature arises by cyclotron resonance absorption near the magnetic poles of the neutron star, it implies a magnetic field of between approximately 1.8 and 2.5 x 10 to the 12th G, depending on the gravitational redshift (no more than about 5-40%).

Wheaton, W. A.

Transient structure in the high-energy X-ray light curve of NP 0532

The paper reports the observation of pulsed fractions in the primary and secondary peaks, as well as in the interpulse region, of the high-energy X-ray light curve of NP 0532. A statistical analysis of light-curve data is performed, and a similar analysis is carried out using simulated data. It is concluded that a previously reported third peak in the light curve was transient in nature.

Ryckman, S. G.

Polishing gold and gold-alloy crystals

Sawed cross-section samples are rough polished at minimum pressure with 14 micron grit. After saw marks are polished away, polishing grit is changed to 0.05 micron. When smooth appearance is attained, surface is then chemically polished by hand in dust free room.

Doty, J. P.

Convection sensitivity and thermal analyses for indium and indium-lead mixing experiment (74-18)

Sounding rocket Experiment 74-18 was designed to demonstrate the effects of the Black Brandt rocket acceleration levels (during the low-g coast phase of its flight) on the motion of a liquid metal system to assist in preflight design. Some post flight analyses were also conducted. Preflight studies consisted of heat transfer analysis and convection sensitivity and convection modeling analyses which aided in the: (1) final selection of fluid materials (indium-lead melts rather than paraffins); (2) design and timing of heater and quench system; and (3) preflight predictions of the degree of lead penetration into the pure indium segment of the fluid. Postflight studies involved: (1) updating the convection sensitivity calculations by utilizing actual flight gravity levels; and (2) modeling the mixing in the flight samples.

Bourgeois, S. V.

The Perseus and Coma clusters of galaxies at energies above 20 keV

Observations of the Perseus and Coma clusters of galaxies were made on June 21, 1974, with a balloon-borne X-ray telescope (energies of approximately 20-150 keV). No positive detection was made. The data favor a thermal bremsstrahlung mechanism for the X-ray production in the Perseus cluster of galaxies over the inverse Compton mechanism. In the case of the Coma cluster of galaxies, the data are inconclusive with respect to determining the origin of the X-rays.

Scheepmaker, A.

Observations of Cygnus X-3 from a balloon-borne X-ray telescope

X-ray measurements in the energy range 20-150 keV were made from a balloon-borne telescope on June 1 1975. Three scans, centered at phases 0.45, 0.60, and 0.70, respectively, of the 4.8 hr cycle, were conducted. The observed relative intensity as a function of phase differs significantly from previously reported X-ray measurements.

Ricker, G. R.

Study of single crystals of metal solid solutions

The growth of single crystals of relatively high melting point metals such as silver, copper, gold, and their alloys was investigated. The purpose was to develop background information necessary to support a space flight experiment and to generate ground based data for comparison. The ground based data, when compared to the data from space grown crystals, are intended to identify any effects which zero-gravity might have on the basic process of single crystal growth of these metals. The ultimate purposes of the complete investigation are to: (1) determine specific metals and alloys to be investigated; (2) grow single metal crystals in a terrestrial laboratory; (3) determine crystal characteristics, properties, and growth parameters that will be effected by zero-gravity; (4) evaluate terrestrially grown crystals; (5) grow single metal crystals in a space laboratory such as Skylab; (6) evaluate the space grown crystals; (7) compare for zero-gravity effects of crystal characteristics, properties, and parameters; and (8) make a recommendation as to production of these crystals as a routine space manufacturing proceses.

Doty, J. P.

Study of single crystals of metal solid solutions

The parameters and requirements for growing single crystals of relatively high melting point metals in a zero gravity environment are studied. The crystal growth of metals such as silver, copper, gold, and alloys with a melting point between 900-1100 C is examined.

Doty, J. P.