Engineering topics

Drago, R. J.

Publications and source records attributed to Drago, R. J..

4 records

NASA NTRS1985

Analysis of Spiral Bevel Gearing

Program generalized for automated finite-element-method model generation. Tedious task of finite-element-method (FEM) model preparation greatly reduced by development of preprocessing program for automated model generation. Utility of program, including ability to rapidly evaluate parametric changes, demonstrated for spiral, helical, and spiral bevel gearing. Postprocessing program also developed, aids in review and interpretation of calculated FEM stresses.

Drago, R. J.↗

NASA NTRS1984

Development of large rotorcraft transmissions

The U.S. Army Heavy Lift Helicopter (HLH) represents a large rotorcraft which was developed by an American aerospace company. In the early 1970's with the HLH Advanced Technology Components (ATC) program, the development of large rotorcraft transmission and drive systems was started. Failures in the spiral bevel gearing were experienced in tests because the employed method of analysis had not considered the effect of rim bending. Consequently, new gears with strengthened rims were designed and fabricated. For a more accurate prediction of the load capacity of the gears, an extensive Finite Element Method (FEM) system was developed. The U.S. Army's XCH-62 HLH aft rotor transmission was finally successfully tested at full design torque and speed. A description of the test program is provided, and the analytical program is discussed. The analytical phase includes the development of a preprocessing program which aids in the review of calculated FEM stresses.

Samanich, N. E.↗

NASA NTRS1982

Developments in the design, analysis, and fabrication of advanced technology transmission elements

Over the last decade, the presently reported proprietary development program for the reduction of helicopter drive system weight and cost and the enhancement of reliability and survivability has produced high speed roller bearings, resin-matrix composite rotor shafts and transmission housings, gear/bearing/shaft system integrations, photoelastic investigation methods for gear tooth strength, and the automatic generation of complex FEM models for gear/shaft systems. After describing the design features and performance capabilities of the hardware developed, attention is given to the prospective benefits to be derived from application of these technologies, with emphasis on the relationship between helicopter drive system performance and cost.

Drago, R. J.↗

NASA NTRS1982

On the automatic generation of FEM models for complex gears - A work-in-progress report

A description is presented of the development and use of a preprocessor to create a NASTRAN finite element model of a complex spur, helical, or spiral bevel gear quickly, inexpensively, and accurately. The preprocessor creates a ready to run NASTRAN input deck including the executive, case control, and bulk data sections. It generates nodes and solid elements to model spur, helical, or spiral bevel gear teeth with integral shafting. Either a complete gear shafting model or a symmetric model is created. The fundamental building block of the gear model is the base layer. The base layer is the mesh configuration of one layer of one tooth segment which is in turn duplicated, translated, and rotated to create the completed model of the gear. Once the base layer is created, the construction of the finite element model is straightforward.

Drago, R. J.↗